Eric Magi

Bio: Eric Magi is an academic researcher from University of Sydney. The author has contributed to research in topics: Optical fiber & Photonic crystal. The author has an hindex of 31, co-authored 146 publications receiving 3162 citations. Previous affiliations of Eric Magi include Salisbury University & Centre for Ultrahigh Bandwidth Devices for Optical Systems.

Low-threshold supercontinuum generation in highly nonlinear chalcogenide nanowires

Abstract: We demonstrate low-threshold supercontinuum generated in a highly nonlinear arsenic selenide chalcogenide nanowire with tailored dispersion. The tapered submicrometer chalcogenide fiber exhibits an ultrahigh nonlinearity, n2~1.1×10−17m2/W and an effective mode area of 0.48 μm2, yielding an effective nonlinearity of γ~93.4W/m, which is over 80,000 times larger than standard silica single-mode fiber at a wavelength of ~1550nm. This high nonlinearity, in conjunction with the engineered anomalous dispersion, enables low-threshold soliton fission leading to large spectral broadening at a dramatically reduced peak power of several watts, corresponding to picojoule energy.

Enhanced Kerr nonlinearity in sub-wavelength diameter As2Se3 chalcogenide fiber tapers

Abstract: We experimentally demonstrate enhanced Kerr nonlinear effects in highly nonlinear As2Se3 chalcogenide fiber tapered down to subwavelength waist diameter of 1.2 µm. Based on self phase modulation measurements, we infer an enhanced nonlinearity of 68 W-1m-1. This is 62,000 times larger than in standard silica singlemode fiber, owing to the 500 times larger n2 and almost 125 times smaller effective mode area. We also consider the potential to exploit the modified dispersion in these tapers for ultra-low threshold supercontinuum generation.

Applications of Highly-Nonlinear Chalcogenide Glass Devices Tailored for High-Speed All-Optical Signal Processing

Abstract: Ultrahigh nonlinear tapered fiber and planar rib Chalcogenide waveguides have been developed to enable highspeed all-optical signal processing in compact, low-loss optical devices through the use of four-wave mixing (FWM) and cross-phase modulation (XPM) via the ultra fast Kerr effect. Tapering a commercial As2Se3 fiber is shown to reduce its effective core area and enhance the Kerr nonlinearity thereby enabling XPM wavelength conversion of a 40 Gb/s signal in a shorter 16-cm length device that allows a broader wavelength tuning range due to its smaller net chromatic dispersion. Progress toward photonic chip-scale devices is shown by fabricating As2S3 planar rib waveguides exhibiting nonlinearity up to 2080 W-1ldr km-1 and losses as low as 0.05 dB/cm. The material's high refractive index, ensuring more robust confinement of the optical mode, permits a more compact serpentine-shaped rib waveguide of 22.5 cm length on a 7-cm- size chip, which is successfully applied to broadband wavelength conversion of 40-80 Gb/s signals by XPM. A shorter 5-cm length planar waveguide proves most effective for all-optical time-division demultiplexing of a 160 Gb/s signal by FWM and analysis shows its length is near optimum for maximizing FWM in consideration of its dispersion and loss.

Low propagation loss silicon-on-sapphire waveguides for the mid-infrared

Abstract: This work was supported by the Australian Research Council (ARC) Centres of Excellence program and the ARC Federation Fellows program.

Microstructured optical fiber photonic wires with subwavelength core diameter

Abstract: We demonstrate fabrication of robust, low-loss silica photonic wires using tapered microstructured silica optical fiber. The fiber is tapered by a factor of fifty while retaining the internal structure and leaving the air holes completely open. The air holes isolate the core mode from the surrounding environment, making it insensitive to surface contamination and contact leakage, suggesting applications as nanowires for photonic circuits. We describe a transition between two different operation regimes of our photonic wire from the embedded regime, where the mode is isolated from the environment, to the evanescent regime, where more than 70% of the mode intensity can propagate outside of the fiber. Interesting dispersion and nonlinear properties are identified.

I and i

Abstract: There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality. Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

Supercontinuum generation in photonic crystal fiber

Abstract: A topical review of numerical and experimental studies of supercontinuum generation in photonic crystal fiber is presented over the full range of experimentally reported parameters, from the femtosecond to the continuous-wave regime. Results from numerical simulations are used to discuss the temporal and spectral characteristics of the supercontinuum, and to interpret the physics of the underlying spectral broadening processes. Particular attention is given to the case of supercontinuum generation seeded by femtosecond pulses in the anomalous group velocity dispersion regime of photonic crystal fiber, where the processes of soliton fission, stimulated Raman scattering, and dispersive wave generation are reviewed in detail. The corresponding intensity and phase stability properties of the supercontinuum spectra generated under different conditions are also discussed.

Developing optofluidic technology through the fusion of microfluidics and optics

Abstract: We describe devices in which optics and fluidics are used synergistically to synthesize novel functionalities. Fluidic replacement or modification leads to reconfigurable optical systems, whereas the implementation of optics through the microfluidic toolkit gives highly compact and integrated devices. We categorize optofluidics according to three broad categories of interactions: fluid–solid interfaces, purely fluidic interfaces and colloidal suspensions. We describe examples of optofluidic devices in each category.

Mid-infrared frequency combs

Abstract: This Review discusses the emerging field of mid-infrared frequency comb generation, including technologies based on novel laser gain media, nonlinear frequency conversion and microresonators, as well as the applications of these combs in precision spectroscopy and direct frequency comb spectroscopy. Laser frequency combs are coherent light sources that emit a broad spectrum of discrete, evenly spaced narrow lines whose absolute frequency can be measured to within the accuracy of an atomic clock. Their development in the near-infrared and visible domains has revolutionized frequency metrology while also providing numerous unexpected opportunities in other fields such as astronomy and attosecond science. Researchers are now exploring how to extend frequency comb techniques to the mid-infrared spectral region. Versatile mid-infrared frequency comb generators based on novel laser gain media, nonlinear frequency conversion or microresonators promise to significantly expand the applications of frequency combs. In particular, novel approaches to molecular spectroscopy in the 'fingerprint region', with dramatically improved precision, sensitivity, recording time and/or spectral bandwidth may lead to new discoveries in the various fields relevant to molecular science.

Nonlinear silicon photonics

Abstract: The nonlinearities in silicon are diverse. This Review covers the wealth of nonlinear effects in silicon and highlights the important applications and technological solutions in nonlinear silicon photonics. The increasing capability for manufacturing a wide variety of optoelectronic devices from polymer and polymer–silicon hybrids, including transmission fibre, modulators, detectors and light sources, suggests that organic photonics has a promising future in communications and other applications.