[신간의 별자리x] 우리/미술, 그리고 ‘슬픔의 박물관’

Thermophysical Properties Research Literature Retrieval Guide Edited by Y. S. Touloukian, J. K. Gerritsen and N. Y. Moore Second edition, revised and expanded. Book 1: Pp. xxi + 819. Book 2: Pp.621. Book 3: Pp. ix + 1315. (New York: Plenum Press, 1967.) n.p.

/pdf/heat-and-mass-transfer-1yaijfx8vp.pdf

Heat and Mass Transfer

To improve the performance of particle image velocimetry in measuring instantaneous velocity fields, direct cross-correlation of image fields can be used in place of auto-correlation methods of interrogation of double- or multiple-exposure recordings. With improved speed of photographic recording and increased resolution of video array detectors, cross-correlation methods of interrogation of successive single-exposure frames can be used to measure the separation of pairs of particle images between successive frames. By knowing the extent of image shifting used in a multiple-exposure and by a priori knowledge of the mean flow-field, the cross-correlation of different sized interrogation spots with known separation can be optimized in terms of spatial resolution, detection rate, accuracy and reliability.

Theory of cross-correlation analysis of PIV images : Image analysis as measuring technique in flows

Rare earth elements recovery using staged precipitation from a leachate generated from coarse coal refuse

The main physicochemical coefficients of the components and of the tested coal–water slurry containing petrochemicals (CWSP) have been collected. The viscosity, mixture stability, density, ash content, humidity, flash and ignition temperatures, and enthalpy of combustion of the tested CWSP are reported. The temperatures of combustion of fuel compositions with different concentrations of solid and liquid components have been measured, as well as the important parameters: the ignition time delays of droplets (radius 0.25–2.5 mm) and the times required to reach their complete burning. The study allows determination of the optimal fuel compositions yielding the shortest ignition time delays, the longest times to complete burning, the highest temperatures of combustion, and the maximum enthalpy of combustion. It is found that the viscosity of CWSP is dependent almost proportionally on the moisture content of components. It is shown that the calorific value of CWSP is dependent proportionally on the calorific v...

Burning Properties of Slurry Based on Coal and Oil Processing Waste

The study results of ignition of organic coal-water fuel (OCWF) compositions were considered. The main problems associated with investigation of these processes were identified. Historical perspectives of the development of coal-water composite fuel technologies in Russia and worldwide are presented. The advantages of the OCWF use as a power-plant fuel in comparison with the common coal-water fuels (CWF) were emphasized. The factors (component ratio, grinding degree of solid (coal) component, limiting temperature of oxidizer, properties of liquid and solid components, procedure and time of suspension preparation, etc.) affecting inertia and stability of the ignition processes of suspensions based on the products of coaland oil processing (coals of various types and metamorphism degree, filter cakes, waste motor, transformer, and turbine oils, water-oil emulsions, fuel-oil, etc.) were analyzed. The promising directions for the development of modern notions on the OCWF ignition processes were determined. The main reasons limiting active application of the OCWF in power generation were identified. Characteristics of ignition and combustion of coal-water and organic coal-water slurry fuels were compared. The effect of water in the composite coal fuels on the energy characteristics of their ignition and combustion, as well as ecological features of these processes, were elucidated. The current problems associated with pulverization of composite coal fuels in power plants, as well as the effect of characteristics of the pulverization process on the combustion parameters of fuel, were considered. The problems hindering the development of models of ignition and combustion of OCWF were analyzed. It was established that the main one was the lack of reliable experimental data on the processes of heating, evaporation, ignition, and combustion of OCWF droplets. It was concluded that the use of high-speed video recording systems and low-inertia sensors of temperature and gas concentration could help in providing the lacking experimental information.

Dmitrii O. Glushkov

Papers

Burning Properties of Slurry Based on Coal and Oil Processing Waste

Organic coal-water fuel: Problems and advances (Review)

Ignition of promising coal-water slurry containing petrochemicals: Analysis of key aspects

Influence of organic coal-water fuel composition on the characteristics of sustainable droplet ignition

Minimum temperatures for sustainable ignition of coal water slurry containing petrochemicals