scispace - formally typeset
Search or ask a question
Author

A. F. Holt

Bio: A. F. Holt is an academic researcher from University of Southampton. The author has contributed to research in topics: Dielectric & Polyethylene. The author has an hindex of 10, co-authored 19 publications receiving 349 citations.

Papers
More filters
Journal ArticleDOI
TL;DR: In this paper, the authors investigated the space charge dynamics in silica-based polyethylene nanocomposites and found that the incorporation of nanosilica into polyylene results in a significant amount of homocharge development near both electrodes.
Abstract: Space charge occurs in a dielectric material when the rate of charge accumulation is different from the rate of removal, which arises due to moving or trapped charges. Inevitably, the local electric field is increased at some point within the material, which then leads to faster degradation and premature failure. The determination of space charge behavior has seen wide implementation in characterizing novel dielectric materials, especially in connection with the newly emerging field of nanocomposites. In this paper, we report on an investigation into space charge dynamics in silica-based polyethylene nanocomposites. The various systems differed with respect to the amount of filler and its surface chemistry; the pulsed electro-acoustic (PEA) technique was used to evaluate the space charge distribution in each. Experimental results indicate that the incorporation of nanosilica into polyethylene results in a significant amount of homocharge development near both electrodes. With appropriate surface treatment of the nanofiller, homocharge formation was successfully suppressed, indicating less severe space charge development in the nanocomposite materials. The mechanisms leading to the observed space charge development and direct current (DC) breakdown properties of the nanocomposites are discussed.

98 citations

Journal ArticleDOI
TL;DR: In this article, the dielectric response of silica-based polyethylene nanocomposites was studied by spectroscopy and the results indicated that nanocom composites absorb significantly more water than unfilled polyethylenes, with the consequence that both permittivity and loss tangent increase with increasing duration of water immersion.
Abstract: The dielectric response of silica-based polyethylene nanocomposites is studied by dielectric spectroscopy. The results indicate that nanocomposites absorb significantly more water than unfilled polyethylene, with the consequence that both permittivity and loss tangent increase with increasing duration of water immersion. However, appropriate surface treatment of nanosilica is found to reduce the water absorption effect and to modify the dielectric response of the nanocomposites compared with those containing untreated nanosilica. While water absorption may not be a technologically desirable characteristic, our results indicate that water molecules can act as effective dielectric probes of interfacial factors.

87 citations

Journal ArticleDOI
TL;DR: In this paper, a series of nanoparticles was prepared by functionalizing a commercial nanosilica with alkylsilanes of varying alkyl tail length, from propyl to octadecyl.
Abstract: A series of nanoparticles was prepared by functionalizing a commercial nanosilica with alkylsilanes of varying alkyl tail length, from propyl to octadecyl. By using a constant molar concentration of silane, the density of alkyl groups attached to each system should be comparable. The effect of chain length on the structure of the resulting nanosilica/polyethylene nanocomposites was examined and comparison with an unfilled reference system revealed that, other than through a weak nucleating effect, the inclusion of the nanosilica does not affect the matrix structure. Since water interacts strongly with applied electric fields, water was used as a dielectric probe in conjunction with dielectric spectroscopy to examine the effect of the nanofiller and its surface chemistry on the system. Sets of samples were prepared through equilibrating under ambient conditions, vacuum drying and water immersion. While the water content of the unfilled polymer was not greatly affected, the water content of the nanocomposites varied over a wide range as a result of water accumulation, in a range of states, at nanoparticle interfaces. The effect of water content on breakdown behavior was also explored and, in the unfilled polymer, the breakdown strength was found to depend little on exposure to water (∼13% reduction). In all the nanocomposites, the increased propensity for these systems to absorb water meant that the breakdown strength was dramatically affected (>66% reduction).

37 citations

Proceedings ArticleDOI
29 Dec 2014
TL;DR: In this article, the effect of moisture content on the dielectric properties of polymer/nano-silica blends was investigated and it was found that the DC breakdown strength, electrical conductivity and complex permittivity were all strongly influenced by absorbed water.
Abstract: The effect of moisture content on the dielectric properties of polymer/nano-silica blends was investigated. It was found that the DC breakdown strength, electrical conductivity and complex permittivity were all strongly influenced by absorbed water. However, a control sample without nano-silica was largely unaffected by changes in moisture content. This has important implications for researchers and cable designers.

29 citations

Journal ArticleDOI
29 Nov 2013
TL;DR: In this article, the authors investigated the absorption current behavior of polyethylene nanocomposites containing 0, 2, 5, 5 and 10 wt% of silica nanofiller, either untreated or treated using trimethoxy(propyl)silane coupling agent.
Abstract: Absorption current is an important characteristic of polymers with regard to their time-domain response to a direct current (DC) poling field. This is because the results of absorption current measurements can be used to gain understanding of the relationship between space charge accumulation and movement. In semicrystalline polyethylene, for example, charge accumulation is likely to be influenced by the presence of charge trapping sites, which are associated with interfaces between the crystalline and amorphous phases. With the addition of a nanofiller, the charge transport mechanism will become more complicated than in the unfilled polymer, as the inclusion of the nanofiller will introduce nanofiller/polymer interfaces. The presence of such interfaces will affect the current flow due to the introduction or modification of the distribution of trapping sites within the system. In this paper, we report on an investigation into the absorption current behaviour of polyethylene nanocomposites containing 0 wt%, 2 wt%, 5 wt% and 10 wt% of silica nanofiller, either untreated or treated using trimethoxy(propyl)silane coupling agent. Our results indicate that the absorption current behaviour of the polyethylene was affected by the presence of the nanosilica. While the current behaviour through the unfilled polymer decreases with time in a conventional manner, all nanocomposites reveal an initial decrease followed by a period in which the current increases with increasing time of DC field application.

