Frank S. Stone

Bio: Frank S. Stone is an academic researcher from University of Bath. The author has contributed to research in topics: Adsorption & Catalysis. The author has an hindex of 20, co-authored 56 publications receiving 1513 citations. Previous affiliations of Frank S. Stone include Sapienza University of Rome & Keele University.

Reflectance spectra of surface states in magnesium oxide and calcium oxide

Abstract: The ultraviolet and visible reflectance spectra (52 000–15 000 cm–1) of high surface area MgO (250–300 m2 g–1) and CaO (100–200 m2 g–1) have been studied in vacuo and in the presence of O2, N2O, CO2 and H2O. The effect of outgassing MgO and CaO at increasing temperatures (773–1073 K) is to develop u.v. absorption bands in the range 30 000–50 000 cm–1. The absorption can be progressively destroyed by chemisorption, and also by sintering. The bands are attributed to excitons bound in surface states. In vacuo the outgassed oxides exhibit a fluorescence which is readily quenched by exposure to a low pressure of oxygen. Absorption bands occur at 37 000 and 46 000 cm–1 for MgO and at 35 500 and 44 500 cm–1 for CaO. With each oxide the chemisorption of gases erodes the lower energy band preferentially, and a similar effect occurs on sintering. The two bands are ascribed to exciton absorption at surface oxide ions in different states of coordinative unsaturation, the lower energy exciton band corresponding to the lower coordination.The influence of gases on the exciton spectra of outgassed MgO and CaO is shown to depend on their chemical reactivity, increasing in the sequence O2, N2O, CO2 and H2O. The effects with each gas are reversible on outgassing. Exposure of CaO to O2 gives rise to an absorption band at 23 500 cm–1, tentatively attributed to an O–3 adsorbed species.The surface states observed on CaO can be produced on MgO by adsorbing Ca ions from solution and heating to 1073 K.

An experimental and theoretical evaluation of surface states in MgO and other alkaline earth oxides

Abstract: Ultra-violet (u.v.) diffuse reflectance spectra of microcrystalline MgO, CaO, SrO and BaO reveal bands at energies below those of bulk excitonic transitions. Correlation of the spectra permit three distinctive absorptions (I, II, III) to be identified, each with similar characteristics in the respective oxides. The absorptions are ascribed to surface states, and the transitions have the characteristics of excitons. Excitons II and III obey the Mollwo–Ivey relation typical of bound excitons, but excition I with the highest energy of transition behaves similarly to a free exciton of the bulk. The four oxides are isostructural and ionic. The Levine–Mark theory of the surface states of ionic insulators, not hitherto tested for oxides, is examined. The numerical values of the parameters appropriate to the oxides are evaluated by using experimental data on bulk excitons. It is shown that the theory accounts satisfactorily for the energies of exciton I in MgO, CaO and SrO on the basis that it is an exci...

Copper–zinc oxide catalysts. Activity in relation to precursor structure and morphology

Abstract: Cu–Zn hydroxycarbonates have been studied as precursors of Cu–ZnO catalysts, with particular reference to the effect on catalyst activity of ageing the precursor prior to decomposition and reduction. The precursor obtained by precipitation from mixed nitrate solution (Cu/Zn molar ratio 2:1) at 333 K and pH 7.0 consisted of zincian malachite (Cu/Zn ≈ 85:15) and aurichalcite. The precursor was aged in the mother liquor at 333 K for various times. Characterisation by XRD, i.r., DTA, electron microscopy, EDAX and XPS showed that ageing led to loss of the aurichalcite and production of a more finely divided copper-enriched (Cu/Zn = 2:1) malachite phase. The unaged precursor yielded a catalyst of low activity for both methanol synthesis (studied at 50 bar and at 1 bar) and the reverse water-gas shift reaction. The aged precursor gave catalysts of much higher activity for both reactions. Increased ageing did not change the selectivity ratio for methanol synthesis vs. reverse shift in the CO2+ H2 reaction at normal pressure.

