Author
Ch. Comninellis
Bio: Ch. Comninellis is an academic researcher from École Polytechnique Fédérale de Lausanne. The author has contributed to research in topics: Catalysis & Cyclic voltammetry. The author has an hindex of 41, co-authored 112 publications receiving 8201 citations.
Topics: Catalysis, Cyclic voltammetry, Electrochemistry, Diamond, Electrolysis
Papers published on a yearly basis
Papers
More filters
••
TL;DR: In this paper, the electrogeneration of hydroxyl radicals was studied at a synthetic B-doped diamond (BDD) thin film electrode, where spin trapping was used for detection of hydoxyl radicals with 5,5-dimethyl-1-pyrroline-Noxide and with salicylic acid using ESR and liq. chromatog.
Abstract: The electrogeneration of hydroxyl radicals was studied at a synthetic B-doped diamond (BDD) thin film electrode. Spin trapping was used for detection of hydroxyl radicals with 5,5-dimethyl-1-pyrroline-N-oxide and with salicylic acid using ESR and liq. chromatog. measurements, resp. The prodn. of H2O2 and competitive oxidn. of formic and oxalic acids were also studied using bulk electrolysis. Oxidn. of salicylic acid gives hydroxylated products (2,3- and 2,5-dihydroxybenzoic acids). The oxidn. process on BDD electrodes involves hydroxyl radicals as electrogenerated intermediates. [on SciFinder (R)]
838 citations
••
TL;DR: In this article, the electrochemical oxidation of phenol for waste water treatment was studied at a platinum anode, and the reaction occurs by two parallel pathways; chemical oxidation with electrogenerated hydroxyl radicals and direct combustion of adsorbed phenol or/and its aromatic intermediates to CO2.
Abstract: The electrochemical oxidation of phenol for waste water treatment was studied at a platinum anode. Analysis of reaction intermediates and a carbon balance has shown that the reaction occurs by two parallel pathways; chemical oxidation with electrogenerated hydroxyl radicals and direct combustion of adsorbed phenol or/and its aromatic intermediates to CO2.
603 citations
••
TL;DR: In this paper, the electrochemical oxidation of phenol at synthetic boron-doped diamond thin film electrode (BDD) has been studied in acid media by cyclic voltammetry, chronoamperometry and bulk electrolysis.
507 citations
••
TL;DR: In this article, the electrochemical oxidation of phenol in the presence of NaCl for wastewater treatment was studied at Ti/SnO2 and Ti/IrO2 anodes.
Abstract: The electrochemical oxidation of phenol in the presence of NaCl for wastewater treatment was studied at Ti/SnO2 and Ti/IrO2 anodes. The experimental results have shown that the presence of NaCl catalyses the anodic oxidation of phenol only at Ti/IrO2 anodes due to the participation of electro-generated ClO− in the oxidation. Analysis of the oxidation products has shown that initially organo-chlorinated compounds are formed in the electrolyte which are further oxidized to volatile organics (CHCl3).
485 citations
••
TL;DR: In this article, the electrochemical oxidation of phenol for waste water treatment was studied on doped SnO2 anodes and it was shown that the main reaction is oxidation of the phenol to CO2.
Abstract: The electrochemical oxidation of phenol for waste water treatment was studied on doped SnO2 anodes. Analysis of reaction intermediates and a carbon balance has shown that the main reaction is oxidation of phenol to CO2. This unexpected behaviour of the SnO2 anode is explained by a change of the chemical structure of the electrode surface during anodic polarization.
458 citations
Cited by
More filters
••
TL;DR: A review of post-lithium-ion batteries is presented in this paper with a focus on their operating principles, advantages and the challenges that they face, and the volumetric energy density of each battery is examined using a commercial pouch-cell configuration.
