Chandresh H. Solanki

Bio: Chandresh H. Solanki is an academic researcher from Sardar Vallabhbhai National Institute of Technology, Surat. The author has contributed to research in topics: Geotextile & Settlement (structural). The author has an hindex of 8, co-authored 64 publications receiving 242 citations. Previous affiliations of Chandresh H. Solanki include Advanced Micro Devices.

Effect of Placement of Waste Tyre Fibres on Unconfined Compressive Strength of Clayey Soil

Abstract: This paper presents the laboratory investigation on compaction and unconfined compression behaviours of clayey soil reinforced with waste tyre fibres. In the present study, waste tyre fibres (WTF) were mixed with the soil at optimum mixing moisture content (OMMC). The fibre-reinforced soil (FRS) was then compacted at a maximum dry density (MDD) into a cylindrical mould in alternate layers of virgin and fibre-reinforced clayey soils. It was found that if the top and bottom layers are kept as virgin soil, then the specimen achieves a better strength as compared to other combinations. The strength of fibre-reinforced soil (FRS) was found to be two times higher than the virgin soil. This study demonstrates that the placement of fibres in alternate layers is useful in increasing the strength properties of soil.

3D FE Analysis of an Embankment Construction on GRSC and Proposal of a Design Method

Abstract: Stone column is often employed for strengthening of an embankment seated on deep soft clay. But in very soft clay having undrained shear strength less than or equal to 15 kPa, stone column may not derive adequate load carrying capacity and undergo large lateral deformation due to inadequate lateral confinement. In such circumstances, reinforcement to individual stone column by geosynthetics enhances load carrying capacity and reduces lateral deformation. This paper addresses parametric study on behaviour of embankment resting on Geosynthetic Reinforced Stone Column (GRSC) considering parameters such as stone column spacing to diameter ratio, deformation modulus of stone column material, geosynthetic stiffness, thickness of soft clay, and height of embankment by 3D numerical analysis. Finally, equation for Settlement Improvement Factor (SIF), defined as ratio between settlement of embankment without treatment and with geosynthetic reinforced stone column, is proposed that correlates with the major influence parameters such as stone column spacing to diameter ratio, deformation modulus of soft clay, and geosynthetic stiffness.

Stabilization/Solidification of Zinc- and Lead-Contaminated Soil Using Limestone Calcined Clay Cement (LC3): An Environmentally Friendly Alternative

Abstract: Due to increased carbon emissions, the use of low-carbon and low-cost cementitious materials that are sustainable and effective are gaining considerable attention recently for the stabilization/solidification (S/S) of contaminated soils. The current study presents the laboratory investigation of low-carbon/cost cementitious material known as limestone-calcined clay cement (LC3) for the potential S/S of Zn- and Pb-contaminated soils. The S/S performance of the LC3 binder on Zn- and Pb-contaminated soil was determined via pH, compressive strength, toxicity leaching, chemical speciation, and X-ray powder diffraction (XRPD) analyses. The results indicate that immobilization efficiency of Zn and Pb was solely dependent on the pH of the soil. In fact, with the increase in the pH values after 14 days, the compressive strength was increased to 2.5–3 times compared to untreated soil. The S/S efficiency was approximately 88% and 99%, with increase in the residual phases up to 67% and 58% for Zn and Pb, respectively, after 28 days of curing. The increase in the immobilization efficiency and strength was supported by the XRPD analysis in forming insoluble metals hydroxides such as zincwoodwardite, shannonite, portlandite, haturite, anorthite, ettringite (Aft), and calcite. Therefore, LC3 was shown to offer green and sustainable remediation of Zn- and Pb-contaminated soils, while the treated soil can also be used as safe and environmentally friendly construction material.

Fundamentals of earthquake engineering

Abstract: PART 1 DEALS WITH THE DYNAMIC ASPECTS OF THE SUBJECT: MATHEMATICAL ANALYSIS OF SYSTEMS SUBJECTED TO INDEPENDENT VIBRATIONS BY MEANS OF MATHEMATICAL MODELS. THE ANALYTICAL SYSTEMS USED ARE NON-LINEAR SYSTEMS, HYDRODYNAMICS AND NUMERICAL METHODS. PART 2 EXAMINES SEISMIC MOVEMENTS, THE DYNAMIC BEHAVIOUR OF STRUCTURES AND THE BASIC CONCEPTS OF THE SEISMIC DESIGN OF STRUCTURES.

Pile Foundation Analysis And Design

Abstract: Thank you very much for downloading pile foundation analysis and design. Maybe you have knowledge that, people have search numerous times for their favorite novels like this pile foundation analysis and design, but end up in infectious downloads. Rather than reading a good book with a cup of coffee in the afternoon, instead they juggled with some malicious bugs inside their laptop. pile foundation analysis and design is available in our digital library an online access to it is set as public so you can download it instantly. Our digital library spans in multiple locations, allowing you to get the most less latency time to download any of our books like this one. Kindly say, the pile foundation analysis and design is universally compatible with any devices to read.

Experimental and Numerical Analysis for Earth-Fill Dam Seepage

Abstract: Earth-fill dams are the most common types of dam and the most economical choice. However, they are more vulnerable to internal erosion and piping due to seepage problems that are the main causes of dam failure. In this study, the seepage through earth-fill dams was investigated using physical, mathematical, and numerical models. Results from the three methods revealed that both mathematical calculations using L. Casagrande solutions and the SEEP/W numerical model have a plotted seepage line compatible with the observed seepage line in the physical model. However, when the seepage flow intersected the downstream slope and when piping took place, the use of SEEP/W to calculate the flow rate became useless as it was unable to calculate the volume of water flow in pipes. This was revealed by the big difference in results between physical and numerical models in the first physical model, while the results were compatible in the second physical model when the seepage line stayed within the body of the dam and low compacted soil was adopted. Seepage analysis for seven different configurations of an earth-fill dam was conducted using the SEEP/W model at normal and maximum water levels to find the most appropriate configuration among them. The seven dam configurations consisted of four homogenous dams and three zoned dams. Seepage analysis revealed that if sufficient quantity of silty sand soil is available around the proposed dam location, a homogenous earth-fill dam with a medium drain length of 0.5 m thickness is the best design configuration. Otherwise, a zoned earth-fill dam with a central core and 1:0.5 Horizontal to Vertical ratio (H:V) is preferred.