Author
Aleksandra Drygała
Bio: Aleksandra Drygała is an academic researcher from Silesian University of Technology. The author has contributed to research in topics: Monocrystalline silicon & Silicon. The author has an hindex of 15, co-authored 56 publications receiving 779 citations.
Papers
More filters
••
TL;DR: In this paper, the influence of different organic modifiers on structure and optical properties of Fe 3 O 4 nanoparticles has been studied in detail using X-ray diffraction method, transmission electron microscopy, Fourier transform infrared spectroscopy and UV-visible spectrograms.
123 citations
••
TL;DR: In this article, a new approach to surface texturization of multicrystalline silicon wafers was developed by means of laser surface treatment and a special etching procedure was applied to remove laser-damaged layer.
116 citations
•
71 citations
••
TL;DR: In this paper, a technique for texturization of solar cells made of multicrystalline silicon has been proposed to improve the understanding of the interaction between laser light and workpiece.
64 citations
••
TL;DR: In this article, the possibility of using Al2O3 antireflection coatings deposited by atomic layer deposition ALD has been presented, which can play the role of both antirelection and passivation layer which will simplify the process.
Abstract: The paper presents the possibility of using Al2O3 antireflection coatings deposited by atomic layer deposition ALD. The ALD method is based on alternate pulsing of the precursor gases and vapors onto the substrate surface and then chemisorption or surface reaction of the precursors. The reactor is purged with an inert gas between the precursor pulses. The Al2O3 thin film in structure of the finished solar cells can play the role of both antireflection and passivation layer which will simplify the process. For this research 50×50 mm monocrystalline silicon solar cells with one bus bar have been used. The metallic contacts were prepared by screen printing method and Al2O3 antireflection coating by ALD method. Results and their analysis allow to conclude that the Al2O3 antireflection coating deposited by ALD has a significant impact on the optoelectronic properties of the silicon solar cell. For about 80 nm of Al2O3 the best results were obtained in the wavelength range of 400 to 800 nm reducing the reflection to less than 1%. The difference in the solar cells efficiency between with and without antireflection coating was 5.28%. The LBIC scan measurements may indicate a positive influence of the thin film Al2O3 on the bulk passivation of the silicon.
46 citations
Cited by
More filters
••
TL;DR: In this article, the photovoltaic technology, its power generating capability, the different existing light absorbing materials used, its environmental aspect coupled with a variety of its applications have been discussed.
Abstract: Global environmental concerns and the escalating demand for energy, coupled with steady progress in renewable energy technologies, are opening up new opportunities for utilization of renewable energy resources. Solar energy is the most abundant, inexhaustible and clean of all the renewable energy resources till date. The power from sun intercepted by the earth is about 1.8 × 1011 MW, which is many times larger than the present rate of all the energy consumption. Photovoltaic technology is one of the finest ways to harness the solar power. This paper reviews the photovoltaic technology, its power generating capability, the different existing light absorbing materials used, its environmental aspect coupled with a variety of its applications. The different existing performance and reliability evaluation models, sizing and control, grid connection and distribution have also been discussed. © 2011 Published by Elsevier Ltd.
1,524 citations
••
01 Jan 2010TL;DR: In this article, the fundamental principles governing laser propagation and absorption as well as the resulting material responses are discussed, and two case studies of improving efficiency in photovoltaic and optoelectronic devices are presented.
Abstract: Lasers provide the ability to accurately deliver large amounts of energy into confined regions of a material in order to achieve a desired response. For opaque materials, this energy is absorbed near the surface, modifying surface chemistry, crystal structure, and/or multiscale morphology without altering the bulk. This chapter covers a brief introduction to the fundamental principles governing laser propagation and absorption as well as the resulting material responses. We then highlight two case studies of improving efficiency in photovoltaic and optoelectronic devices as well as optimizing cell-surface interactions in biological interfaces.
319 citations
••
TL;DR: In this paper, a broadband, omnidirectional, graded-index antireflection (AR) coating made using nanostructured low-refractive index (n=1.05-1.40) silica deposited by oblique-angle deposition is reported.
Abstract: Design, fabrication, and characterization of a broadband, omnidirectional, graded-index antireflection (AR) coating made using nanostructured low-refractive-index (n=1.05–1.40) silica deposited by oblique-angle deposition are reported. Averaged over wavelength range from 400 to 1100 nm and 0°–90° angle of incidence, polished Si reflects ∼37% of incident radiation. The reflection losses are reduced to only 5.9% by applying a three-layer graded-index AR coating to Si. Our experimental results are in excellent agreement with theoretical calculations. The AR coatings reported here can be optimized for photovoltaic cells made of any type of material.
300 citations
••
TL;DR: In this article, a detailed review of the work done to improve the performance of DSSC, with supporting data, is presented, which includes a summary of the suggested improvements by various researchers, bifurcated into different sections with respect to the different components.
Abstract: Dye Sensitized Solar Cell (DSSC) is considered to be one of the most promising technological developments in the field of Solar Cells. It is basically a cell that imitates the process seen in plant cells to produce energy. It is a photo-electrochemical cell, considering the electron moments caused by the combined effect of the photon energy and the chemical reactions. The DSSC being transparent to some extent and comparatively cheaper than conventional solar photo-voltaic, can be a potential energy source for the future. But there are many aspects that need to be worked upon before declaring it as a feasible commercial product. The paper emphasizes on these aspects and the various improvements that the DSSC has gone through in recent years. This is a detailed review of the work done to improve the performance of DSSC, with supporting data. A comparative study of the effect of various suggested modification to the different components of DSSC has been done. This would give a clear idea about the most recent improvements done in DSSC with respect to the various components. It includes a summary of the suggested improvements by various researchers, bifurcated into different sections with respect to the different components of the DSSC. It was observed that incorporating graphene sheets of various sizes in the photo anode helped to improve the efficiency of DSSC significantly, giving a maximum efficiency of 6.62%. In case of novel dyes used in the DSSC fabrication the D-A-pi-A indoline dyes showed a great enhancement in the cell efficiency, with efficiency of up to 6.9%. Incorporation of Pt in counter electrodes and 3D-CE also showed notably good efficiency in DSSC, the efficiency improving up to 8.8%.
274 citations
••
TL;DR: Graphene oxide (GO) is useful and promising material for graphene-based applications in electronic, optics, chemistry, energy storage and biology as discussed by the authors, however, the results of recent research demonstrated a great amount of unique chemical, optical and electronic properties of graphene oxide that allow regarding it as independent nanomaterial possessing a large area of applications.
Abstract: Graphene oxide (GO) is useful and promising material for graphene based applications in electronic, optics, chemistry, energy storage and biology. At the beginning of graphene history GO was only a simple and cheap step for preparation of single and multilayer graphene films and bulk structures by reduction. The further studies revealed the substantial structure imperfection of graphene oxide derived materials due to the defects in initial graphite and incompletion of reducing process. However, the results of recent research demonstrated a great amount of unique chemical, optical and electronic properties of graphene oxide that allow regarding it as independent nanomaterial possessing a large area of applications. In general, it represents the ultra-large organic molecule containing 2D carbon mesh. Unlike conventional graphene it provides wide range of chemical methods for attachment of various functional groups to its surface for control optical transparency, electrical and thermal conductance. Recently developed methods for preparation of graphene oxide derivatives saturated by carboxyl groups open the new attractive application areas in green technologies including energy storage and utilizing nuclear wastes. The goal of the review is to summarize the results of recent studies of graphene oxide, derivatives and reveal the most promising directions to focus the efforts of researchers.
202 citations