Byeong Ha Lee

Bio: Byeong Ha Lee is an academic researcher from Gwangju Institute of Science and Technology. The author has contributed to research in topics: Optical fiber & Photonic-crystal fiber. The author has an hindex of 36, co-authored 280 publications receiving 5532 citations. Previous affiliations of Byeong Ha Lee include University of Ulsan & National Institute of Advanced Industrial Science and Technology.

Interferometric Fiber Optic Sensors

Abstract: Fiber optic interferometers to sense various physical parameters including temperature, strain, pressure, and refractive index have been widely investigated. They can be categorized into four types: Fabry-Perot, Mach-Zehnder, Michelson, and Sagnac. In this paper, each type of interferometric sensor is reviewed in terms of operating principles, fabrication methods, and application fields. Some specific examples of recently reported interferometeric sensor technologies are presented in detail to show their large potential in practical applications. Some of the simple to fabricate but exceedingly effective Fabry-Perot interferometers, implemented in both extrinsic and intrinsic structures, are discussed. Also, a wide variety of Mach-Zehnder and Michelson interferometric sensors based on photonic crystal fibers are introduced along with their remarkable sensing performances. Finally, the simultaneous multi-parameter sensing capability of a pair of long period fiber grating (LPG) is presented in two types of structures; one is the Mach-Zehnder interferometer formed in a double cladding fiber and the other is the highly sensitive Sagnac interferometer cascaded with an LPG pair.

All-fiber Mach-Zehnder type interferometers formed in photonic crystal fiber.

Abstract: We propose simple and compact methods for implementing all-fiber interferometers. The interference between the core and the cladding modes of a photonic crystal fiber (PCF) is utilized. To excite the cladding modes from the fundamental core mode of a PCF, a coupling point or region is formed by using two methods. One is fusion splicing two pieces of a PCF with a small lateral offset, and the other is partially collapsing the air-holes in a single piece of PCF. By making another coupling point at a different location along the fiber, the proposed all-PCF interferometer is implemented. The spectral response of the interferometer is investigated mainly in terms of its wavelength spectrum. The spatial frequency of the spectrum was proportional to the physical length of the interferometer and the difference between the modal group indices of involved waveguide modes. For the splicing type interferometer, only a single spatial frequency component was dominantly observed, while the collapsing type was associated with several components at a time. By analyzing the spatial frequency spectrum of the wavelength spectrum, the modal group index differences of the PCF were obtained from 2.83×10-3 to 4.65 ×10-3 . As potential applications of the all-PCF interferometer, strain sensing is experimentally demonstrated and ultra-high temperature sensing is proposed.

Miniature fiber-optic high temperature sensor based on a hybrid structured Fabry-Perot interferometer

Abstract: A miniature Fabry-Perot (FP) interferometric fiber-optic sensor suitable for high-temperature sensing is proposed and demonstrated. The sensor head consists of two FP cavities formed by fusion splicing a short hollow-core fiber and a piece of single-mode fiber at a photonic crystal fiber in series. The reflection spectra of an implemented sensor are measured at several temperatures and analyzed in the spatial frequency domain. The experiment shows that the thermal-optic effect of the cavity material is much more appreciable than its thermal expansion. The temperature measurements up to 1000 degrees C with a step of 50 degrees C confirm that it could be applicable as a high-temperature sensor.

Dependence of fringe spacing on the grating separation in a long-period fiber grating pair.

Abstract: The spectral spacing of the interference fringes formed by a pair of long-period fiber gratings was investigated. The variation of the fringe spacing was measured while the separation between the gratings was changed from 22 to 500 mm. When the grating separation was much longer than the length of the individual grating, the inverse of the fringe spacing became linearly proportional to the grating separation and to the differential effective group index of the fiber. In the third stop band of the grating pair, made along a dispersion-shifted fiber centered at 1.55 µm, the differential effective group index was calculated to be ∼6.4 × 10-3, which is approximately twice the differential effective index of the fiber. The discrepancy between the two indices was observed to decrease with the band order, a phenomenon that is explained by the first-order dispersion of the fiber. The measured interference fringes were not regularly spaced in the frequency domain, but regular spacing is required in wavelength-division multiplexing communication systems. Analysis of the second-order dispersion of the fiber and the grating-induced nonlinear phase shift within grating regions as the factors that induce chirping on the fringe spacing is presented.

Displacements of the resonant peaks of a long-period fiber grating induced by a change of ambient refractive index.

Abstract: We present a graphic method of analyzing the spectral displacements of a long-period fiber grating as a function of ambient index. Mode dependence of the maximum displacement, disappearance of a particular resonance peak, and spectral behavior when the ambient index is larger than that of the cladding material are investigated and compared with experimental results.

Measurement of intraocular distances by backscattering spectral interferometry

Abstract: The diffraction tomography theorem is adapted to one-dimensional length measurement. The resulting spectral interferometry technique is described and the first length measurements using this technique on a model eye and on a human eye in vivo are presented.

Hydrogen Sensors - A review

Abstract: Hydrogen sensors are of increasing importance in connection with the development and expanded use of hydrogen gas as an energy carrier and as a chemical reactant. There are an immense number of sensors reported in the literature for hydrogen detection and in this work these sensors are classified into eight different operating principles. Characteristic performance parameters of these sensor types, such as measuring range, sensitivity, selectivity and response time are reviewed and the latest technology developments are reported. Testing and validation of sensor performance are described in relation to standardisation and use in potentially explosive atmospheres so as to identify the requirements on hydrogen sensors for practical applications.

Optical fibre long-period grating sensors: characteristics and application

Abstract: Recent research on fibre optic long-period gratings (LPGs) is reviewed with emphasis placed upon the characteristics of LPGs that make them attractive for applications in sensing strain, temperature, bend radius and external index of refraction. The prospect of the development of multi-parameter sensors, capable of simultaneously monitoring a number of these measurands will be discussed.

Nested self-similar wrinkling patterns in skins.

Abstract: Stiff thin films on soft substrates are both ancient and commonplace in nature; for instance, animal skin comprises a stiff epidermis attached to a soft dermis. Although more recent and rare, artificial skins are increasingly used in a broad range of applications, including flexible electronics, tunable diffraction gratings, force spectroscopy in cells, modern metrology methods, and other devices. Here we show that model elastomeric artificial skins wrinkle in a hierarchical pattern consisting of self-similar buckles extending over five orders of magnitude in length scale, ranging from a few nanometres to a few millimetres. We provide a mechanism for the formation of this hierarchical wrinkling pattern, and quantify our experimental findings with both computations and a simple scaling theory. This allows us to harness the substrates for applications. In particular, we show how to use the multigeneration-wrinkled substrate for separating particles based on their size, while simultaneously forming linear chains of monodisperse particles.