There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality.

Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

I and i

抗原变异可使得多种致病微生物易于逃避宿主免疫应答。表达在感染红细胞表面的恶性疟原虫红细胞表面蛋白1（PfPMP1）与感染红细胞、内皮细胞、树突状细胞以及胎盘的单个或多个受体作用，在黏附及免疫逃避中起关键的作用。每个单倍体基因组var基因家族编码约60种成员，通过启动转录不同的var基因变异体为抗原变异提供了分子基础。

疟原虫var基因转换速率变化导致抗原变异[英]／Paul H, Robert P, Christodoulou Z, et al//Proc Natl Acad Sci U S A

Many materials systems are currently under consideration as potential replacements for SiO2 as the gate dielectric material for sub-0.1 μm complementary metal–oxide–semiconductor (CMOS) technology. A systematic consideration of the required properties of gate dielectrics indicates that the key guidelines for selecting an alternative gate dielectric are (a) permittivity, band gap, and band alignment to silicon, (b) thermodynamic stability, (c) film morphology, (d) interface quality, (e) compatibility with the current or expected materials to be used in processing for CMOS devices, (f) process compatibility, and (g) reliability. Many dielectrics appear favorable in some of these areas, but very few materials are promising with respect to all of these guidelines. A review of current work and literature in the area of alternate gate dielectrics is given. Based on reported results and fundamental considerations, the pseudobinary materials systems offer large flexibility and show the most promise toward success...

/pdf/high-k-gate-dielectrics-current-status-and-materials-zjvba0c4u8.pdf

High-κ gate dielectrics: Current status and materials properties considerations

The CMOS technology area has quickly grown, calling for a new text--and here it is, covering the analysis and design of CMOS integrated circuits that practicing engineers need to master to succeed. Filled with many examples and chapter-ending problems, the book not only describes the thought process behind each circuit topology, but also considers the rationale behind each modification. The analysis and design techniques focus on CMOS circuits but also apply to other IC technologies.
Table of contents

1 Introduction to Analog Design
2 Basic MOS Device Physics
3 Single-Stage Amplifiers
4 Differential Amplifiers
5 Passive and Active Current Mirrors
6 Frequency Response of Amplifiers
7 Noise
8 Feedback
9 Operational Amplifiers
10 Stability and Frequency Compensation
11 Bandgap References
12 Introduction to Switched-Capacitor Circuits
13 Nonlinearity and Mismatch
14 Oscillators
15 Phase-Locked Loops
16 Short-Channel Effects and Device Models
17 CMOS Processing Technology
18 Layout and Packaging

/pdf/design-of-analog-cmos-integrated-circuits-35wxhwa3a6.pdf

Design of Analog CMOS Integrated Circuits

Nanocrystals (NCs) discussed in this Review are tiny crystals of metals, semiconductors, and magnetic material consisting of hundreds to a few thousand atoms each. Their size ranges from 2-3 to about 20 nm. What is special about this size regime that placed NCs among the hottest research topics of the last decades? The quantum mechanical coupling * To whom correspondence should be addressed. E-mail: dvtalapin@uchicago.edu. † The University of Chicago. ‡ Argonne National Lab. Chem. Rev. 2010, 110, 389–458 389

/pdf/prospects-of-colloidal-nanocrystals-for-electronic-and-3dxpyhl3r7.pdf

Prospects of Colloidal Nanocrystals for Electronic and Optoelectronic Applications

As the scaling of conventional planar CMOS is reaching its limits, multiple-gate CMOS structures will likely take up the baton. To facilitate circuit simulation in such advanced technologies, we have developed BSIM-MG: a versatile compact model for multi-gate MOSFETs. In this chapter separate formulations for common multi-gate and independent multi-gate MOSFETs are presented. The core I-V and C-V models are derived and agree well with TCAD simulations without using fitting parameters, reflecting the predictivity and scalability of the model. Physical effects such as volume inversion, short channel effects and quantum mechanical effects are included in the model. We verify BSIM-MG against triple-gate SOI FinFET experimental data. The model fits data very well across a wide range of biases, gate lengths and temperatures. It is also computationally efficient and suitable for simulating large circuits. Finally, several multi-gate circuit simulation examples are presented to demonstrate the use of the model.

Multi-Gate MOSFET Compact Model BSIM-MG

Role of electrode-induced oxygen vacancies in regulating polarization wake-up in ferroelectric capacitors

This work demonstrates that excess hot-carrier currents in SOI MOSFETs are caused by self-heating. Self-heating-free I/sub SUB/ data should be used for dynamic lifetime extrapolation due to long thermal time constant. The underlying mechanism, increased impact ionization with temperature at low drain bias, is studied experimentally from the angle of thermal activation energy. Our study indicates that the driving force of impact ionization transitions from the electric field to the lattice temperature with power-supply scaling below 1.2 V.

Excess hot-carrier currents in SOI MOSFETs and its implications

Impact of Polarization Relaxation on Ferroelectric Memory Performance

A novel dual-metal gate technology that uses a combination of Mo-MoSi/sub x/ gate electrodes is proposed. An amorphous-Si/Mo stack was fabricated as a gate electrode for the n-channel device. It was thermally annealed to form MoSi/sub x/. Pure Mo served as the gate electrode for the p-channel device. The work functions of MoSi/sub x/ and pure Mo gates on SiO/sub 2/ are 4.38 and 4.94 eV, respectively, which are appropriate for devices with advanced transistor structures. The small increase in the work function (< 20 meV) and the negligible equivalent oxide thickness variation (< 0.08 nm) after rapid thermal annealing at 950 /spl deg/C for 30 s also demonstrate the excellent thermal stabilities of Mo and MoSi/sub x/ on SiO/sub 2/. Additional arsenic ion implantation prior to silicidation was demonstrated further to lower the work function of MoSi/sub x/ to 4.07 eV. This approach for modulating the work function makes the proposed combination of Mo-MoSi/sub x/ gate electrodes appropriate for conventional bulk devices. The developed dual-metal-gate technology on HfO/sub 2/ gate dielectric was also evaluated. The effective work functions of pure Mo and undoped MoSi/sub x/ gates on HfO/sub 2/ are 4.89 and 4.34 eV, respectively. A considerable work-function shift was observed on the high-/spl kappa/ gate dielectric. The effect of arsenic preimplantation upon the work function of the metal silicide on HfO/sub 2/ was also demonstrated, even though the range of modulation was a little reduced.

https://ir.nctu.edu.tw:443/bitstream/11536/12182/1/000238154200018.pdf

Chenming Hu

Papers

Multi-Gate MOSFET Compact Model BSIM-MG

Role of electrode-induced oxygen vacancies in regulating polarization wake-up in ferroelectric capacitors

Excess hot-carrier currents in SOI MOSFETs and its implications

Impact of Polarization Relaxation on Ferroelectric Memory Performance

Novel dual-metal gate technology using Mo-MoSi/sub x/ combination