This paper is the second part of the two-part review article presenting an overview of mechanics of pipes conveying fluid and related problems such as the fluid-elastic instability under conditions of turbulence in nuclear power plants. In the first part, different types of modeling, dynamic analysis and stability regimes of pipes conveying fluid restrained by elastic or inelastic barriers were described. The dynamic and stability behaviors of pinnedpinned, clamped-clamped, and cantilevered pipes conveying fluid together with curved and articulated pipes were discussed. Other problems such as pipes made of viscoelastic materials and active control of severe pipe vibrations were considered. The first part was closed by conclusions highlighting resolved and nonresolved controversies reported in the literature. The second part will address the problem of fluidelastic instability in single- and twophase flows and fretting wear in process equipment, such as heat exchangers and steam generators. Connors critical velocity will be discussed as a measure of initiating fluidelastic instability. Vibro-impact of heat exchanger tubes and the random excitation by the cross-flow can produce a progressive damage at the supports through fretting wear or fatigue. Antivibration bar supports used to limit pipe vibrations are described. An assessment of analytical, numerical, and experimental techniques of fretting-wear problem of pipes in heat exchangers will be given. Other topics related to this part include remote impact analysis and parameter identification, pipe damage-induced by pressure elastic waves, the dynamic response and stability of long pipes, marine risers together with pipes aspirating fluid, and carbon nanotubes conveying fluid. DOI: 10.1115/1.4001270

Mechanics of Pipes Conveying Fluids—Part II: Applications and Fluidelastic Problems

Fluidelastic Instability Modeling of Loosely Supported Multispan U-Tubes in Nuclear Steam Generators

Damping-controlled fluidelastic instability forces in multi-span tubes with loose supports

Analysis of flow-induced vibration of steam generator tubes subjected to cross flow

The effect of grid generated turbulence on the fluidelastic instability response in parallel triangular tube array

Tube arrays exposed to air, gas or liquid cross-flow can vibrate due to vortex-shedding, turbulence, or fluidelastic instability. The major emphasis of this paper is on the phenomenon of fluidelastic instability (or fluidelastic vibration). A numerical model is applied to the simulation of fluidelastic vibration of representative tubes in a tube bundle, based on S. S. Chen's unsteady flow theory. The results are validated against published data based on linear cases. The model is then applied to a nonlinear structure of a U-bend tube bundle with clearances at supports, and the computed results compared to those obtained by experimental testing. The numerical studies were performed using the ABAQUS-EPGEN finite element code using a special subroutine incorporating fluidelastic forces. It is shown that the results of both the linear and nonlinear modeling are in good agreement with experimental data.

F. L. Eisinger

Papers

Numerical Simulation of Cross-Flow-Induced Fluidelastic Vibration of Tube Arrays and Comparison With Experimental Results