Elisabetta Comini

Bio: Elisabetta Comini is an academic researcher from University of Brescia. The author has contributed to research in topics: Nanowire & Thin film. The author has an hindex of 61, co-authored 443 publications receiving 15102 citations. Previous affiliations of Elisabetta Comini include University of Valladolid & University of Pisa.

Stable and highly sensitive gas sensors based on semiconducting oxide nanobelts

Abstract: Gas sensors have been fabricated using the single-crystalline SnO2 nanobelts. Electrical characterization showed that the contacts were ohmic and the nanobelts were sensitive to environmental polluting species like CO and NO2, as well as to ethanol for breath analyzers and food control applications. The sensor response, defined as the relative variation in conductance due to the introduction of the gas, is 4160% for 250 ppm of ethanol and −1550% for 0.5 ppm NO2 at 400 °C. The results demonstrate the potential of fabricating nanosized sensors using the integrity of a single nanobelt with a sensitivity at the level of a few ppb.

Ultrasensitive and highly selective gas sensors using three-dimensional tungsten oxide nanowire networks

Abstract: The performance of a solid-state gas sensor is characterized by its sensitivity, stability, and selectivity. The working principle relies on modulation of electrical conductivity due to surface oxidation reduction caused by gas exposure. Because only the surface layer is affected by such reactions, the sensitivity is strongly dependent on the surface-to-volume ratio of the material used. This purpose has been pursued by synthesizing layers with a porous morphology to enhance the material surface area. Porosity is enhanced by means of the thick film synthesis approach typically adopted in the gas sensing field. Such high porosity is not easy to achieve by thin film approach. Another approach largely used in the field is the rheotaxial growth and its thermal oxidation RGTO method, which allows synthesizing a porous thin film mono

TiO2 thin films by a novel sol–gel processing for gas sensor applications

Abstract: Novel thin films of titanium dioxide dispersed in a polymeric matrix have been prepared by a chemically modified sol–gel technique. Nanostructured films of pure TiO2 in the anatase form are obtained after annealing at 500°C. SEM, TEM and TG/DTA are used for the structure characterisation of TiO2 films. The role of the polymer in controlling the microstructure is confirmed. The first application of this technique in gas sensor field is presented in this work. Ethanol and methanol sensing properties are tested and reported. TiO2 sensors can detect very well concentration required for breath analysers.

I and i

Abstract: There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality. Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

Zinc oxide nanostructures: growth, properties and applications

Abstract: Zinc oxide is a unique material that exhibits semiconducting and piezoelectric dual properties. Using a solid–vapour phase thermal sublimation technique, nanocombs, nanorings, nanohelixes/nanosprings, nanobelts, nanowires and nanocages of ZnO have been synthesized under specific growth conditions. These unique nanostructures unambiguously demonstrate that ZnO probably has the richest family of nanostructures among all materials, both in structures and in properties. The nanostructures could have novel applications in optoelectronics, sensors, transducers and biomedical sciences. This article reviews the various nanostructures of ZnO grown by the solid–vapour phase technique and their corresponding growth mechanisms. The application of ZnO nanobelts as nanosensors, nanocantilevers, field effect transistors and nanoresonators is demonstrated.

A review on the visible light active titanium dioxide photocatalysts for environmental applications

Abstract: Fujishima and Honda (1972) demonstrated the potential of titanium dioxide (TiO2) semiconductor materials to split water into hydrogen and oxygen in a photo-electrochemical cell. Their work triggered the development of semiconductor photocatalysis for a wide range of environmental and energy applications. One of the most significant scientific and commercial advances to date has been the development of visible light active (VLA) TiO2 photocatalytic materials. In this review, a background on TiO2 structure, properties and electronic properties in photocatalysis is presented. The development of different strategies to modify TiO2 for the utilization of visible light, including non metal and/or metal doping, dye sensitization and coupling semiconductors are discussed. Emphasis is given to the origin of visible light absorption and the reactive oxygen species generated, deduced by physicochemical and photoelectrochemical methods. Various applications of VLA TiO2, in terms of environmental remediation and in particular water treatment, disinfection and air purification, are illustrated. Comprehensive studies on the photocatalytic degradation of contaminants of emerging concern, including endocrine disrupting compounds, pharmaceuticals, pesticides, cyanotoxins and volatile organic compounds, with VLA TiO2 are discussed and compared to conventional UV-activated TiO2 nanomaterials. Recent advances in bacterial disinfection using VLA TiO2 are also reviewed. Issues concerning test protocols for real visible light activity and photocatalytic efficiencies with different light sources have been highlighted.