Akira Nakajima

Bio: Akira Nakajima is an academic researcher from University of Tokyo. The author has contributed to research in topics: Contact angle & Materials science. The author has an hindex of 22, co-authored 28 publications receiving 6742 citations.

Effects of the Surface Roughness on Sliding Angles of Water Droplets on Superhydrophobic Surfaces

Abstract: Various superhydrophobic films having different surface roughnesses were prepared, and the relationships between the sliding angle, the contact angle, and the surface structure were investigated. In the highly hydrophobic region, the sliding angles of water droplets decreased with increasing contact angles. Microstructural observation revealed that surface structures that can trap air are important for the preparation of low-sliding-angle surfaces. We have also derived an equation that describes the relationship between sliding angles and contact angles on superhydrophobic surfaces with roughness. The results calculated on the basis of this equation agreed well with the experimental ones. Moreover, we have successfully prepared a transparent superhydrophobic film whose sliding angle is ∼1° for a 7 mg water droplet. On this film, there was almost no resistance to the sliding of water droplets. The film obtained satisfies the requirements of superhydrophobicity, transparency, and a low water sliding angle.

Effects of Surface Structure on the Hydrophobicity and Sliding Behavior of Water Droplets

Abstract: Hydrophobicity and sliding behavior of water droplets were investigated on various hydrophobic pillarlike and groove structures prepared on a silicon wafer by dicing and subsequently coating with fluoroalkylsilane. The dominant hydrophobicity mode was changed from Wenzel's mode to Cassie's mode at a smaller roughness than that expected from the calculation based on the sinusoidal surface by Johnson and Dettre. The effect of water intrusion on the microstructure due to droplet weight was revealed to be an important factor governing the water sliding angle on the surface. In a comparison of the sliding behavior of water droplets over pillarlike and groove structures, it was demonstrated that a proper design of the surface with respect to shape and extent of the three-phase line is more effective than the increase of contact angles merely by decreasing the solid−water contact area.

Photoinduced Surface Wettability Conversion of ZnO and TiO2 Thin Films

Abstract: The photoinduced surface wettability conversion reactions of ZnO and TiO2 thin films were investigated by means of water contact angle measurement and X-ray photoelectron spectroscopy. Before ultraviolet (UV) illumination, ZnO and TiO2 films exhibited water contact angles of ∼109 and ∼54°, respectively. UV illumination turned both surfaces to highly hydrophilic with water contact angles smaller than 10°. Storage in the dark reconverted the highly hydrophilic films to their original states. Reversible surface wettability conversion reactions were achieved by alternate UV illumination and storage in the dark on both the films. The similar behaviors of wettability conversion observed on ZnO and TiO2 surfaces suggest that they follow a similar conversion mechanism. Preferential adsorption of water molecules on the photogenerated surface defective sites is ascribed to the formation of highly hydrophilic ZnO and TiO2 surfaces. Achievement of highly hydrophilic ZnO and TiO2 surfaces by high-temperature annealing...

Recent Studies on Super-Hydrophobic Films

Abstract: Films whose water contact angle is higher than 150° have been the subject of great interest and enthusiastic study in recent years. These films, which are called super-hydrophobic, are fabricated by combining appropriate surface roughness with surfaces of low surface energy. Here we briefly review the fundamental theories on the wettability of a hydrophobic rough solid surface, together with recent works on the processing and properties of super-hydrophobic films. Though the practical application of these films is still limited, the obstacles to application are gradually being surmounted, providing a great opportunity for the development of various industrial products.

Transparent Superhydrophobic Thin Films with Self-Cleaning Properties

Abstract: Transparent superhydrophobic thin films with TiO2 photocatalyst were prepared by utilizing a sublimation material and subsequent coating of a (fluoroalkyl)silane. The transparency of the films decreased with increasing TiO2 concentration, which was attributed to the size difference of the starting materials. The film with only 2 wt % TiO2 maintained higher contact angle than the film without TiO2 after 1800-h outdoor exposure, the accumulation of stain being avoided due to TiO2 photocatalysis. The films prepared in this study are the first ones that satisfy the requirements of transparency, superhydrophobicity, and long lifetime simultaneously.

Understanding TiO2 photocatalysis: mechanisms and materials.

Abstract: Jenny Schneider,*,† Masaya Matsuoka,‡ Masato Takeuchi,‡ Jinlong Zhang, Yu Horiuchi,‡ Masakazu Anpo,‡ and Detlef W. Bahnemann*,† †Institut fur Technische Chemie, Leibniz Universitaẗ Hannover, Callinstrasse 3, D-30167 Hannover, Germany ‡Faculty of Engineering, Osaka Prefecture University, 1 Gakuen-cho, Sakai Osaka 599-8531, Japan Key Lab for Advanced Materials and Institute of Fine Chemicals, East China University of Science and Technology, Shanghai 200237, China

TiO2 Photocatalysis: A Historical Overview and Future Prospects

Abstract: Photocatalysis has recently become a common word and various products using photocatalytic functions have been commercialized. Among many candidates for photocatalysts, TiO2 is almost the only material suitable for industrial use at present and also probably in the future. This is because TiO2 has the most efficient photoactivity, the highest stability and the lowest cost. More significantly, it has been used as a white pigment from ancient times, and thus, its safety to humans and the environment is guaranteed by history. There are two types of photochemical reaction proceeding on a TiO2 surface when irradiated with ultraviolet light. One includes the photo-induced redox reactions of adsorbed substances, and the other is the photo-induced hydrophilic conversion of TiO2 itself. The former type has been known since the early part of the 20th century, but the latter was found only at the end of the century. The combination of these two functions has opened up various novel applications of TiO2, particularly in the field of building materials. Here, we review the progress of the scientific research on TiO2 photocatalysis as well as its industrial applications, and describe future prospects of this field mainly based on the present authors' work.