Abstract: Energy density is the main property of rechargeable batteries that has driven the entire technology forward in past decades. Lithium-ion batteries (LIBs) now surpass other, previously competitive battery types (for example, lead–acid and nickel metal hydride) but still require extensive further improvement to, in particular, extend the operation hours of mobile IT devices and the driving mileages of all-electric vehicles. In this Review, we present a critical overview of a wide range of post-LIB materials and systems that could have a pivotal role in meeting such demands. We divide battery systems into two categories: near-term and long-term technologies. To provide a realistic and balanced perspective, we describe the operating principles and remaining issues of each post-LIB technology, and also evaluate these materials under commercial cell configurations. Post-lithium-ion batteries are reviewed with a focus on their operating principles, advantages and the challenges that they face. The volumetric energy density of each battery is examined using a commercial pouch-cell configuration to evaluate its practical significance and identify appropriate research directions.
3,314 citations
••
TL;DR: In this paper, a review of the electrochemical methods used at lab and pilot plant scale to decontaminate synthetic and real effluents containing dyes, considering the period from 2009 to 2013, as an update of our previous review up to 2008.
Abstract: As the environment preservation gradually becomes a matter of major social concern and more strict legislation is being imposed on effluent discharge, more effective processes are required to deal with non-readily biodegradable and toxic pollutants. Synthetic organic dyes in industrial effluents cannot be destroyed in conventional wastewater treatment and consequently, an urgent challenge is the development of new environmentally benign technologies able to mineralize completely these non-biodegradable compounds. This review aims to increase the knowledge on the electrochemical methods used at lab and pilot plant scale to decontaminate synthetic and real effluents containing dyes, considering the period from 2009 to 2013, as an update of our previous review up to 2008. Fundamentals and main applications of electrochemical advanced oxidation processes and the other electrochemical approaches are described. Typical methods such as electrocoagulation, electrochemical reduction, electrochemical oxidation and indirect electro-oxidation with active chlorine species are discussed. Recent advances on electrocatalysis related to the nature of anode material to generate strong heterogeneous OH as mediated oxidant of dyes in electrochemical oxidation are extensively examined. The fast destruction of dyestuffs mediated with electrogenerated active chlorine is analyzed. Electro-Fenton and photo-assisted electrochemical methods like photoelectrocatalysis and photoelectro-Fenton, which destroy dyes by heterogeneous OH and/or homogeneous OH produced in the solution bulk, are described. Current advantages of the exposition of effluents to sunlight in the emerging photo-assisted procedures of solar photoelectrocatalysis and solar photoelectro-Fenton are detailed. The characteristics of novel combined methods involving photocatalysis, adsorption, nanofiltration, microwaves and ultrasounds among others and the use of microbial fuel cells are finally discussed.
3,112 citations
••
Los Alamos National Laboratory1, University of Texas at Austin2, United States Department of Energy3, Argonne National Laboratory4, Oak Ridge National Laboratory5, Case Western Reserve University6, Virginia Tech7, Doshisha University8, University of Yamanashi9, Yokohama National University10, Kyoto University11, New Energy and Industrial Technology Development Organization12, Tokyo Institute of Technology13, National Institute of Advanced Industrial Science and Technology14
TL;DR: The research focuses on the durability of polymer electrolyte fuel cells (PEFCs), in particular, membrane degradation, and he has been involved in NEDO R&D research projects on PEFC durability since 2001.
