Chihaya Adachi

Bio: Chihaya Adachi is an academic researcher from Kyushu University. The author has contributed to research in topics: OLED & Electroluminescence. The author has an hindex of 112, co-authored 908 publications receiving 61403 citations. Previous affiliations of Chihaya Adachi include Ricoh & Universal Display Corporation.

Highly efficient organic light-emitting diodes from delayed fluorescence

Abstract: The inherent flexibility afforded by molecular design has accelerated the development of a wide variety of organic semiconductors over the past two decades. In particular, great advances have been made in the development of materials for organic light-emitting diodes (OLEDs), from early devices based on fluorescent molecules to those using phosphorescent molecules. In OLEDs, electrically injected charge carriers recombine to form singlet and triplet excitons in a 1:3 ratio; the use of phosphorescent metal-organic complexes exploits the normally non-radiative triplet excitons and so enhances the overall electroluminescence efficiency. Here we report a class of metal-free organic electroluminescent molecules in which the energy gap between the singlet and triplet excited states is minimized by design, thereby promoting highly efficient spin up-conversion from non-radiative triplet states to radiative singlet states while maintaining high radiative decay rates, of more than 10(6) decays per second. In other words, these molecules harness both singlet and triplet excitons for light emission through fluorescence decay channels, leading to an intrinsic fluorescence efficiency in excess of 90 per cent and a very high external electroluminescence efficiency, of more than 19 per cent, which is comparable to that achieved in high-efficiency phosphorescence-based OLEDs.

Nearly 100% internal phosphorescence efficiency in an organic light emitting device

Abstract: We demonstrate very high efficiency electrophosphorescence in organic light-emitting devices employing a phosphorescent molecule doped into a wide energy gap host. Using bis(2-phenylpyridine)iridium(III) acetylacetonate [(ppy)2Ir(acac)] doped into 3-phenyl-4(1′-naphthyl)-5-phenyl-1,2,4-triazole, a maximum external quantum efficiency of (19.0±1.0)% and luminous power efficiency of (60±5) lm/W are achieved. The calculated internal quantum efficiency of (87±7)% is supported by the observed absence of thermally activated nonradiative loss in the photoluminescent efficiency of (ppy)2Ir(acac). Thus, very high external quantum efficiencies are due to the nearly 100% internal phosphorescence efficiency of (ppy)2Ir(acac) coupled with balanced hole and electron injection, and triplet exciton confinement within the light-emitting layer.

Highly phosphorescent bis-cyclometalated iridium complexes: synthesis, photophysical characterization, and use in organic light emitting diodes.

Abstract: The synthesis and photophysical study of a family of cyclometalated iridium(III) complexes are reported. The iridium complexes have two cyclometalated (C∧N) ligands and a single monoanionic, bidentate ancillary ligand (LX), i.e., C∧N2Ir(LX). The C∧N ligands can be any of a wide variety of organometallic ligands. The LX ligands used for this study were all β-diketonates, with the major emphasis placed on acetylacetonate (acac) complexes. The majority of the C∧N2Ir(acac) complexes phosphoresce with high quantum efficiencies (solution quantum yields, 0.1−0.6), and microsecond lifetimes (e.g., 1−14 μs). The strongly allowed phosphorescence in these complexes is the result of significant spin−orbit coupling of the Ir center. The lowest energy (emissive) excited state in these C∧N2Ir(acac) complexes is a mixture of 3MLCT and 3(π−π*) states. By choosing the appropriate C∧N ligand, C∧N2Ir(acac) complexes can be prepared which emit in any color from green to red. Simple, systematic changes in the C∧N ligands, whic...

Efficient blue organic light-emitting diodes employing thermally activated delayed fluorescence

Abstract: Blue organic light-emitting diodes that harness thermally activated delayed fluorescence are realized with an external quantum efficiency of 19.5% and reduced roll-off at high luminance.

Transient analysis of organic electrophosphorescence. II. Transient analysis of triplet-triplet annihilation

Abstract: In the preceding paper, Paper I [Phys Rev B 62, 10 958 (2000)], we studied the formation and diffusion of excitons in several phosphorescent guest-host molecular organic systems In this paper, we demonstrate that the observed decrease in electrophosphorescent intensity in organic light-emitting devices at high current densities [M A Baldo et al, Nature 395, 151 (1998)] is principally due to triplet-triplet annihilation Using parameters extracted from transient phosphorescent decays, we model the quantum efficiency versus current characteristics of electrophosphorescent devices It is found that the increase in luminance observed for phosphors with short excited-state lifetimes is due primarily to reduced triplet-triplet annihilation We also derive an expression for a limiting current density ${(J}_{0})$ above which triplet-triplet annihilation dominates The expression for ${J}_{0}$ allows us to establish the criteria for identifying useful phosphors and to assist in the optimized design of electrophosphorescent molecules and device structures

I and i

Abstract: There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality. Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

Light-emitting diodes based on conjugated polymers

Abstract: CONJUGATED polymers are organic semiconductors, the semiconducting behaviour being associated with the π molecular orbitals delocalized along the polymer chain. Their main advantage over non-polymeric organic semiconductors is the possibility of processing the polymer to form useful and robust structures. The response of the system to electronic excitation is nonlinear—the injection of an electron and a hole on the conjugated chain can lead to a self-localized excited state which can then decay radiatively, suggesting the possibility of using these materials in electroluminescent devices. We demonstrate here that poly(p-phenylene vinylene), prepared by way of a solution-processable precursor, can be used as the active element in a large-area light-emitting diode. The combination of good structural properties of this polymer, its ease of fabrication, and light emission in the green–yellow part of the spectrum with reasonably high efficiency, suggest that the polymer can be used for the development of large-area light-emitting displays.

Aggregation-Induced Emission: Together We Shine, United We Soar!

Abstract: Ju Mei,†,‡,∥ Nelson L. C. Leung,†,‡,∥ Ryan T. K. Kwok,†,‡ Jacky W. Y. Lam,†,‡ and Ben Zhong Tang*,†,‡,§ †HKUST-Shenzhen Research Institute, Hi-Tech Park, Nanshan, Shenzhen 518057, China ‡Department of Chemistry, HKUST Jockey Club Institute for Advanced Study, Institute of Molecular Functional Materials, Division of Biomedical Engineering, State Key Laboratory of Molecular Neuroscience, Division of Life Science, The Hong Kong University of Science and Technology, Clear Water Bay, Kowloon, Hong Kong, China Guangdong Innovative Research Team, SCUT-HKUST Joint Research Laboratory, State Key Laboratory of Luminescent Materials and Devices, South China University of Technology, Guangzhou 510640, China

Electroluminescence in conjugated polymers

Abstract: Research in the use of organic polymers as the active semiconductors in light-emitting diodes has advanced rapidly, and prototype devices now meet realistic specifications for applications. These achievements have provided insight into many aspects of the background science, from design and synthesis of materials, through materials fabrication issues, to the semiconductor physics of these polymers.