Author
Daisuke Adachi
Bio: Daisuke Adachi is an academic researcher from Kaneka Corporation. The author has contributed to research in topics: Solar cell & Layer (electronics). The author has an hindex of 14, co-authored 47 publications receiving 2506 citations.
Papers
More filters
••
TL;DR: In this paper, a silicon heterojunction with interdigitated back contacts was presented, achieving an efficiency of 26.3% and a detailed loss analysis to guide further developments.
Abstract: The efficiency of silicon solar cells has a large influence on the cost of most photovoltaics panels. Here, researchers from Kaneka present a silicon heterojunction with interdigitated back contacts reaching an efficiency of 26.3% and provide a detailed loss analysis to guide further developments.
2,052 citations
••
TL;DR: In this paper, a heterojunction interdigitated back contact solar cell with conversion efficiency of 26.6% was developed, which was independently confirmed by Fraunhofer Institute for Solar Energysystem Callab.
394 citations
••
TL;DR: In this article, the effective minority carrier lifetime (τe) of a large area (151.9 cm2) HJ c-Si solar cell with amorphous Si (a-Si) passivation layer was investigated from the point of view of effective minority lifetime and the impact of τe on fill factor.
Abstract: We have achieved a certified 25.1% conversion efficiency in a large area (151.9 cm2) heterojunction (HJ) crystalline Si (c-Si) solar cell with amorphous Si (a-Si) passivation layer. This efficiency is a world record in a both-side-contacted c-Si solar cell. Our high efficiency HJ c-Si solar cells are investigated from the standpoint of the effective minority carrier lifetime (τe), and the impact of τe on fill factor (FF) is discussed. The τe measurements of our high efficiency HJ c-Si solar cells reveal that τe at an injection level corresponding to an operation point of maximum power is dominated by the carrier recombination at the a-Si/c-Si interface. By optimization of the process conditions, the carrier recombination at the a-Si/c-Si interface is reduced, which leads to an improvement of the FF by an absolute value of 2.7%, and a conversion efficiency of 25.1% has been achieved. These results indicate that the reduction of carrier recombination centers at the a-Si/c-Si interface should be one of the m...
350 citations
••
TL;DR: In this paper, the authors proposed a two-terminal tandem structure with a heterojunction c-Si solar cell and a perovskite solar cell, which achieved record-breaking conversion efficiencies of 26.7% for cells and 24.5% for modules.
Abstract: High-efficiency back-contact heterojunction crystalline Si (c-Si) solar cells with record-breaking conversion efficiencies of 26.7% for cells and 24.5% for modules are reported. The importance of thin-film Si solar cell technology for heterojunction c-Si solar cells with amorphous Si passivation layers in improving conversion efficiency and reducing production cost is demonstrated. Our attempts to reduce the production cost of a heterojunction c-Si solar cell by applying a SiO x layer prepared by a plasma-enhanced CVD method are presented. The characteristics of heterojunction c-Si solar cells are clarified by comparing them with those of practical homojunction solar cells, and crucial targets for industrialization of back-contact heterojunction c-Si solar cells are discussed. Owing to the recent improvement of c-Si solar cells and perovskite solar cells, conversion efficiencies over 30% have become a realistic target by using a two-terminal tandem structure with a heterojunction c-Si solar cell and a perovskite solar cell.
113 citations
••
TL;DR: In this paper, structural and luminescence properties of nanostructured (NS-) ZnS:Mn which has potential applications in thin-film electroluminescence (TFEL) devices were studied.
Abstract: We have studied structural and luminescence properties of nanostructured (NS-) ZnS:Mn which has potential applications in thin-film electroluminescence (TFEL) devices. As a NS-ZnS:Mn system, a ZnS:Mn/Si3N4 multilayer having thicknesses of 2.5 nm for ZnS and 0.6 nm for Si3N4 was prepared by a conventional rf-magnetron sputtering method. Grazing incidence x-ray reflectometry and x-ray diffractometry show that ZnS:Mn nanocrystals were formed between the amorphous Si3N4 layers. Photoluminescence intensity associated with the Mn2+ transitions per total thickness of the ZnS:Mn layers is increased in NS-ZnS:Mn in comparison with that of the ZnS:Mn thin film, indicating the effects due to quantum confinement. The TFEL device with NS-ZnS:Mn as an emission layer exhibits a reddish-orange broad band emission with the maximum luminance of 2.8 cd/m2 under the 1-kHz sinusoidal wave operation at a voltage of 20.5 V0−p.
