Bates Andrew

Bio: Bates Andrew is an academic researcher. The author has contributed to research in topics: Thesaurus (information retrieval). The author has an hindex of 1, co-authored 1 publications receiving 10 citations.

The AirSpeck Family of Static and Mobile Wireless Air Quality Monitors

Abstract: The Automatic Urban and Rural Network (AURN) [1] is a set of high quality reference monitoring sites for recording air quality in the United Kingdom. They are costly to install and expensive to run, and are therefore limited in numbers. The data from these networks are used to inform regulatory compliance with the Ambient Air Quality Directives [2]. There is also a requirement to monitor air pollution at sufficiently high spatial and temporal resolutions around people to estimate personal exposure to particulates, and gases such as Nitrogen Dioxide and Ozone for better understanding their health impacts. Such high resolution measurements can also be used for validating the air quality models' estimates of variability over space and time due to complex interactions. Networks of air-quality monitors using inexpensive sensors offer a cost-effective alternative approach for recording trends in air quality at a higher spatial resolution, albeit not as accurately as the reference monitoring sites. This paper describes the design, implementation, and deployment of a family of air quality monitors: stationary (AirSpeck-S) monitors for measuring ambient air quality, and mobile wearable AirSpeck-P for monitoring personal exposure to air borne particulates (PM10, PM2.5 and PM1), and the gases - Nitrogen Dioxide and Ozone. Results are presented for characterising the ambient air quality in public spaces gathered from people wearing the AirSpeck-P monitors who are out and about in two cities as pedestrians (Edinburgh, Scotland) and as car passengers (Delhi, India). The paper demonstrates the viability of using inexpensive static and mobile AirSpeck monitors for mapping trends in particulate concentrations in urban spaces. Results are presented for comparisons of the mobile personal exposure data from pedestrians with static AirSpeck-S monitors along the same route, and the characterization of urban spaces based on levels of particulate concentration using the AirSpeck-P monitor.

Applications of low-cost sensing technologies for air quality monitoring and exposure assessment: How far have they gone?

Abstract: Over the past decade, a range of sensor technologies became available on the market, enabling a revolutionary shift in air pollution monitoring and assessment. With their cost of up to three orders of magnitude lower than standard/reference instruments, many avenues for applications have opened up. In particular, broader participation in air quality discussion and utilisation of information on air pollution by communities has become possible. However, many questions have been also asked about the actual benefits of these technologies. To address this issue, we conducted a comprehensive literature search including both the scientific and grey literature. We focused upon two questions: (1) Are these technologies fit for the various purposes envisaged? and (2) How far have these technologies and their applications progressed to provide answers and solutions? Regarding the former, we concluded that there is no clear answer to the question, due to a lack of: sensor/monitor manufacturers' quantitative specifications of performance, consensus regarding recommended end-use and associated minimal performance targets of these technologies, and the ability of the prospective users to formulate the requirements for their applications, or conditions of the intended use. Numerous studies have assessed and reported sensor/monitor performance under a range of specific conditions, and in many cases the performance was concluded to be satisfactory. The specific use cases for sensors/monitors included outdoor in a stationary mode, outdoor in a mobile mode, indoor environments and personal monitoring. Under certain conditions of application, project goals, and monitoring environments, some sensors/monitors were fit for a specific purpose. Based on analysis of 17 large projects, which reached applied outcome stage, and typically conducted by consortia of organizations, we observed that a sizable fraction of them (~ 30%) were commercial and/or crowd-funded. This fact by itself signals a paradigm change in air quality monitoring, which previously had been primarily implemented by government organizations. An additional paradigm-shift indicator is the growing use of machine learning or other advanced data processing approaches to improve sensor/monitor agreement with reference monitors. There is still some way to go in enhancing application of the technologies for source apportionment, which is of particular necessity and urgency in developing countries. Also, there has been somewhat less progress in wide-scale monitoring of personal exposures. However, it can be argued that with a significant future expansion of monitoring networks, including indoor environments, there may be less need for wearable or portable sensors/monitors to assess personal exposure. Traditional personal monitoring would still be valuable where spatial variability of pollutants of interest is at a finer resolution than the monitoring network can resolve.

Edge Computing Based IoT Architecture for Low Cost Air Pollution Monitoring Systems: A Comprehensive System Analysis, Design Considerations & Development

Abstract: With the swift growth in commerce and transportation in the modern civilization, much attention has been paid to air quality monitoring, however existing monitoring systems are unable to provide sufficient spatial and temporal resolutions of the data with cost efficient and real time solutions In this paper we have investigated the issues, infrastructure, computational complexity, and procedures of designing and implementing real-time air quality monitoring systems To daze the defects of the existing monitoring systems and to decrease the overall cost, this paper devised a novel approach to implement the air quality monitoring system, employing the edge-computing based Internet-of-Things (IoT) In the proposed method, sensors gather the air quality data in real time and transmit it to the edge computing device that performs necessary processing and analysis The complete infrastructure & prototype for evaluation is developed over the Arduino board and IBM Watson IoT platform Our model is structured in such a way that it reduces the computational burden over sensing nodes (reduced to 70%) that is battery powered and balanced it with edge computing device that has its local data base and can be powered up directly as it is deployed indoor Algorithms were employed to avoid temporary errors in low cost sensor, and to manage cross sensitivity problems Automatic calibration is set up to ensure the accuracy of the sensors reporting, hence achieving data accuracy around 75–80% under different circumstances In addition, a data transmission strategy is applied to minimize the redundant network traffic and power consumption Our model acquires a power consumption reduction up to 23% with a significant low cost Experimental evaluations were performed under different scenarios to validate the system’s effectiveness

Review of urban computing in air quality management as smart city service: An integrated IoT, AI, and cloud technology perspective

Abstract: Cities foster economic growth. However, growing cities also contribute to air pollution and climate change. The paper provides a perspective regarding the opportunity available in addressing the urban air quality management (UAQM) issues using smart city framework in the context of ‘urban computing’. Traditionally, UAQM has been built on sparse regulatory monitoring, enhanced with satellite data and forecast models. The ‘Fourth Industrial Revolution’ (4IR) technologies such as Internet of Things (IoT), big data, artificial intelligence, smartphones, social and cloud computing are reshaping urban conglomerates, worldwide. Cities can harness these ubiquitous technologies in concert with traditional methods for betterment of air quality governance and to improve quality of life. This paper discusses the role of urban computing in UAQM through a review of scientific publications and ‘grey literature’ from technical reports of governments, international organizations and institutional websites. It provides an interdisciplinary knowledge repository on urban computing applications for air quality functions. It highlights the potential of integrated technologies in enabling data driven, strategic and real-time mitigation governance actions and helping citizens to take informed decisions. It recommends ‘fit for the purpose’ multitechnology framework for UAQM services in emerging smart cities.