Anvar Kacimov

Bio: Anvar Kacimov is an academic researcher from Sultan Qaboos University. The author has contributed to research in topics: Aquifer & Phreatic. The author has an hindex of 21, co-authored 167 publications receiving 2006 citations. Previous affiliations of Anvar Kacimov include Cranfield University.

Geoelectrical and hydrogeochemical studies for delineating seawater intrusion in the outlet of Wadi Ham, UAE

Abstract: The Quaternary aquifer of Wadi Ham, UAE has been overexploited during the last two decades to meet the increasing water demands. As a result, the dynamic balance between freshwater and seawater has been disturbed and the quality of the groundwater has deteriorated. In this paper, a 2D earth resistivity survey was conducted in Wadi Ham in the area between Fujairah and Kalba to delineate the seawater intrusion. Existing monitoring wells were used to measure the horizontal and vertical variations in water salinity and thus to improve the interpretation of earth resistivity imaging data. Results of vertical electrical soundings and chemical analyses of collected water samples were used to obtain an empirical relationship between the inferred earth resistivity and the amount of total dissolved solids. This relationship was used along with the true resistivity sections resulting from the inversion of 2D resistivity data to identify three zones of water-bearing formation (fresh, brackish, and salt-water zones). Along the four 2D resistivity profiles, the depth to the fresh-brackish interface exceeded 50 m at the western part of the area and was in the order of 10 m or less in the eastern side near the shoreline. Depth to the brackish-saline water interface reached about 70 m in the western side and was in the order of 20 m in the eastern side. The thickness of the fresh water zone decreases considerably in the farming areas toward Kalba and thus the degree of seawater intrusion increases.

Mass fractal dimension of soil macropores using computed tomography: from the box‐counting to the cube‐counting algorithm

Abstract: Summary Transport phenomena in porous media depend strongly on three-dimensional pore structures. Macropore networks enable water and solute to move preferentially through the vadose zone. A complete representation of their geometry is important for understanding soil behaviour such as preferential flow. Once we know the geometrical, topological and scaling attributes of preferential flow paths, we can begin computer simulations of water movement in the soil. The box-counting method is used in three dimensions (i.e. cube-counting algorithm) to characterize the mass fractal dimension of macropore networks using X-ray computed tomography (CT) matrices. We developed an algorithm to investigate the mass fractal dimension in three dimensions and to see how it compares with the co-dimensions obtained using the box-counting technique in two dimensions. For that purpose, macropore networks in four large undisturbed soil columns (850 mm × 77 mm diameter) were quantified and visualized, in both two and three dimensions, using X-ray CT. We observed an increasing trend between the fractal dimension and macroporosity for the four columns. Moreover, similar natural logarithm functions were obtained for the four cores by a least squares fit through plots of mass fractal dimension against macroporosity.

Control of sea-water intrusion by salt-water pumping: Coast of Oman

Abstract: A shallow alluvial coastal aquifer in the Batinah area of Oman, with sea-water intrusion that extends several kilometres inland, has been studied experimentally, analytically and numerically. The water table is proved to have a trough caused by intensive pumping from a fresh groundwater zone and evaporation from the saline phreatic surface. Resistivity traverses perpendicular to the shoreline indicated no fresh groundwater recharge into the sea. Using an analytical Dupuit-Forchheimer model, developed for the plain part of the catchment, explicit expressions for the water table, sharp interface location and stored volume of fresh water are obtained. It is shown that by the pumping of salt water from the intruded part of the aquifer, this intrusion can be mitigated. Different catchment sizes, intensities of fresh groundwater pumping, evaporation rates, water densities, sea level, incident fresh water level in the mountains and hydraulic conductivity are considered. SUTRA code is applied to a hypothetical case of a leaky aquifer with line sinks modeling fresh water withdrawal and evaporation. The numerical code also shows that pumping of saline water can pull the dispersion zone back to the shoreline.

Modeling Groundwater Flow and Seawater Intrusion in the Coastal Aquifer of Wadi Ham, UAE

Abstract: Groundwater pumping from Kalbha and Fujairah coastal aquifer of the United Arab Emirates (UAE) has increased significantly during the last two decades to meet the agriculture water demands. Due to the lack of natural replenishment from rainfall and the excessive pumping, groundwater levels have declined significantly causing an intrusion of seawater in the coastal aquifer of Wadi Ham. As a result, many pumping wells in the coastal zone have been terminated and a number of farms have been abandoned. In this paper, MODFLOW was used to simulate the groundwater flow and assess the seawater intrusion in the coastal aquifer of Wadi Ham. The model was calibrated against a five-year dataset of historical groundwater levels and validated against another eleven-year dataset. The effects of pumping on groundwater levels and seawater intrusion were investigated. Results showed that reducing the pumping from Khalbha well field will help to reduce the seawater intrusion into the southeastern part of the aquifer. Under the current groundwater pumping rates, the seawater will continue to migrate inland.

Inductive Teaching and Learning Methods: Definitions, Comparisons, and Research Bases

Abstract: Traditional engineering instruction is deductive, beginning with theories and progressing to the applications of those theories Alternative teaching approaches are more inductive Topics are introduced by presenting specific observations, case studies or problems, and theories are taught or the students are helped to discover them only after the need to know them has been established This study reviews several of the most commonly used inductive teaching methods, including inquiry learning, problem-based learning, project-based learning, case-based teaching, discovery learning, and just-in-time teaching The paper defines each method, highlights commonalities and specific differences, and reviews research on the effectiveness of the methods While the strength of the evidence varies from one method to another, inductive methods are consistently found to be at least equal to, and in general more effective than, traditional deductive methods for achieving a broad range of learning outcomes

The Insect Societies

Abstract: In his introduction to this detailed survey of knowledge of insect societies, the author points out that research on insect sociology has proceeded in three phases, the natural history phase, the physiological phase and the population-biology phase. Advances in the first two phases have permitted embarkation in the third phase on a more rigorous theory of social evolution based on population genetics and writing this book, the author wished to relate the three phases of research on insects and to express insect sociology as population biology. A glossary of terms, a considerable bibliography and a general index are included. Other CABI sites 