47 citations
Cited by
More filters
••
TL;DR: In this paper, an organic halide salt phenethylammonium iodide (PEAI) was used on HC(NH2)2-CH3NH3 mixed perovskite films for surface defect passivation.
Abstract: In recent years, the power conversion efficiency of perovskite solar cells has increased to reach over 20%. Finding an effective means of defect passivation is thought to be a promising route for bringing further increases in the power conversion efficiency and the open-circuit voltage (VOC) of perovskite solar cells. Here, we report the use of an organic halide salt phenethylammonium iodide (PEAI) on HC(NH2)2–CH3NH3 mixed perovskite films for surface defect passivation. We find that PEAI can form on the perovskite surface and results in higher-efficiency cells by reducing the defects and suppressing non-radiative recombination. As a result, planar perovskite solar cells with a certificated efficiency of 23.32% (quasi-steady state) are obtained. In addition, a VOC as high as 1.18 V is achieved at the absorption threshold of 1.53 eV, which is 94.4% of the Shockley–Queisser limit VOC (1.25 V). Planar perovskite solar cells that have been passivated using the organic halide salt phenethylammonium iodide are shown to have suppressed non-radiative recombination and operate with a certified power conversion efficiency of 23.3%.
3,064 citations
••
TL;DR: In this article, a semi-empirical model analysis and using the tandem cell strategy to overcome the low charge mobility of organic materials, leading to a limit on the active-layer thickness and efficient light absorption was performed.
Abstract: Although organic photovoltaic (OPV) cells have many advantages, their performance still lags far behind that of other photovoltaic platforms. A fundamental reason for their low performance is the low charge mobility of organic materials, leading to a limit on the active-layer thickness and efficient light absorption. In this work, guided by a semi-empirical model analysis and using the tandem cell strategy to overcome such issues, and taking advantage of the high diversity and easily tunable band structure of organic materials, a record and certified 17.29% power conversion efficiency for a two-terminal monolithic solution-processed tandem OPV is achieved.
2,165 citations
••
TL;DR: In this paper, a silicon heterojunction with interdigitated back contacts was presented, achieving an efficiency of 26.3% and a detailed loss analysis to guide further developments.
Abstract: The efficiency of silicon solar cells has a large influence on the cost of most photovoltaics panels. Here, researchers from Kaneka present a silicon heterojunction with interdigitated back contacts reaching an efficiency of 26.3% and provide a detailed loss analysis to guide further developments.
2,052 citations
••
TL;DR: Because photocurrents are near the theoretical maximum, the focus is on efforts to increase open-circuit voltage by means of improving charge-selective contacts and charge carrier lifetimes in perovskites via processes such as ion tailoring.
Abstract: The efficiencies of perovskite solar cells have gone from single digits to a certified 22.1% in a few years' time. At this stage of their development, the key issues concern how to achieve further improvements in efficiency and long-term stability. We review recent developments in the quest to improve the current state of the art. Because photocurrents are near the theoretical maximum, our focus is on efforts to increase open-circuit voltage by means of improving charge-selective contacts and charge carrier lifetimes in perovskites via processes such as ion tailoring. The challenges associated with long-term perovskite solar cell device stability include the role of testing protocols, ionic movement affecting performance metrics over extended periods of time, and determination of the best ways to counteract degradation mechanisms.
1,371 citations
••
TL;DR: In this paper, a comprehensive review of the state-of-the-art research activities related to ZnS nanostructures is provided, with the focus on the critical experiments determining the electrical, chemical and physical parameters of the nanostructure, and the interplay between synthetic conditions and nanoscale morphologies.
1,090 citations