Bo Yu

Bio: Bo Yu is an academic researcher from Boston College. The author has contributed to research in topics: Thermoelectric effect & Thermoelectric materials. The author has an hindex of 19, co-authored 37 publications receiving 11534 citations. Previous affiliations of Bo Yu include The University of Nottingham Ningbo China.

High-Thermoelectric Performance of Nanostructured Bismuth Antimony Telluride Bulk Alloys

Abstract: The dimensionless thermoelectric figure of merit (ZT) in bismuth antimony telluride (BiSbTe) bulk alloys has remained around 1 for more than 50 years. We show that a peak ZT of 1.4 at 100°C can be achieved in a p-type nanocrystalline BiSbTe bulk alloy. These nanocrystalline bulk materials were made by hot pressing nanopowders that were ball-milled from crystalline ingots under inert conditions. Electrical transport measurements, coupled with microstructure studies and modeling, show that the ZT improvement is the result of low thermal conductivity caused by the increased phonon scattering by grain boundaries and defects. More importantly, ZT is about 1.2 at room temperature and 0.8 at 250°C, which makes these materials useful for cooling and power generation. Cooling devices that use these materials have produced high-temperature differences of 86°, 106°, and 119°C with hot-side temperatures set at 50°, 100°, and 150°C, respectively. This discovery sets the stage for use of a new nanocomposite approach in developing high-performance low-cost bulk thermoelectric materials.

High-performance flat-panel solar thermoelectric generators with high thermal concentration

Abstract: The conversion of sunlight into electricity has been dominated by photovoltaic and solar thermal power generation. A highly efficient solar to electric energy conversion device based on nanostructured thermoelectric materials and high solar concentration is now demonstrated. The results show potential for cost effective solar thermoelectric generation.

Enhanced thermoelectric figure-of-merit in p-type nanostructured bismuth antimony tellurium alloys made from elemental chunks.

Abstract: By ball milling alloyed bulk crystalline ingots into nanopowders and hot pressing them, we had demonstrated high figure-of-merit in nanostructured bulk bismuth antimony telluride. In this study, we use the same ball milling and hot press technique, but start with elemental chunks of bismuth, antimony, and tellurium to avoid the ingot formation step. We show that a peak ZT of about 1.3 in the temperature range of 75 and 100 °C has been achieved. This process is more economical and environmentally friendly than starting from alloyed bulk crystalline ingots. The ZT improvement is caused mostly by the lower thermal conductivity, similar as the case using ingot. Transmission electron microscopy observations of the microstructures suggest that the lower thermal conductivity is mainly due to the increased phonon scattering from the increased grain boundaries of the nanograins, precipitates, nanodots, and defects. Our material also exhibits a ZT of 0.7 at 250 °C, similar to the value obtained when ingot was used. This study demonstrates that high ZT values can be achieved in nanostructured bulk materials with ball milling elemental chunks, suggesting that the approach can be applied to other materials that are hard to be made into ingot, in addition to its advantage of lower manufacturing cost.

Enhancement of Thermoelectric Properties by Modulation-Doping in Silicon Germanium Alloy Nanocomposites

Abstract: Modulation-doping was theoretically proposed and experimentally proved to be effective in increasing the power factor of nanocomposites (Si80Ge20)70(Si100B5)30 by increasing the carrier mobility but not the figure-of-merit (ZT) due to the increased thermal conductivity. Here we report an alternative materials design, using alloy Si70Ge30 instead of Si as the nanoparticles and Si95Ge5 as the matrix, to increase the power factor but not the thermal conductivity, leading to a ZT of 1.3 ± 0.1 at 900 °C.

Two-Dimensional Nanosheets Produced by Liquid Exfoliation of Layered Materials

Abstract: If they could be easily exfoliated, layered materials would become a diverse source of two-dimensional crystals whose properties would be useful in applications ranging from electronics to energy storage. We show that layered compounds such as MoS2, WS2, MoSe2, MoTe2, TaSe2, NbSe2, NiTe2, BN, and Bi2Te3 can be efficiently dispersed in common solvents and can be deposited as individual flakes or formed into films. Electron microscopy strongly suggests that the material is exfoliated into individual layers. By blending this material with suspensions of other nanomaterials or polymer solutions, we can prepare hybrid dispersions or composites, which can be cast into films. We show that WS2 and MoS2 effectively reinforce polymers, whereas WS2/carbon nanotube hybrid films have high conductivity, leading to promising thermoelectric properties.

Cooling, heating, generating power, and recovering waste heat with thermoelectric systems.

Abstract: Thermoelectric materials are solid-state energy converters whose combination of thermal, electrical, and semiconducting properties allows them to be used to convert waste heat into electricity or electrical power directly into cooling and heating. These materials can be competitive with fluid-based systems, such as two-phase air-conditioning compressors or heat pumps, or used in smaller-scale applications such as in automobile seats, night-vision systems, and electrical-enclosure cooling. More widespread use of thermoelectrics requires not only improving the intrinsic energy-conversion efficiency of the materials but also implementing recent advancements in system architecture. These principles are illustrated with several proven and potential applications of thermoelectrics.

Prospects of Colloidal Nanocrystals for Electronic and Optoelectronic Applications

Abstract: Nanocrystals (NCs) discussed in this Review are tiny crystals of metals, semiconductors, and magnetic material consisting of hundreds to a few thousand atoms each. Their size ranges from 2-3 to about 20 nm. What is special about this size regime that placed NCs among the hottest research topics of the last decades? The quantum mechanical coupling * To whom correspondence should be addressed. E-mail: dvtalapin@uchicago.edu. † The University of Chicago. ‡ Argonne National Lab. Chem. Rev. 2010, 110, 389–458 389

High-performance bulk thermoelectrics with all-scale hierarchical architectures

Abstract: Controlling the structure of thermoelectric materials on all length scales (atomic, nanoscale and mesoscale) relevant for phonon scattering makes it possible to increase the dimensionless figure of merit to more than two, which could allow for the recovery of a significant fraction of waste heat with which to produce electricity.