Maximum power point tracking (MPPT) techniques are used in photovoltaic (PV) systems to maximize the PV array output power by tracking continuously the maximum power point (MPP) which depends on panels temperature and on irradiance conditions. The issue of MPPT has been addressed in different ways in the literature but, especially for low-cost implementations, the perturb and observe (PO moreover, it is well known that the P&O algorithm can be confused during those time intervals characterized by rapidly changing atmospheric conditions. In this paper it is shown that, in order to limit the negative effects associated to the above drawbacks, the P&O MPPT parameters must be customized to the dynamic behavior of the specific converter adopted. A theoretical analysis allowing the optimal choice of such parameters is also carried out. Results of experimental measurements are in agreement with the predictions of theoretical analysis.

/pdf/optimization-of-perturb-and-observe-maximum-power-point-z7a8beok09.pdf

Optimization of perturb and observe maximum power point tracking method

Asymptotic waveform evaluation (AWE) provides a generalized approach to linear RLC circuit response approximations. The RLC interconnect model may contain floating capacitors, grounded resistors, inductors, and even linear controlled sources. The transient portion of the response is approximated by matching the initial boundary conditions and the first 2q-1 moments of the exact response to a lower-order q-pole model. For the case of an RC tree model, a first-order AWE approximation reduces to the RC tree methods. >

Asymptotic waveform evaluation for timing analysis

The application of a hybrid two-port model to teleoperators with force and velocity sensing at the master and slave is presented. The interfaces between human operator and master, and between environment and slave, are ports through which the teleoperator is designed to exchange energy between the operator and the environment. By computing or measuring the input-output properties of this two-port network, the hybrid two-port model of an actual or simulated teleoperator system can be obtained. It is shown that the hybrid model (as opposed to other two-port forms) leads to an intuitive representation of ideal teleoperator performance and applies to several teleoperator architectures. Thus measured values of the h matrix or values computed from a simulation can be used to compare performance with the ideal. The frequency-dependent h matrix is computed from a detailed SPICE model of an actual system, and the method is applied to a proposed architecture. >

A design framework for teleoperators with kinesthetic feedback

A mesh analysis equation formulation technique combined with a multipole-accelerated Generalized Minimal Residual (GMRES) matrix solution algorithm is used to compute the 3-D frequency dependent inductances and resistances in nearly order n time and memory where n is the number of volume-filaments. The mathematical formulation and numerical solution are discussed, including two types of preconditioners for the GMRES algorithm. Results from examples are given to demonstrate that the multipole acceleration can reduce required computation time and memory by more than an order of magnitude for realistic integrated circuit packaging problems. >

FASTHENRY: a multipole-accelerated 3-D inductance extraction program

In [1], it was shown that an equation formulation based on mesh analysis can be combined with a GMRES-style iterative matrix solution technique to make a reasonably fast 3-D frequency dependent inductance and resistance extraction algorithm. Unfortunately, both the computation time and memory required for that approach grow faster than n/sup 2/, where n is the number of volume-filaments. In this paper, we show that it is possible to use multipole-acceleration to reduce both required memory and computation time to nearly order n. Results from examples are given to demonstrate that the multipole acceleration can reduce required computation time and memory by more than an order of magnitude for realistic packaging problems.

Charles A. Desoer

Papers

Basic circuit theory

Basic Circuit Theory: Chapters 1 through 10

Inter American University of Puerto Rico Bayamon Campus School of Engineering Department of Electrical Engineering