Chenming Hu

Bio: Chenming Hu is an academic researcher from University of California, Berkeley. The author has contributed to research in topics: MOSFET & Gate oxide. The author has an hindex of 119, co-authored 1296 publications receiving 57264 citations. Previous affiliations of Chenming Hu include Motorola & National Chiao Tung University.

A 128 K flash EEPROM using double-polysilicon technology

Abstract: An easily manufacturable 128 K flash EEPROM (electrically erasable programmable read-only memory) was developed based on a novel cell. Programming is achieved through hot-electron injection and erasing through electron tunneling from the floating gate to the drain. The cell is 20% larger than an EPROM cell and contains an integral series transistor which ensures selflimited erasing, reduces leakage, and increases the cell current. The flash EEPROM device can withstand thousands of program/erase cycles. Endurance failures are due to threshold window closing caused by electron trapping in the gate oxide. Typical erasure time is 1 s to clear the entire memory.

High-field transport of inversion-layer electrons and holes including velocity overshoot

Abstract: In this paper, we experimentally address the effect of a wide range of parameters on the high-field transport of inversion-layer electrons and holes. The studied parameters include substrate doping level, surface micro-roughness, vertical field strength, nitridation of the gate oxide, and device channel length. We employ special test structures built on Silicon-On-Insulator (SOI) and bulk wafers to accurately measure the high-field drift velocity of inversion-layer carriers. Our findings point to electron velocity overshoot at room temperature, dependence of electron and hole saturation velocities on nitridation of the gate oxide, dependence of the high-field drift velocity on the effective vertical field, and relative insensitivity of electron and hole mobility and saturation velocity to moderate surface roughness.

Impact of systematic spatial intra-chip gate length variability on performance of high-speed digital circuits

Abstract: Using data collected from an actual state-of-the-art fabrication facility, we conducted a comprehensive characterization of an advanced 0.18 /spl mu/m CMOS process. The measured data revealed significant systematic, rather than random, spatial intra-chip variability of MOS gate length, leading to large circuit path delay variation. The critical path value of a combinational logic block varies by as much as 17%, and the global skew is increased by 8%. Thus, a significant timing error (/spl sim/25%) and performance loss takes place if variability is not properly addressed. We derive a model, which allows estimating performance degradation for the given circuit and process parameters. Analysis shows that the spatial, rather than proximity-dependent, systematic Lgate variability is the main cause of large circuit speed degradation. The degradation is worse for the circuits with a larger number of critical paths and shorter average logic depth. We propose a location-dependent timing analysis methodology that allows to mitigate the detrimental effects of Lgate variability, and developed a tool linking the layout-dependent spatial information to circuit analysis. We discuss the details of the practical implementation of the methodology, and provide the guidelines for managing the design complexity.

IC reliability simulation

Abstract: The motivation and challenges of IC reliability simulation are discussed. The reliability simulator BERT is used to illustrate the physical models and approaches used to simulate the hot-electron effect, oxide time-dependent breakdown, electromigration, and bipolar transistor gain degradation. >

9nm half-pitch functional resistive memory cell with <1µA programming current using thermally oxidized sub-stoichiometric WO x film

Abstract: Record 9nm half-pitch functional Transition-Metal-Oxide based Resistive Random Access Memory (TMORRAM) cell and the lowest reported 1µA programming current (I prog , both Set and Reset) have been achieved with thermally oxidized sub-stoichiometric WO x and Nano Injection Lithography (NIL) technique [1]. The unexpectedly low programming current at 9nm diameter has been examined in-depth, it offers potential for scaling low power non-volatile memory. This small device shows Reset/Set resistance ratio around 10, stability during read operation, and good data-retention. A switching mechanism based on oxygen-ion dynamics can account for the observed device characteristics as discussed in this work.

I and i

Abstract: There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality. Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

疟原虫var基因转换速率变化导致抗原变异[英]／Paul H, Robert P, Christodoulou Z, et al//Proc Natl Acad Sci U S A

Abstract: 抗原变异可使得多种致病微生物易于逃避宿主免疫应答。表达在感染红细胞表面的恶性疟原虫红细胞表面蛋白1（PfPMP1）与感染红细胞、内皮细胞、树突状细胞以及胎盘的单个或多个受体作用，在黏附及免疫逃避中起关键的作用。每个单倍体基因组var基因家族编码约60种成员，通过启动转录不同的var基因变异体为抗原变异提供了分子基础。

High-κ gate dielectrics: Current status and materials properties considerations

Abstract: Many materials systems are currently under consideration as potential replacements for SiO2 as the gate dielectric material for sub-0.1 μm complementary metal–oxide–semiconductor (CMOS) technology. A systematic consideration of the required properties of gate dielectrics indicates that the key guidelines for selecting an alternative gate dielectric are (a) permittivity, band gap, and band alignment to silicon, (b) thermodynamic stability, (c) film morphology, (d) interface quality, (e) compatibility with the current or expected materials to be used in processing for CMOS devices, (f) process compatibility, and (g) reliability. Many dielectrics appear favorable in some of these areas, but very few materials are promising with respect to all of these guidelines. A review of current work and literature in the area of alternate gate dielectrics is given. Based on reported results and fundamental considerations, the pseudobinary materials systems offer large flexibility and show the most promise toward success...

Design of Analog CMOS Integrated Circuits

Abstract: The CMOS technology area has quickly grown, calling for a new text--and here it is, covering the analysis and design of CMOS integrated circuits that practicing engineers need to master to succeed. Filled with many examples and chapter-ending problems, the book not only describes the thought process behind each circuit topology, but also considers the rationale behind each modification. The analysis and design techniques focus on CMOS circuits but also apply to other IC technologies. Table of contents 1 Introduction to Analog Design 2 Basic MOS Device Physics 3 Single-Stage Amplifiers 4 Differential Amplifiers 5 Passive and Active Current Mirrors 6 Frequency Response of Amplifiers 7 Noise 8 Feedback 9 Operational Amplifiers 10 Stability and Frequency Compensation 11 Bandgap References 12 Introduction to Switched-Capacitor Circuits 13 Nonlinearity and Mismatch 14 Oscillators 15 Phase-Locked Loops 16 Short-Channel Effects and Device Models 17 CMOS Processing Technology 18 Layout and Packaging

Prospects of Colloidal Nanocrystals for Electronic and Optoelectronic Applications

Abstract: Nanocrystals (NCs) discussed in this Review are tiny crystals of metals, semiconductors, and magnetic material consisting of hundreds to a few thousand atoms each. Their size ranges from 2-3 to about 20 nm. What is special about this size regime that placed NCs among the hottest research topics of the last decades? The quantum mechanical coupling * To whom correspondence should be addressed. E-mail: dvtalapin@uchicago.edu. † The University of Chicago. ‡ Argonne National Lab. Chem. Rev. 2010, 110, 389–458 389