Cu–ZnO and Cu–ZnO/Al2O3 Catalysts for the Reverse Water-Gas Shift Reaction. The Effect of the Cu/Zn Ratio on Precursor Characteristics and on the Activity of the Derived Catalysts

Abstract: Comparison is made between Cu–ZnO and alumina-supported Cu–ZnO as catalysts for the reverse water-gas shift (RWGS) reaction For both types of catalyst the Cu/Zn ratio has been varied between Cu-rich and Zn-rich compositions By applying X-ray diffractometry, X-ray line broadening, optical reflectance spectroscopy and other techniques the effects on the structural and physical properties of the hydroxycarbonate precursors, the calcined products and the ultimately derived catalysts are determined The presence of alumina decreases the crystallite size of the CuO and ZnO particles produced on calcination and at high Cu/Zn ratios increases the dispersion of copper in the final catalyst The activities of the catalysts for the RWGS reaction at 513K are compared and the most active are shown to be those which are Cu rich (Cu/Zn > 3) and contain alumina as support The activities of all the catalysts can be rationalized by referring the activity to unit surface area of copper metal

Simulation studies of the structure and energetics of sorbed molecules in high-silica zeolites. 1. Hydrocarbons

Abstract: Theoretical methods are used to study the adsorption of linear hydrocarbons, Cl-C8, in silicalite, H-ZSM-5, and siliceous faujasite. The aim is to model the behavior of sorbed species in zeolites and evaluate the influence of the zeolite structure and composition on the sorption process. The method of calculation is energy minimization using the Born model of solids with specified interatomic potentials

Recent advances in catalytic hydrogenation of carbon dioxide

Abstract: Owing to the increasing emissions of carbon dioxide (CO2), human life and the ecological environment have been affected by global warming and climate changes. To mitigate the concentration of CO2 in the atmosphere various strategies have been implemented such as separation, storage, and utilization of CO2. Although it has been explored for many years, hydrogenation reaction, an important representative among chemical conversions of CO2, offers challenging opportunities for sustainable development in energy and the environment. Indeed, the hydrogenation of CO2 not only reduces the increasing CO2 buildup but also produces fuels and chemicals. In this critical review we discuss recent developments in this area, with emphases on catalytic reactivity, reactor innovation, and reaction mechanism. We also provide an overview regarding the challenges and opportunities for future research in the field (319 references).

Quantum Dot Solar Cells. Tuning Photoresponse through Size and Shape Control of CdSe−TiO2 Architecture

Abstract: Different-sized CdSe quantum dots have been assembled on TiO2 films composed of particle and nanotube morphologies using a bifunctional linker molecule. Upon band-gap excitation, CdSe quantum dots inject electrons into TiO2 nanoparticles and nanotubes, thus enabling the generation of photocurrent in a photoelectrochemical solar cell. The results presented in this study highlight two major findings: (i) ability to tune the photoelectrochemical response and photoconversion efficiency via size control of CdSe quantum dots and (ii) improvement in the photoconversion efficiency by facilitating the charge transport through TiO2 nanotube architecture. The maximum IPCE (photon-to-charge carrier generation efficiency) obtained with 3 nm diameter CdSe nanoparticles was 35% for particulate TiO2 and 45% for tubular TiO2 morphology. The maximum IPCE observed at the excitonic band increases with decreasing particle size, whereas the shift in the conduction band to more negative potentials increases the driving force and favors fast electron injection. The maximum power-conversion efficiency

Sustainable Conversion of Carbon Dioxide: An Integrated Review of Catalysis and Life Cycle Assessment

Abstract: CO2 conversion covers a wide range of possible application areas from fuels to bulk and commodity chemicals and even to specialty products with biological activity such as pharmaceuticals. In the present review, we discuss selected examples in these areas in a combined analysis of the state-of-the-art of synthetic methodologies and processes with their life cycle assessment. Thereby, we attempted to assess the potential to reduce the environmental footprint in these application fields relative to the current petrochemical value chain. This analysis and discussion differs significantly from a viewpoint on CO2 utilization as a measure for global CO2 mitigation. Whereas the latter focuses on reducing the end-of-pipe problem “CO2 emissions” from todays’ industries, the approach taken here tries to identify opportunities by exploiting a novel feedstock that avoids the utilization of fossil resource in transition toward more sustainable future production. Thus, the motivation to develop CO2-based chemistry does...

Heterogeneous catalytic decomposition of nitrous oxide

Abstract: An overview is given on the ongoing activities in the area of the decomposition of nitrous oxide, N2O, over solid catalysts. These catalysts include metals, pure and mixed oxides, supported as well as unsupported, and zeolitic systems. The review covers aspects of the reaction mechanism and kinetics, focusing on the role of surface oxygen, the inhibition by molecular oxygen, water and other species, poisoning phenomena and practical developments.