Deyi Pi

Bio: Deyi Pi is an academic researcher from Broadcom. The author has contributed to research in topics: CMOS & Chipset. The author has an hindex of 8, co-authored 14 publications receiving 293 citations. Previous affiliations of Deyi Pi include University of California, Irvine.

A 500 mW ADC-Based CMOS AFE With Digital Calibration for 10 Gb/s Serial Links Over KR-Backplane and Multimode Fiber

Abstract: This paper presents the design of an analog-front-end (AFE) integrated into a DSP-based transceiver for both serial 10 Gbps KR-backplane and long-reach-multimode-fiber (LRM) applications. The receiver consists of a programmable gain amplifier (PGA) and a 6-bit 4-way time-interleaved ADC, which is digitally calibrated to compensate for the offset, gain and phase mismatches between the interleaved channels. With a 5 GHz input signal, the ADC achieves overall SNDR of 29 dB, while the measured SNDR of flash sub-ADC is 31.6 dB. The power efficiency FoM of the complete interleaved ADC is 1.4 pJ per conversion step. The PLL uses a calibrated LC-VCO and the TX features a full-rate 3-tap de-emphasis at the output. Inductively tuned buffers connected in tandem are employed to distribute the 10 GHz clock. Random and deterministic jitter measured at the TX output are 0.38 psrms and 2.65 pspp, respectively. Implemented in 65 nm CMOS technology, the AFE occupies an area of 3 mm2 and consumes 500 mW from a 1 V supply. BER of less than 10-15 is measured over legacy backplanes with 26 dB loss at Nyquist and the measured transceiver optical sensitivity is less than -13 dBm for all four LRM stressors, exceeding both the KR and the LRM specifications.

21.7 A 500mW digitally calibrated AFE in 65nm CMOS for 10Gb/s Serial links over backplane and multimode fiber

Abstract: The demand for bandwidth has fueled the deployment of 10Gb/s traffic over legacy data links such as serial backplanes (10GBase-KR) and multimode fiber (10GBase-MMF) which were originally intended for much lower data rates [1,2]. Under severe channel impairments, a DSP-based transceiver provides robust performance and enables power/area scaling with processes [3–5]. This work describes a 65nm CMOS AFE integrated in a DSP-based PHY for 10Gb/s KR/MMF applications.

A Sub-2 W 39.8–44.6 Gb/s Transmitter and Receiver Chipset With SFI-5.2 Interface in 40 nm CMOS

Abstract: A 39.8-44.6 Gb/s transmitter and receiver chipset designed in 40 nm CMOS is presented. The line-side TX implements a 2-tap FIR filter with delay-based pre-emphasis. The line-side RX uses a quarter-rate CDR architecture. The TX output shows 0.9 pspp ISI and 0.2 psrms RJ at 0.87 W. The RX achieves a jitter tolerance of 0.6 UIpp at 100 MHz and an input sensitivity of 20 mV pp\mathchar"702D diff at 1.05 W. The combined transmitter/receiver equalization enables 44.6 Gb/s data transmission using 231-1 PRBS at BER 10-12 over a channel with >21 dB loss at Nyquist frequency.

A CMOS Code-Modulated Path-Sharing Multi-Antenna Receiver Front-End

Abstract: This paper presents the design and implementation of a novel multi-antenna receiver front-end, which is capable of accommodating various multi-antenna schemes including spatial multiplexing (SM), spatial diversity (SD), and beamforming (BF). The use of orthogonal code-modulation at the RF stage of multi-antenna signal paths enables linear combination of all mutually orthogonal code-modulated RF received signals. The combined signal is then fed to a single RF/baseband/ADC chain. In the digital domain, all antenna signals are fully recovered using matched filters. Primary advantages of this architecture include a significant reduction in area and power consumption. Moreover, the path-sharing of multiple RF signals mitigates the issues of LO routing/distribution and cross-talk between receive chains. System-level analyses of variable gain/dynamic range, bandwidth/area/power trade-off, and interferers are presented. Designed for the 5-GHz frequency and fabricated in 0.18 mum CMOS, the 76 mW 2.3 mm2 two-antenna receiver front-end prototype achieves a 10-2 symbol error rate (SER) at 64, 77, and 78 dBm of input power for SM, SD, and BF, respectively, while providing 21-85 dB gain, 6.2 dB NF, and 10.6 dBm IIP3.

Theoretical Analysis of Novel Multi-Order LC Oscillators

Abstract: A conventional differential pair LC oscillator is capable of generating only a single fundamental oscillation frequency. This brief presents the theoretical study of a novel oscillator that incorporates higher order LC filters to produce multiple oscillation frequencies that may be several octaves apart. These multiple oscillation frequencies are obtained from a single oscillator, thereby reducing the area of the circuit when being used for multistandard wireless applications. Moreover, a multi-order oscillator does not suffer from large parasitic capacitances from switches, which is a common drawback in switched-inductor tuned oscillators. A detailed analysis is carried out, and useful design insights are provided

State of the Art in 60-GHz Integrated Circuits and Systems for Wireless Communications

Abstract: This tutorial presents an overview of the technological advances in millimeter-wave (mm-wave) circuit components, antennas, and propagation that will soon allow 60-GHz transceivers to provide multigigabit per second (multi-Gb/s) wireless communication data transfers in the consumer marketplace. Our goal is to help engineers understand the convergence of communications, circuits, and antennas, as the emerging world of subterahertz and terahertz wireless communications will require understanding at the intersections of these areas. This paper covers trends and recent accomplishments in a wide range of circuits and systems topics that must be understood to create massively broadband wireless communication systems of the future. In this paper, we present some evolving applications of massively broadband wireless communications, and use tables and graphs to show research progress from the literature on various radio system components, including on-chip and in-package antennas, radio-frequency (RF) power amplifiers (PAs), low-noise amplifiers (LNAs), voltage-controlled oscillators (VCOs), mixers, and analog-to-digital converters (ADCs). We focus primarily on silicon-based technologies, as these provide the best means of implementing very low-cost, highly integrated 60-GHz mm-wave circuits. In addition, the paper illuminates characterization techniques that are required to competently design and fabricate mm-wave devices in silicon, and illustrates effects of the 60-GHz RF propagation channel for both in-building and outdoor use. The paper concludes with an overview of the standardization and commercialization efforts for 60-GHz multi-Gb/s devices, and presents a novel way to compare the data rate versus power efficiency for future broadband devices.

