Anna Maria Giovanna Musinu

Bio: Anna Maria Giovanna Musinu is an academic researcher from University of Cagliari. The author has contributed to research in topics: Nanoparticle & Superparamagnetism. The author has an hindex of 38, co-authored 136 publications receiving 4997 citations. Previous affiliations of Anna Maria Giovanna Musinu include Technical University of Denmark & University of Milano-Bicocca.

Correlated electron–hole plasma in organometal perovskites

Abstract: Organic-inorganic perovskites are a class of solution-processed semiconductors holding promise for the realization of low-cost efficient solar cells and on-chip lasers. Despite the recent attention they have attracted, fundamental aspects of the photophysics underlying device operation still remain elusive. Here we use photoluminescence and transmission spectroscopy to show that photoexcitations give rise to a conducting plasma of unbound but Coulomb-correlated electron-hole pairs at all excitations of interest for light-energy conversion and stimulated optical amplification. The conductive nature of the photoexcited plasma has crucial consequences for perovskite-based devices: in solar cells, it ensures efficient charge separation and ambipolar transport while, concerning lasing, it provides a low threshold for light amplification and justifies a favourable outlook for the demonstration of an electrically driven laser. We find a significant trap density, whose cross-section for carrier capture is however low, yielding a minor impact on device performance.

Characterization of Iron Oxide Nanoparticles in an Fe2O3−SiO2 Composite Prepared by a Sol−Gel Method

Abstract: An Fe2O3−SiO2 composite was prepared by a gelation method that adopts tetraethoxysilane and iron(III) nitrate as starting materials. The dried gel was treated at increasing temperatures, and the samples were characterized by XRD, TEM, magnetic susceptibility measurements, and EPR and Mossbauer spectroscopies. Nanometer size (3−4 nm) X-ray-amorphous iron(III) oxide particles are observed in the samples treated at low temperature. These particles display superparamagnetic behavior in the Mossbauer spectra and susceptibility measurements, and their magnetic moments indicate antiferromagnetic clustering. The occurrence of two sites for iron ions, one in the bulk and one on the surface of nanoparticles, is suggested by EPR and Mossbauer spectroscopies. Heating of the samples to higher temperatures (T > 700 °C) gives rise to a small increase of the particle size. Simultaneously XRD and TEM exhibit the formation of γ-Fe2O3 crystalline particles, Mossbauer spectra reveal a large change in the magnetization, magne...

Structural and Magnetic Properties of Fe2O3 Nanoparticles Dispersed over a Silica Matrix

Abstract: The structure and the magnetic properties of a series of Fe2O3−SiO2 nanocomposites (9−33 wt % Fe2O3), prepared by a sol−gel method and submitted to thermal treatments in the temperature range 300−900 °C, were investigated through XRD, TEM, EPR, and magnetic susceptibility measurements. Superparamagnetic iron(III) oxide nanoparticles with a narrow size distribution, dispersed over the amorphous silica matrix, are present in all the samples. They are mostly amorphous, antiferromagnetic in the samples treated at low temperatures. At T > 700 °C, a lot of γ-Fe2O3 crystalline ferrimagnetic nanoparticles (4−6 nm) are formed, while a further increase of the temperature results in the γ- to α-Fe2O3 transformation. The variation of iron oxide content affects the abundance of γ-Fe2O3 formation, which reaches the maximum percent values in the more dilute samples. In the more concentrated samples, while the amount of maghemite is still growing, antiferromagnetic α-Fe2O3 begins to form. As a consequence, the saturation...

Interparticle Interactions and Magnetic Anisotropy in Cobalt Ferrite Nanoparticles: Influence of Molecular Coating

Abstract: Molecular coating of nanoparticles represents probably the most important and, at the same time, critical step to design new nanostructured magnetic materials. The interaction between molecules and surface atoms leads to a strong modification of surface magnetic properties, that are one of the key points in the physics of magnetic nanoparticles. In this paper the magnetic properties of CoFe2O4 nanoparticles (⟨D⟩ ≅ 4–8 nm) coated with oleic acid have been investigated in order to clarify the role of the molecular coating on the interparticle interactions and surface anisotropy. An increase of magnetic anisotropy (i.e., coercive field and anisotropy constant) with particle size is observed in coated nanoparticles, indicating that the magnetic anisotropy is governed mainly by its magneto-crystalline component. The removal of molecular coating induces a strong increase of anisotropy, because of the increase of its surface component, as indicated by the increase of exchange bias field.

Studying the effect of Zn-substitution on the magnetic and hyperthermic properties of cobalt ferrite nanoparticles

Abstract: The possibility to finely control nanostructured cubic ferrites (M(II)Fe2O4) paves the way to design materials with the desired magnetic properties for specific applications. However, the strict and complex interrelation among the chemical composition, size, polydispersity, shape and surface coating renders their correlation with the magnetic properties not trivial to predict. In this context, this work aims to discuss the magnetic properties and the heating abilities of Zn-substituted cobalt ferrite nanoparticles with different zinc contents (ZnxCo1-xFe2O4 with 0 100 emu g(-1)). The increase in the zinc content up to x = 0.46 in the structure has resulted in an increase of the saturation magnetisation (Ms) at 5 K. High Ms values have also been revealed at room temperature (∼90 emu g(-1)) for both CoFe2O4 and Zn0.30Co0.70Fe2O4 samples and their heating ability has been tested. Despite a similar saturation magnetisation, the specific absorption rate value for the cobalt ferrite is three times higher than the Zn-substituted one. DC magnetometry results were not sufficient to justify these data, the experimental conditions of SAR and static measurements being quite different. The synergic combination of DC with AC magnetometry and (57)Fe Mossbauer spectroscopy represents a powerful tool to get new insights into the design of suitable heat mediators for magnetic fluid hyperthermia.

