Alexander S. Peregudov

Bio: Alexander S. Peregudov is an academic researcher from A. N. Nesmeyanov Institute of Organoelement Compounds. The author has contributed to research in topics: Catalysis & Aryl. The author has an hindex of 27, co-authored 399 publications receiving 3908 citations. Previous affiliations of Alexander S. Peregudov include Moscow State University & Togliatti State University.

Material Solubility-Photovoltaic Performance Relationship in the Design of Novel Fullerene Derivatives for Bulk Heterojunction Solar Cells

Abstract: The preparation of 27 different derivatives of C60 and C70 fullerenes possessing various aryl (heteroaryl) and/or alkyl groups that are appended to the fullerene cage via a cyclopropane moiety and their use in bulk heterojunction polymer solar cells is reported. It is shown that even slight variations in the molecular structure of a compound can cause a significant change in its physical properties, in particular its solubility in organic solvents. Furthermore, the solubility of a fullerene derivative strongly affects the morphology of its composite with poly(3-hexylthiophene), which is commonly used as active material in bulk heterojunction organic solar cells. As a consequence, the solar cell parameters strongly depend on the structure and the properties of the fullerene-based material. The power conversion efficiencies for solar cells comprising these fullerene derivatives range from negligibly low (0.02%) to considerably high (4.1%) values. The analysis of extensive sets of experimental data reveals a general dependence of all solar cell parameters on the solubility of the fullerene derivative used as acceptor component in the photoactive layer of an organic solar cell. It is concluded that the best material combinations are those where donor and acceptor components are of similar and sufficiently high solubility in the solvent used for the deposition of the active layer.

Synthesis of α-Amino Acids via Asymmetric Phase Transfer-Catalyzed Alkylation of Achiral Nickel(II) Complexes of Glycine-Derived Schiff Bases

Abstract: Achiral, diamagnetic Ni(II) complexes 1 and 3 have been synthesized from Ni(II) salts and the Schiff bases, generated from glycine and PBP (7) and PBA (11), respectively, in MeONa/MeOH solutions. The requisite carbonyl-derivatizing agents pyridine-2-carboxylic acid(2-benzoyl-phenyl)-amide 7 (PBP) and pyridine-2-carboxylic acid(2-formyl-phenyl)-amide 11 (PBA) were readily prepared from picolinic acid and o-aminobenzophenone or picolinic acid and methyl o-anthranilate, respectively. The structure of 1 was established by X-ray crystallography. Complexes 1 and 3 were found to undergo C-alkylation with alkyl halides under PTC conditions in the presence of beta-naphthol or benzyltriethylammonium bromide as catalysts to give mono- and bis-alkylated products, respectively. Decomposition of the complexes with aqueous HCl under mild conditions gave the required amino acids, and PBP and PBA were recovered. Alkylation of 1 with highly reactive alkyl halides, carried out under the PTC conditions in the presence of 10% mol of (S)- or (R)-2-hydroxy-2'-amino-1,1'-binaphthyl 31a (NOBIN) and/or its N-acyl derivatives and by (S)- or (R)-2-hydroxy-8'-amino-1,1'-binaphthyl 32a (iso-NOBIN) and its N-acyl derivatives, respectively, gave rise to alpha-amino acids with high enantioselectivities (90-98.5% ee) in good-to-excellent chemical yields at room temperature within several minutes. An unusually large positive nonlinear effect was observed in these reactions. The Michael addition of acrylic derivatives 37 to 1 was conducted under similar conditions with up to 96% ee. The (1)H NMR and IR spectra of a mixture of the sodium salt of NOBIN and 1 indicated formation of a complex between the two components. Implications of the association and self-association of NOBIN for the observed sense of asymmetric induction and nonlinear effects are discussed.

Chlorofullerene C60Cl6: a precursor for straightforward preparation of highly water-soluble polycarboxylic fullerene derivatives active against HIV.

