scispace - formally typeset
Search or ask a question
Author

Francesca Cecchet

Bio: Francesca Cecchet is an academic researcher from Université de Namur. The author has contributed to research in topics: Monolayer & Plasmon. The author has an hindex of 20, co-authored 47 publications receiving 967 citations. Previous affiliations of Francesca Cecchet include Université catholique de Louvain & University of Bologna.

Papers
More filters
Journal ArticleDOI
TL;DR: The analysis of the catalytic current generated at the GOx/SAM electrode in the presence of glucose and FcMeOH allowed the high surface protein coverage suggested by X-ray photoelectron spectroscopy (XPS) measurements to be confirmed.
Abstract: Cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS), and digital simulation techniques were used to investigate quantitatively the mechanism of electron transfer (ET) through densely packed and well-ordered self-assembled monolayers (SAMs) of 11-mercaptoundecanoic acid on gold, either pristine or modified by physically adsorbed glucose oxidase (GOx) In the presence of ferrocenylmethanol (FcMeOH) as a redox mediator, ET kinetics involving either solution-phase hydrophilic redox probes such as [Fe(CN)6]3-/4- or surface-immobilized GOx is greatly accelerated: [Fe(CN)6]3-/4- undergoes diffusion-controlled ET, while the enzymatic electrochemical conversion of glucose to gluconolactone is efficiently sustained by FcMeOH Analysis of the results, also including the digital simulation of CV and EIS data, showed the prevalence of an ET mechanism according to the so-called membrane model that comprises the permeation of the redox mediator within the SAM and the intermolecular ET to the redox probe located outside the monolayer The analysis of the catalytic current generated at the GOx/SAM electrode in the presence of glucose and FcMeOH allowed the high surface protein coverage suggested by X-ray photoelectron spectroscopy (XPS) measurements to be confirmed

73 citations

Journal ArticleDOI
TL;DR: Atomic force microscopy has been proposed as a promising complementary method for the characterisation of EVs and compared air and liquid modes for EVs’ size and number determination as potential biomarkers of the prothrombotic risk.
Abstract: Introduction : Extracellular vesicles (EVs) are shed from cells and carry markers of the parent cells. Vesicles derived from cancer cells reach the bloodstream and locally influence important physiological processes. It has been previously shown that procoagulant vesicles are circulating in patients’ fluids. These EVs are therefore considered as promising biomarkers for the thrombotic risk. Because of their small size, classical methods such as flow cytometry suffer from limitation for their characterisation. Atomic force microscopy (AFM) has been proposed as a promising complementary method for the characterisation of EVs. Objectives : The objectives of this study are: (a) to develop and validate AFM with specific antibodies (anti-TF) and (b) to compare air and liquid modes for EVs’ size and number determination as potential biomarkers of the prothrombotic risk. Methods : AFM multimode nanoscope III was used for air tapping mode (TM). AFM catalyst was used for liquid Peak Force Tapping (PFT) mode. Vesicles are generated according to Davila et al.'s protocol. Substrates are coated with various concentrations of antibodies, thanks to ethanolamine and glutaraldehyde. Results : Vesicles were immobilised on antibody-coated surfaces to select tissue factor (TF)-positive vesicles. The size range of vesicles observed in liquid PFT mode is 6–10 times higher than in air mode. This corresponds to the data found in the literature. Conclusion : We recommend liquid PFT mode to analyse vesicles on 5 µg/ml antibody-coated substrates. Keywords: extracellular vesicles; tissue factor; atomic force microscopy; coagulation; biomarker (Published: 27 August 2013) Citation: Journal of Extracellular Vesicles 2013, 2 : 21045 - http://dx.doi.org/10.3402/jev.v2i0.21045 To access the supplementary material to this article, please see Supplementary files under Article Tools online.