Nanocrystals of Cesium Lead Halide Perovskites (CsPbX3, X = Cl, Br, and I): Novel Optoelectronic Materials Showing Bright Emission with Wide Color Gamut

Abstract: Metal halides perovskites, such as hybrid organic–inorganic CH3NH3PbI3, are newcomer optoelectronic materials that have attracted enormous attention as solution-deposited absorbing layers in solar cells with power conversion efficiencies reaching 20%. Herein we demonstrate a new avenue for halide perovskites by designing highly luminescent perovskite-based colloidal quantum dot materials. We have synthesized monodisperse colloidal nanocubes (4–15 nm edge lengths) of fully inorganic cesium lead halide perovskites (CsPbX3, X = Cl, Br, and I or mixed halide systems Cl/Br and Br/I) using inexpensive commercial precursors. Through compositional modulations and quantum size-effects, the bandgap energies and emission spectra are readily tunable over the entire visible spectral region of 410–700 nm. The photoluminescence of CsPbX3 nanocrystals is characterized by narrow emission line-widths of 12–42 nm, wide color gamut covering up to 140% of the NTSC color standard, high quantum yields of up to 90%, and radiativ...

Magnetic Iron Oxide Nanoparticles: Synthesis, Stabilization, Vectorization, Physicochemical Characterizations, and Biological Applications

Abstract: 1. Introduction 20642. Synthesis of Magnetic Nanoparticles 20662.1. Classical Synthesis by Coprecipitation 20662.2. Reactions in Constrained Environments 20682.3. Hydrothermal and High-TemperatureReactions20692.4. Sol-Gel Reactions 20702.5. Polyol Methods 20712.6. Flow Injection Syntheses 20712.7. Electrochemical Methods 20712.8. Aerosol/Vapor Methods 20712.9. Sonolysis 20723. Stabilization of Magnetic Particles 20723.1. Monomeric Stabilizers 20723.1.1. Carboxylates 20733.1.2. Phosphates 20733.2. Inorganic Materials 20733.2.1. Silica 20733.2.2. Gold 20743.3. Polymer Stabilizers 20743.3.1. Dextran 20743.3.2. Polyethylene Glycol (PEG) 20753.3.3. Polyvinyl Alcohol (PVA) 20753.3.4. Alginate 20753.3.5. Chitosan 20753.3.6. Other Polymers 20753.4. Other Strategies for Stabilization 20764. Methods of Vectorization of the Particles 20765. Structural and Physicochemical Characterization 20785.1. Size, Polydispersity, Shape, and SurfaceCharacterization20795.2. Structure of Ferro- or FerrimagneticNanoparticles20805.2.1. Ferro- and Ferrimagnetic Nanoparticles 20805.3. Use of Nanoparticles as Contrast Agents forMRI20825.3.1. High Anisotropy Model 20845.3.2. Small Crystal and Low Anisotropy EnergyLimit20855.3.3. Practical Interests of Magnetic NuclearRelaxation for the Characterization ofSuperparamagnetic Colloid20855.3.4. Relaxation of Agglomerated Systems 20856. Applications 20866.1. MRI: Cellular Labeling, Molecular Imaging(Inflammation, Apoptose, etc.)20866.2.

Mechanical Alloying And Milling

Abstract: Mechanical alloying (MA) is a solid-state powder processng technique involving repeated welding, fracturing, and rewelding of powder particles in a high-energy ball mill. Originally developed to produce oxide-dispersion strengthened (ODS) nickel- and iron-base superalloys for applications in the aerospace industry, MA has now been shown to be capable of synthesizing a variety of equilibrium and non-equilibrium alloy phases starting from blended elemental or prealloyed powders. The non-equilibrium phases synthesized include supersaturated solid solutions, metastable crystalline and quasicrystalline phases, nanostructures, and amorphous alloys. Recent advances in these areas and also on disordering of ordered intermetallics and mechanochemical synthesis of materials have been critically reviewed after discussing the process and process variables involved in MA. The often vexing problem of powder contamination has been analyzed and methods have been suggested to avoid/minimize it. The present understanding of the modeling of the MA process has also been discussed. The present and potential applications of MA are described. Wherever possible, comparisons have been made on the product phases obtained by MA with those of rapid solidification processing, another non-equilibrium processing technique.

Recent advances in the liquid-phase syntheses of inorganic nanoparticles.

Abstract: The development of novel materials is a fundamental focal point of chemical research; and this interest is mandated by advancements in all areas of industry and technology. A good example of the synergism between scientific discovery and technological development is the electronics industry, where discoveries of new semiconducting materials resulted in the evolution from vacuum tubes to diodes and transistors, and eventually to miniature chips. The progression of this technology led to the development * To whom correspondence should be addressed. B.L.C.: (504) 2801385 (phone); (504) 280-3185 (fax); bcushing@uno.edu (e-mail). C.J.O.: (504)280-6846(phone);(504)280-3185(fax);coconnor@uno.edu (e-mail). 3893 Chem. Rev. 2004, 104, 3893−3946