Abstract: Rod Borup is a Team Leader in the fuel cell program at Los Alamos National Lab in Los Alamos, New Mexico. He received his B.S.E. in Chemical Engineering from the University of Iowa in 1988 and his Ph.D. from the University of Washington in 1993. He has worked on fuel cell technology since 1994, working in the areas of hydrogen production and PEM fuel cell stack components. He has been awarded 12 U.S. patents, authored over 40 papers related to fuel cell technology, and presented over 50 oral papers at national meetings. His current main research area is related to water transport in PEM fuel cells and PEM fuel cell durability. Recently, he was awarded the 2005 DOE Hydrogen Program R&D Award for the most significant R&D contribution of the year for his team's work in fuel cell durability and was the Principal Investigator for the 2004 Fuel Cell Seminar (San Antonio, TX, USA) Best Poster Award. Jeremy Meyers is an Assistant Professor of materials science and engineering and mechanical engineering at the University of Texas at Austin, where his research focuses on the development of electrochemical energy systems and materials. Prior to joining the faculty at Texas, Jeremy workedmore » as manager of the advanced transportation technology group at UTC Power, where he was responsible for developing new system designs and components for automotive PEM fuel cell power plants. While at UTC Power, Jeremy led several customer development projects and a DOE-sponsored investigation into novel catalysts and membranes for PEM fuel cells. Jeremy has coauthored several papers on key mechanisms of fuel cell degradation and is a co-inventor of several patents. In 2006, Jeremy and several colleagues received the George Mead Medal, UTC's highest award for engineering achievement, and he served as the co-chair of the Gordon Research Conference on fuel cells. Jeremy received his Ph.D. in Chemical Engineering from the University of California at Berkeley and holds a Bachelor's Degree in Chemical Engineering from Stanford University. Bryan Pivovar received his B.S. in Chemical Engineering from the University of Wisconsin in 1994. He completed his Ph.D. in Chemical Engineering at the University of Minnesota in 2000 under the direction of Profs. Ed Cussler and Bill Smyrl, studying transport properties in fuel cell electrolytes. He continued working in the area of polymer electrolyte fuel cells at Los Alamos National Laboratory as a post-doc (2000-2001), as a technical staff member (2001-2005), and in his current position as a team leader (2005-present). In this time, Bryan's research has expanded to include further aspects of fuel cell operation, including electrodes, subfreezing effects, alternative polymers, hydroxide conductors, fuel cell interfaces, impurities, water transport, and high-temperature membranes. Bryan has served at various levels in national and international conferences and workshops, including organizing a DOE sponsored workshop on freezing effects in fuel cells and an ARO sponsored workshop on alkaline membrane fuel cells, and he was co-chair of the 2007 Gordon Research Conference on Fuel Cells. Minoru Inaba is a Professor at the Department of Molecular Science and Technology, Faculty of Engineering, Doshisha University, Japan. He received his B.Sc. from the Faculty of Engineering, Kyoto University, in 1984 and his M.Sc. in 1986 and his Dr. Eng. in 1995 from the Graduate School of Engineering, Kyoto University. He has worked on electrochemical energy conversion systems including fuel cells and lithium-ion batteries at Kyoto University (1992-2002) and at Doshisha University (2002-present). His primary research interest is the durability of polymer electrolyte fuel cells (PEFCs), in particular, membrane degradation, and he has been involved in NEDO R&D research projects on PEFC durability since 2001. He has authored over 140 technical papers and 30 review articles. Kenichiro Ota is a Professor of the Chemical Energy Laboratory at the Graduate School of Engineering, Yokohama National University, Japan. He received his B.S.E. in Applied Chemistry from the University of Tokyo in 1968 and his Ph.D. from the University of Tokyo in 1973. He has worked on hydrogen energy and fuel cells since 1974, working on materials science for fuel cells and water electrolysis. He has published more than 150 original papers, 70 review papers, and 50 scientific books. He is now the president of the Hydrogen Energy Systems Society of Japan, the chairman of the Fuel Cell Research Group of the Electrochemical Society of Japan, and the chairman of the National Committee for the Standardization of the Stationary Fuel Cells. ABSTRACT TRUNCATED« less
2,921 citations
••
TL;DR: Electro-Fenton (EF) Process 6585 4.2.1.
Abstract: 2.2. Fenton’s Chemistry 6575 2.2.1. Origins 6575 2.2.2. Fenton Process 6575 2.3. Photo-Fenton Process 6577 3. H2O2 Electrogeneration for Water Treatment 6577 3.1. Fundamentals 6578 3.2. Cathode Materials 6579 3.3. Divided Cells 6580 3.4. Undivided Cells 6583 4. Electro-Fenton (EF) Process 6585 4.1. Origins 6585 4.2. Fundamentals of EF for Water Remediation 6586 4.2.1. Cell Configuration 6586 4.2.2. Cathodic Fe2+ Regeneration 6586 4.2.3. Anodic Generation of Heterogeneous Hydroxyl Radical 6587
2,652 citations
••
TL;DR: In this article, the development, design and applications of electrochemical technologies in water and wastewater treatment are reviewed with particular focus on electrodeposition, electrocoagulation, electroflotation (EF), and electrooxidation.
2,577 citations