70 citations

Journal ArticleDOI
06 Jan 2006-Langmuir
TL;DR: Two routes for creating protein adsorption-resistant self-assembled monolayers (SAMs) by chemical modification of silicon surfaces with poly(ethylene oxide) (PEO) oligomeric derivatives are compared.
Abstract: We compare two routes for creating protein adsorption-resistant self-assembled monolayers (SAMs) by chemical modification of silicon surfaces with poly(ethylene oxide) (PEO) oligomeric derivatives. The first route involves the assembly of 2-methyl[(polyethyleneoxy)propyl]trichlorosilane (Cl3SiMPEO) films onto oxidized silicon surfaces (OH-SiO(x)) either by a liquid-phase process at room temperature or by a gas-phase process at 423 K, producing Si-O-Si bonds between the substrate and the organic layer. The second pathway makes use of the assembly of poly(ethylene glycol methyl ether) (MPEG) films onto hydrogen-passivated silicon surfaces (H-Si) using a liquid-phase process at 353 or 423 K, leading to the formation of Si-O-C bonds between the substrate and the organic layer. Structural investigation by X-ray reflectometry (XRR) reveals that the thickness and surface densities of the grafted PEO monolayers strongly depend on experimental conditions such as temperature and grafting time. Atomic force microscopy (AFM) shows that very smooth and homogeneous monolayers can be obtained with average roughnesses close to those measured on the corresponding bare substrates. Finally, the antifouling properties of the modified silicon surfaces were evaluated by X-ray photoelectron spectroscopy (XPS), using a membrane protein (P.69 antigen) as model protein. Both types of PEO monolayers exhibit excellent protein repellency, as soon as the grafting density is equal to or higher than 1.7 chains/nm2.

67 citations

Journal ArticleDOI
TL;DR: In this article, a complex parallel ECE mechanism is proposed, comprising the loss of the SCN ligands in their pristine (anionic) form, which is initiated by the metal-centered oxidation process.
Abstract: The redox properties of cis-[Ru(dcbpyH2)2(NCS)2] ([Ru(dcbpyH2)2(NCS)2]; dcbpyH2 = 2,2‘-bipyridine- 4,4‘-dicarboxylic acid) have been investigated in various solvents by combining electrochemical techniques (cyclic voltammetry (CV) and spectroelectrochemistry), mass spectrometry, digital simulation techniques, and semiempirical quantum chemical calculations. The electrochemical study has shown that while in polar solvents such as acetonitrile and ethanol the complex undergoes, following oxidation, the rapid loss of SCN ligands, forming the corresponding solvato complexes. In the less polar solvent tetrahydrofuran, a reversible oxidative CV behavior is observed at relatively low scan rates. On the basis of the CV and spectroelectrochemical studies and supported by quantum chemical calculations, a complex parallel ECE mechanism is proposed, comprising the loss of the SCN ligands in their pristine (anionic) form, which is initiated by the metal-centered oxidation process.

59 citations

Journal ArticleDOI
TL;DR: In this article, an electrochemical polymerization fac-[Re(v-bpy)(CO)3Cl] was applied to a nanocrystalline TiO2 film on glass and the properties of such heterogeneous catalyst in the electrochemical reduction of CO2 were investigated.

57 citations


Cited by
More filters
Journal ArticleDOI
TL;DR: The computed alignments of the molecular orbitals of the different complexes with the band edges of a model TiO(2) nanoparticle provide additional insights into the electronic factors governing the efficiency of dye-sensitized solar cell devices.
Abstract: We report a combined experimental and computational study of several ruthenium(II) sensitizers originated from the [Ru(dcbpyH2)2(NCS)2], N3, and [Ru(dcbpyH2)(tdbpy)(NCS)2], N621, (dcbpyH2 = 4,4‘-dicarboxy-2,2‘-bipyridine, tdbpy = 4,4‘-tridecyl-2,2‘-bipyridine) complexes. A purification procedure was developed to obtain pure N-bonded isomers of both types of sensitizers. The photovoltaic data of the purified N3 and N621 sensitizers adsorbed on TiO2 films in their monoprotonated and diprotonated state, exhibited remarkable power conversion efficiency at 1 sun, 11.18 and 9.57%, respectively. An extensive Density Functional Theory (DFT)−Time Dependent DFT study of these sensitizers in solution was performed, investigating the effect of protonation of the terminal carboxylic groups and of the counterions on the electronic structure and optical properties of the dyes. The calculated absorption spectra are in good agreement with the experiment, thus allowing a detailed assignment of the UV−vis spectral features ...