Abstract: We report for the first time the application of chlorofullerene C60Cl6 as a substrate for straightforward preparation of highly water-soluble fullerene derivatives, promising compounds for investigation of the biological action of fullerenesin vitro and in vivo. Methyl esters of phenylacetic and benzylmalonic acids were used as reagents in the Friedel–Crafts arylation of C60Cl6 that resulted in the corresponding C60(Ar)5Cl compounds with 50–60% yields. The following cleavage of ester groups in phenylacetic and benzylmalonic residues was accomplished almost quantitatively to yield the corresponding fullerene-based acids bearing 5 and 10 carboxylic groups, respectively. The relatively-low solubility of these acids in water can be strongly enhanced (up to 150–200 mg ml–1) by their conversion to salts with alkali metal cations. These fullerene salt derivatives showed pronounced anti-HIV action and low toxicity; these two findings point to the necessity for further investigation of the biological properties of the here-reported compounds.

Aggregation and morphology control enables multiple cases of high-efficiency polymer solar cells.

Abstract: Although the field of polymer solar cell has seen much progress in device performance in the past few years, several limitations are holding back its further development For instance, current high-efficiency (>90%) cells are restricted to material combinations that are based on limited donor polymers and only one specific fullerene acceptor Here we report the achievement of high-performance (efficiencies up to 108%, fill factors up to 77%) thick-film polymer solar cells for multiple polymer:fullerene combinations via the formation of a near-ideal polymer:fullerene morphology that contains highly crystalline yet reasonably small polymer domains This morphology is controlled by the temperature-dependent aggregation behaviour of the donor polymers and is insensitive to the choice of fullerenes The uncovered aggregation and design rules yield three high-efficiency (>10%) donor polymers and will allow further synthetic advances and matching of both the polymer and fullerene materials, potentially leading to significantly improved performance and increased design flexibility

Copper-mediated coupling reactions and their applications in natural products and designed biomolecules synthesis.

Abstract: 6.4. Polyynes 3123 6.5. Using R-Hydroxy Stannanes 3124 6.6. Using the Hurtley Reaction 3124 6.7. Using a Methylenation Reaction 3125 7. Conclusions and Future Prospects 3125 8. Uncommon Abbreviations 3125 9. Acknowledgments 3125 10. Note Added in Proof 3125 11. References 3126 * Authorstowhomcorrespondenceshouldbeaddressed(evano@chimie.uvsq.fr, nicolas.blanchard@uha.fr). † Université de Versailles Saint Quentin en Yvelines. ‡ Université de Haute-Alsace. Chem. Rev. 2008, 108, 3054–3131 3054

Ab initio calculation of vibrational absorption and circular dichroism spectra using density functional force fields

Abstract: : The unpolarized absorption and circular dichroism spectra of the fundamental vibrational transitions of the chiral molecule, 4-methyl-2-oxetanone, are calculated ab initio. Harmonic force fields are obtained using Density Functional Theory (DFT), MP2, and SCF methodologies and a 5S4P2D/3S2P (TZ2P) basis set. DFT calculations use the Local Spin Density Approximation (LSDA), BLYP, and Becke3LYP (B3LYP) density functionals. Mid-IR spectra predicted using LSDA, BLYP, and B3LYP force fields are of significantly different quality, the B3LYP force field yielding spectra in clearly superior, and overall excellent, agreement with experiment. The MP2 force field yields spectra in slightly worse agreement with experiment than the B3LYP force field. The SCF force field yields spectra in poor agreement with experiment.The basis set dependence of B3LYP force fields is also explored: the 6-31G* and TZ2P basis sets give very similar results while the 3-21G basis set yields spectra in substantially worse agreements with experiment. jg

Small molecule organic semiconductors on the move: promises for future solar energy technology.

Abstract: This article is written from an organic chemist's point of view and provides an up-to-date review about organic solar cells based on small molecules or oligomers as absorbers and in detail deals with devices that incorporate planar-heterojunctions (PHJ) and bulk heterojunctions (BHJ) between a donor (p-type semiconductor) and an acceptor (n-type semiconductor) material. The article pays particular attention to the design and development of molecular materials and their performance in corresponding devices. In recent years, a substantial amount of both, academic and industrial research, has been directed towards organic solar cells, in an effort to develop new materials and to improve their tunability, processability, power conversion efficiency, and stability. On the eve of commercialization of organic solar cells, this review provides an overview over efficiencies attained with small molecules/oligomers in OSCs and reflects materials and device concepts developed over the last decade. Approaches to enhancing the efficiency of organic solar cells are analyzed.