D
D.N. Sah
Researcher at Bhabha Atomic Research Centre
Publications - 8
Citations - 89
D.N. Sah is an academic researcher from Bhabha Atomic Research Centre. The author has contributed to research in topics: Burnup & Post Irradiation Examination. The author has an hindex of 5, co-authored 8 publications receiving 73 citations.
Papers
More filters
Journal ArticleDOI
Influence of temperature on threshold stress for reorientation of hydrides and residual stress variation across thickness of Zr-2.5Nb alloy pressure tube
TL;DR: In this paper, the threshold stress, σth, for reorientation of hydrides in cold worked and stress-relieved (CWSR) Zr 2.5Nb pressure tube material was determined in the temperature range of 523-673 K.
Journal ArticleDOI
Post irradiation examination of thermal reactor fuels
TL;DR: The post irradiation examination (PIE) facility at the Bhabha Atomic Research Centre (BARC) has been in operation for more than three decades and has been utilized for examination of experimental fuel pins and fuels from commercial power reactors operating in India as mentioned in this paper.
Journal ArticleDOI
Measurement of fission gas release, internal pressure and cladding creep rate in the fuel pins of PHWR bundle of normal discharge burnup
TL;DR: In this article, the internal gas pressure in the outer fuel pin was measured to be 0.55 ± 0.05 MPa at room temperature and the increase in diameter of the fuel pin after heat treatment was measured after 10min.
Journal ArticleDOI
Blind prediction exercise on modeling of PHWR fuel at extended burnup
TL;DR: A blind prediction exercise on Indian Pressurised Heavy Water Reactor (PHWR) fuel to investigate the predictive capability of existing codes for their application at extended burnup and to identify areas of improvement was organised in this paper.
Journal ArticleDOI
Behaviour of irradiated PHWR fuel pins during high temperature heating
TL;DR: In this paper, fuel pins removed from an irradiated pressurised heavy water reactor (PHWR) fuel bundle discharged after an extended burn up of 15,000MWd/tU have been subjected to isothermal heating tests in temperature range 700-1300°C inside hot-cells.