2,660 citations

Journal ArticleDOI
TL;DR: The challenges in achieving highly active and stable CO2 reduction electrocatalysts are analyzed, and several research directions for practical applications are proposed, with the aim of mitigating performance degradation, overcoming additional challenges, and facilitating research and development in this area.
Abstract: This paper reviews recent progress made in identifying electrocatalysts for carbon dioxide (CO2) reduction to produce low-carbon fuels, including CO, HCOOH/HCOO−, CH2O, CH4, H2C2O4/HC2O4−, C2H4, CH3OH, CH3CH2OH and others. The electrocatalysts are classified into several categories, including metals, metal alloys, metal oxides, metal complexes, polymers/clusters, enzymes and organic molecules. The catalyts' activity, product selectivity, Faradaic efficiency, catalytic stability and reduction mechanisms during CO2 electroreduction have received detailed treatment. In particular, we review the effects of electrode potential, solution–electrolyte type and composition, temperature, pressure, and other conditions on these catalyst properties. The challenges in achieving highly active and stable CO2 reduction electrocatalysts are analyzed, and several research directions for practical applications are proposed, with the aim of mitigating performance degradation, overcoming additional challenges, and facilitating research and development in this area.

2,205 citations

Journal ArticleDOI
TL;DR: This review extensively discusses the multifunctional bio-applications of AgNPs; for example, as antibacterial, antifungal, antiviral,Anti-inflammatory, anti-angiogenic, and anti-cancer agents, and the mechanism of the anti- cancer activity of Ag NPs.
Abstract: Recent advances in nanoscience and nanotechnology radically changed the way we diagnose, treat, and prevent various diseases in all aspects of human life. Silver nanoparticles (AgNPs) are one of the most vital and fascinating nanomaterials among several metallic nanoparticles that are involved in biomedical applications. AgNPs play an important role in nanoscience and nanotechnology, particularly in nanomedicine. Although several noble metals have been used for various purposes, AgNPs have been focused on potential applications in cancer diagnosis and therapy. In this review, we discuss the synthesis of AgNPs using physical, chemical, and biological methods. We also discuss the properties of AgNPs and methods for their characterization. More importantly, we extensively discuss the multifunctional bio-applications of AgNPs; for example, as antibacterial, antifungal, antiviral, anti-inflammatory, anti-angiogenic, and anti-cancer agents, and the mechanism of the anti-cancer activity of AgNPs. In addition, we discuss therapeutic approaches and challenges for cancer therapy using AgNPs. Finally, we conclude by discussing the future perspective of AgNPs.

1,720 citations

Journal ArticleDOI
TL;DR: This chapter should acquaint the reader with the fundamentals of the electrochemistry of glucose and provide a perspective of the evolution of the Electrochemical glucose assays and monitors helping diabetic people, who constitute about 5 % of the world’s population.
Abstract: Over 7,000 peer reviewed articles have been published on electrochemical glucose assays and sensors over recent years. Their number makes a full review of the literature, or even of the most recent advances, impossible. Nevertheless, this chapter should acquaint the reader with the fundamentals of the electrochemistry of glucose and provide a perspective of the evolution of the electrochemical glucose assays and monitors helping diabetic people, who constitute about 5 % of the world’s population. Because of the large number of diabetic people, no assay is performed more frequently than that of glucose. Most of these assays are electrochemical. The reader interested also in nonelectrochemical assays used in, or proposed for, the management of diabetes is referred to a 2007 excellent review of Kondepati and Heise [1].

1,353 citations