24 citations


Cited by
More filters
Journal ArticleDOI

[...]

08 Dec 2001-BMJ
TL;DR: There is, I think, something ethereal about i —the square root of minus one, which seems an odd beast at that time—an intruder hovering on the edge of reality.
Abstract: There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality. Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

33,785 citations

Journal ArticleDOI
01 Apr 1988-Nature
TL;DR: In this paper, a sedimentological core and petrographic characterisation of samples from eleven boreholes from the Lower Carboniferous of Bowland Basin (Northwest England) is presented.
Abstract: Deposits of clastic carbonate-dominated (calciclastic) sedimentary slope systems in the rock record have been identified mostly as linearly-consistent carbonate apron deposits, even though most ancient clastic carbonate slope deposits fit the submarine fan systems better. Calciclastic submarine fans are consequently rarely described and are poorly understood. Subsequently, very little is known especially in mud-dominated calciclastic submarine fan systems. Presented in this study are a sedimentological core and petrographic characterisation of samples from eleven boreholes from the Lower Carboniferous of Bowland Basin (Northwest England) that reveals a >250 m thick calciturbidite complex deposited in a calciclastic submarine fan setting. Seven facies are recognised from core and thin section characterisation and are grouped into three carbonate turbidite sequences. They include: 1) Calciturbidites, comprising mostly of highto low-density, wavy-laminated bioclast-rich facies; 2) low-density densite mudstones which are characterised by planar laminated and unlaminated muddominated facies; and 3) Calcidebrites which are muddy or hyper-concentrated debrisflow deposits occurring as poorly-sorted, chaotic, mud-supported floatstones. These

9,929 citations

Journal ArticleDOI
28 Apr 2016-Polymers
TL;DR: The use of polymer micro/nanocomposites in electrical engineering is very promising and further research work must be accomplished in order to diversify the polymer composites matrices and to improve their properties.
Abstract: The present review article represents a comprehensive study on polymer micro/nanocomposites that are used in high-voltage applications. Particular focus is on the structure-property relationship of composite materials used in power engineering, by exploiting fundamental theory as well as numerical/analytical models and the influence of material design on electrical, mechanical and thermal properties. In addition to describing the scientific development of micro/nanocomposites electrical features desired in power engineering, the study is mainly focused on the electrical properties of insulating materials, particularly cross-linked polyethylene (XLPE) and epoxy resins, unfilled and filled with different types of filler. Polymer micro/nanocomposites based on XLPE and epoxy resins are usually used as insulating systems for high-voltage applications, such as: cables, generators, motors, cast resin dry-type transformers, etc. Furthermore, this paper includes ample discussions regarding the advantages and disadvantages resulting in the electrical, mechanical and thermal properties by the addition of micro- and nanofillers into the base polymer. The study goals are to determine the impact of filler size, type and distribution of the particles into the polymer matrix on the electrical, mechanical and thermal properties of the polymer micro/nanocomposites compared to the neat polymer and traditionally materials used as insulation systems in high-voltage engineering. Properties such as electrical conductivity, relative permittivity, dielectric losses, partial discharges, erosion resistance, space charge behavior, electric breakdown, tracking and electrical tree resistance, thermal conductivity, tensile strength and modulus, elongation at break of micro- and nanocomposites based on epoxy resin and XLPE are analyzed. Finally, it was concluded that the use of polymer micro/nanocomposites in electrical engineering is very promising and further research work must be accomplished in order to diversify the polymer composites matrices and to improve their properties.

263 citations

Journal ArticleDOI
TL;DR: It is pointed out here that larger microscopic hierarchical metal-oxide particles with high surface porosity also impart good insulation properties, and suggested mechanisms for improved insulation using nanoparticles, such as increased charge trap density, adsorption of impurities/ions, and induced particle dipole moments are considered.
Abstract: Recent progress in the development of polyethylene/metal-oxide nanocomposites for extruded high-voltage direct-current (HVDC) cables with ultrahigh electric insulation properties is presented. This is a promising technology with the potential of raising the upper voltage limit in today's underground/submarine cables, based on pristine polyethylene, to levels where the loss of energy during electric power transmission becomes low enough to ensure intercontinental electric power transmission. The development of HVDC insulating materials together with the impact of the interface between the particles and the polymer on the nanocomposites electric properties are shown. Important parameters from the atomic to the microlevel, such as interfacial chemistry, interfacial area, and degree of particle dispersion/aggregation, are discussed. This work is placed in perspective with important work by others, and suggested mechanisms for improved insulation using nanoparticles, such as increased charge trap density, adsorption of impurities/ions, and induced particle dipole moments are considered. The effects of the nanoparticles and of their interfacial structures on the mechanical properties and the implications of cavitation on the electric properties are also discussed. Although the main interest in improving the properties of insulating polymers has been on the use of nanoparticles, leading to nanodielectrics, it is pointed out here that larger microscopic hierarchical metal-oxide particles with high surface porosity also impart good insulation properties. The impact of the type of particle and its inherent properties (purity and conductivity) on the nanocomposite dielectric and insulating properties are also discussed based on data obtained by a newly developed technique to directly observe the charge distribution on a nanometer scale in the nanocomposite.

148 citations