Millimeter-wave massive MIMO: the next wireless revolution?

Abstract: The combination of millimeter-wave communications, arrays with a massive number of antennas, and small cell geometries is a symbiotic convergence of technologies that has the potential to dramatically improve wireless access and throughput. This article outlines the benefits, challenges, and potential solutions associated with cellular networks that incorporate these technologies.

The Design of CMOS Radio-Frequency Integrated Circuits

Abstract: The Design Of Cmos Radio Frequency Integrated Circuits Solution Manual *FREE* the design of cmos radio frequency integrated circuits solution manual 4. RESISTA N CE . RESISTORS AND RESISTOR CIRCUITS Resistance is the op position to current flow in various degrees. The practical unit of resistance is called the ohm. A resistor on one ohm is physically very large but provides only a small resistance to current flow.The Design Of Cmos Radio Frequency Integrated Circuits the design of cmos radio frequency integrated circuits solution manual The Design Of Cmos Radio Frequency Integrated Circuits Solution Manual The Design Of Cmos Radio Frequency Integrated Circuits Solution Manual FREE the design of cmos radio frequency integrated circuits solution manual 4 RESISTA N CE Read The Design Of Cmos Radio Frequency Integrated Free Download Books The Design Of Cmos Radio Frequency Integrated Circuits Solution Manual You know that reading The Design Of Cmos Radio Frequency Integrated Circuits Solution Manual is beneficial because we are able to get a lot of information in the reading materials The design of cmos radio frequency integrated circuits Download The design of cmos radio frequency integrated circuits solution manual in EPUB Format In the website you will find a large variety of ePub PDF Kindle AudioBook and books Such as manual user assist The design of cmos radio frequency integrated circuits solution manual ePub comparison suggestions and The Design Of CMOS Radio Frequency Integrated Circuits The Design of CMOS Radio Frequency Integrated Circuits Solutions Manual Solutions Manuals are available for thousands of the most popular college and high school textbooks in subjects such as Math Science Physics Chemistry Biology Engineering Mechanical Electrical Civil Business and more The Design of CMOS Radio Frequency Integrated Circuits The Design of CMOS Radio Frequency Integrated Circuits Second Edition The last chapter will provide a trip down memory lane for some readers—a sampling of circuits of particular interest in RF history including the Regency TR 1 transistor radio design and the three transistor cicuit that created the first toy walkie talkie in 1962 PDF The Design of CMOS Radio Frequency Integrated PDF Student Solutions Manual Chapters 1 11 for Stewarts Single Variable Calculus Early Transcendentals 7th By James Stewart P D F PDF The Beginning Questions to Dr Malachi Z York El About By Malachi Z York El pdf PDF The Design of CMOS Radio Frequency Integrated PDF The Design of CMOS Radio Frequency Integrated Circuits Second Edition 2 DESCRIPTION This expanded and thoroughly revised edition of Thomas H Lee s acclaimed guide to the design of gigahertz RF integrated circuits features a completely new chapter on the principles of wireless systems The Design of CMOS Radio Frequency Integrated Circuits Chapter 2 Basic MOS Device Physics In studying the design of integrated circuits one of two extreme approaches can b Design of Analog CMOS Integrated Circuits Chap 3 I X1 X2 Single Stage Amplifiers Figure 3 1 Input output characteristic of a nonlinear system The Design of CMOS Radio Frequency Integrated Circuits The Design of CMOS Radio Frequency Integrated Circuits Second Edition Thomas H Lee on Amazon com FREE shipping on qualifying offers This expanded and thoroughly revised edition of Thomas H Lee s acclaimed guide to the design of gigahertz RF integrated circuits features a completely new chapter on the principles of wireless systems The chapters on low noise amplifiers The Design of CMOS Radio Frequency Integrated Circuits by The Design of CMOS Radio Frequency

The Design of CMOS Radio-Frequency Integrated Circuits: RF CIRCUITS THROUGH THE AGES

Abstract: This expanded and thoroughly revised edition of Thomas H. Lee's acclaimed guide to the design of gigahertz RF integrated circuits features a completely new chapter on the principles of wireless systems. The chapters on low-noise amplifiers, oscillators and phase noise have been significantly expanded as well. The chapter on architectures now contains several examples of complete chip designs that bring together all the various theoretical and practical elements involved in producing a prototype chip. First Edition Hb (1998): 0-521-63061-4 First Edition Pb (1998); 0-521-63922-0

使用《Basic circuit Theory》进行教学的初步体会

Abstract: 为了适应科学技术的飞速发展,为了迅速改变我国科学技术的现状,我们必须以现代科学技术水平为起点,来组织我们的教学工作,培养出适应当前科学技术发展要求的科学技术人材。否则我们就始终只能跟在人家的后面,一步一步地爬行。从这个角度来看,我院领导正确地决定了电工基础课程采用University of California,Berkeley(伯克莱加大)Charles A.Desor and Ernest S.Kuh 所著《Basic Cirouif Theory》教材是非常适时的。