Power dissipation is a fundamental problem for nanoelectronic circuits. Scaling the supply voltage reduces the energy needed for switching, but the field-effect transistors (FETs) in today's integrated circuits require at least 60 mV of gate voltage to increase the current by one order of magnitude at room temperature. Tunnel FETs avoid this limit by using quantum-mechanical band-to-band tunnelling, rather than thermal injection, to inject charge carriers into the device channel. Tunnel FETs based on ultrathin semiconducting films or nanowires could achieve a 100-fold power reduction over complementary metal-oxide-semiconductor (CMOS) transistors, so integrating tunnel FETs with CMOS technology could improve low-power integrated circuits.

Tunnel field-effect transistors as energy-efficient electronic switches

We have demonstrated a 70-nm n-channel tunneling field-effect transistor (TFET) which has a subthreshold swing (SS) of 52.8 mV/dec at room temperature. It is the first experimental result that shows a sub-60-mV/dec SS in the silicon-based TFETs. Based on simulation results, the gate oxide and silicon-on-insulator layer thicknesses were scaled down to 2 and 70 nm, respectively. However, the ON/ OFF current ratio of the TFET was still lower than that of the MOSFET. In order to increase the on current further, the following approaches can be considered: reduction of effective gate oxide thickness, increase in the steepness of the gradient of the source to channel doping profile, and utilization of a lower bandgap channel material

Tunneling Field-Effect Transistors (TFETs) With Subthreshold Swing (SS) Less Than 60 mV/dec

Steep subthreshold swing transistors based on interband tunneling are examined toward extending the performance of electronics systems. In particular, this review introduces and summarizes progress in the development of the tunnel field-effect transistors (TFETs) including its origin, current experimental and theoretical performance relative to the metal-oxide-semiconductor field-effect transistor (MOSFET), basic current-transport theory, design tradeoffs, and fundamental challenges. The promise of the TFET is in its ability to provide higher drive current than the MOSFET as supply voltages approach 0.1 V.

/pdf/low-voltage-tunnel-transistors-for-beyond-cmos-logic-3w5c8knrc5.pdf

Low-Voltage Tunnel Transistors for Beyond CMOS Logic

In this paper, we propose and validate a novel design for a double-gate tunnel field-effect transistor (DG tunnel FET), for which the simulations show significant improvements compared with single-gate devices using a gate dielectric. For the first time, DG tunnel FET devices, which are using a high-gate dielectric, are explored using realistic design parameters, showing an on-current as high as 0.23 mA for a gate voltage of 1.8 V, an off-current of less than 1 fA (neglecting gate leakage), an improved average subthreshold swing of 57 mV/dec, and a minimum point slope of 11 mV/dec. The 2D nature of tunnel FET current flow is studied, demonstrating that the current is not confined to a channel at the gate-dielectric surface. When varying temperature, tunnel FETs with a high-kappa gate dielectric have a smaller threshold voltage shift than those using SiO2, while the subthreshold slope for fixed values of Vg remains nearly unchanged, in contrast with the traditional MOSFET. Moreover, an Ion/Ioff ratio of more than 2 times 1011 is shown for simulated devices with a gate length (over the intrinsic region) of 50 nm, which indicates that the tunnel FET is a promising candidate to achieve better-than-ITRS low-standby-power switch performance.

https://www.silvaco.co.kr/tech_lib_TCAD/simulationstandard/2008/jan_feb_mar/a2/jan-feb-mar08_a2.pdf

Double-Gate Tunnel FET With High- $\kappa$ Gate Dielectric

A formula is derived, which shows that the subthreshold swing of field-effect interband tunnel transistors is not limited to 60 mV/dec as in the MOSFET. This formula is consistent with two recent reports of interband tunnel transistors, which show lower than 60-mV/dec subthreshold swings and provides two simple design principles for configuring these transistors. One of these principles suggests placing the gate adjacent to the tunnel junction. Modeling of this configuration verifies that sub-60-mV/dec swing is possible.

Low-subthreshold-swing tunnel transistors

The metal oxide semiconductor field effect transistor (MOSFET) is scaling to a “tunneling epoch”, in which multiple leakage current induced by different tunneling effects exist. The complementary Si-based tunneling transistors are presented in this paper. The working principle of this device is investigated in detail. It is found that the band-to-band tunneling current is be controlled by the gate-to-source voltage. Due to the reverse biased p-i-n diode structure, an ultra-low leakage current is achieved. The sub-threshold swing of TFET is not limited by kt/q, which is the physical limit of the MOSFET. Using the CMOS compatible processes, the complementary TFETs (CTFET) are fabricated on one wafer. From a circuit point of view, the compatibility between TFET and MOSFET enables the transfer of CMOS circuits to CTFET circuits.

Ch. Stepper

Papers

Complementary tunneling transistor for low power application