scispace - formally typeset
Search or ask a question
Author

A. Thakker

Bio: A. Thakker is an academic researcher from University of Limerick. The author has contributed to research in topics: Pressure drop & Airflow. The author has an hindex of 1, co-authored 1 publications receiving 73 citations.

Papers
More filters
Journal ArticleDOI
TL;DR: In this article, an experimental investigation of the aerodynamic performance of a high-solidity Wells turbine for a wave power plant is presented, and the results show that the presence of guide vanes can provide a remarkable increase in turbine efficiency.
Abstract: The paper describes an experimental investigation, and presents the results of the aerodynamic performance of a high-solidity Wells turbine for a wave power plant. A monoplane turbine of 0.6 m rotor diameter with guide vanes was built and tested. The tests were conducted in unidirectional steady airflow. Measurements taken include flow rate, pressure drop, torque, and rotational speed, as well as velocity and pressure distributions. Experimental results show that the presence of guide vanes can provide a remarkable increase in turbine efficiency.

84 citations


Cited by
More filters
Journal ArticleDOI
TL;DR: In this paper, a theoretical model is developed to simulate the energy conversion from wave to turbine shaft of an oscillating-water-column (OWC) plant equipped with a Wells air-turbine and with a valve (in series or in parallel with the turbine) for air-flow control.

258 citations

Journal ArticleDOI
TL;DR: In this article, the state of the art in self-rectifying impulse air turbines is reviewed and the optimum parameters for the fixed-guide-vane impulse turbine are also presented.

206 citations

Journal ArticleDOI
TL;DR: In this paper, different types of wave energy converters are classified by their mechanical structure and how they absorb energy from ocean waves, and a review of strategies for electrical control of wave EH converters as well as energy storage techniques are presented.
Abstract: Renewable energy techniques are now gaining more and more attention as the years pass by, not only because of the threat of climate change but also, e.g. due to serious pollution problems in some countries and because the renewable energy technologies have matured and can be depended upon an increasing degree. The energy from ocean waves bares tremendous potential as a source of renewable energy, and the related technologies have continually been improved during the last decades. In this paper, different types of wave energy converters are classified by their mechanical structure and how they absorb energy from ocean waves. The paper presents a review of strategies for electrical control of wave energy converters as well as energy storage techniques. Strategies of electrical control are used to achieve a higher energy absorption, and they are also of interest because of the large variety among different strategies. Furthermore, the control strategies strongly affect the complexity of both the mechanical and the electrical system, thus not only impacting energy absorption but also robustness, survivability, maintenance requirements and thus in the end the cost of electricity from ocean waves.

155 citations

Journal ArticleDOI
01 Mar 1997
TL;DR: Several types of single-plane and multiplane Wells turbines are investigated and compared in this paper, where the turbines' aerodynamic losses and overall performances are presented and two successful methods of swirl energy recovery are studied in detail.
Abstract: Several types of single-plane and multiplane Wells turbines are investigated and compared. The turbines’ aerodynamic losses and overall performances are presented and two successful methods of swirl energy recovery are studied in detail. Guide vanes were fitted to a monoplane turbine whereas the rotors of a biplane turbine were contra-rotated. A double-shaft biplane turbine was also tested. The contra-rotating turbine had an operational range which was similar to that of the monoplane turbine with guide vanes, achieved a similar peak efficiency, but performed better in the post-stall region and also was found to be able to accommodate a much higher pressure-flow ratio.

154 citations

Journal ArticleDOI
TL;DR: It will be shown how the controllers avoid the stalling behavior and that the average power of the generator fed into the grid is significantly higher in the controlled cases than in the uncontrolled one while providing the desired output power.
Abstract: The control and simulation of the power delivered to the grid are becoming an important topic, particularly when the number of distributed power generation systems increases. In this paper, two different control schemes for an oscillating-water-column Wells-turbine-generator module are simulated, implemented, and compared. In the first method, the control system does appropriately adapt the slip of the induction generator according to the pressure drop entry in order to maximize the generated power, while in the second method, a traditional proportional-integral-derivative-based control is implemented in order to deal with the desired power-reference-tracking problem. It will be shown how the controllers avoid the stalling behavior and that the average power of the generator fed into the grid is significantly higher in the controlled cases than in the uncontrolled one while providing the desired output power.

127 citations