G. Muller

Bio: G. Muller is an academic researcher from Philips. The author has contributed to research in topics: Field-effect transistor & Gate oxide. The author has an hindex of 2, co-authored 2 publications receiving 1168 citations.

A ferroelectric transparent thin‐film transistor

Abstract: Operation is demonstrated of a field‐effect transistor made of transparant oxidic thin films, showing an intrinsic memory function due to the usage of a ferroelectric insulator. The device consists of a high mobility Sb‐doped n‐type SnO2 semiconductor layer, PbZr0.2Ti0.8O3 as a ferroelectric insulator, and SrRuO3 as a gate electrode, each layer prepared by pulsed laser deposition. The hysteresis behavior of the channel conductance is studied. Using gate voltage pulses of 100 μs duration and a pulse height of ±3 V, a change of a factor of two in the remnant conductance is achieved. The dependence of the conductance on the polarity of the gate pulse proves that the memory effect is driven by the ferroelectric polarization. The influence of charge trapping is also observed and discussed.

Oxidic Field Effect Structures with Memory

Abstract: Two types of switching memory devices have been made by integrating a ferroelectric layer in a device. A Schottky diode consisting of a ferroelectric semiconductor and a high work function metal was found to show a bistable I-V behaviour. Experimentally an On/Off current ratio of two orders of magnitude was found in a structure consisting of a semiconducting PbTiO3 layer with a gold top contact, grown on a La0.5Sr0.5CoO3 bottom contact layer. The ferroelectric polarization parallel or antiparallel to the internal field of the diode gives rise to a change in the Schottky barrier height and depletion width. This will, depending on the polarization direction of the ferroelectric layer, enhance or diminish the tunnel probability of charge carriers through the Schottky barrier and thereby increase or decrease the current through the device. In the Ferroelectric Field Effect Transistor an insulating ferroelectric gate oxide was brought in close contact to a gated n-type Sb-doped SnO2 semiconducting channel layer. A maximum On/Off Source-Drain current (IsD) ratio at zero gate voltage of 5.7 was found. Gate pulse measurements showed retention of IsD after polarisation reversal of the ferroelectric gate oxide in both polarization directions. After more than 104 switching cycles the device shows a gradual decrease in ISD both in the On and Off state.

Thin-Film Transistor Fabricated in Single-Crystalline Transparent Oxide Semiconductor

Abstract: We report the fabrication of transparent field-effect transistors using a single-crystalline thin-film transparent oxide semiconductor, InGaO 3 (ZnO) 5 , as an electron channel and amorphous hafnium oxide as a gate insulator. The device exhibits an on-to-off current ratio of ∼10 6 and a field-effect mobility of ∼80 square centimeters per volt per second at room temperature, with operation insensitive to visible light irradiation. The result provides a step toward the realization of transparent electronics for next-generation optoelectronics.

Oxide Semiconductor Thin‐Film Transistors: A Review of Recent Advances

Abstract: Transparent electronics is today one of the most advanced topics for a wide range of device applications. The key components are wide bandgap semiconductors, where oxides of different origins play an important role, not only as passive component but also as active component, similar to what is observed in conventional semiconductors like silicon. Transparent electronics has gained special attention during the last few years and is today established as one of the most promising technologies for leading the next generation of flat panel display due to its excellent electronic performance. In this paper the recent progress in n- and p-type oxide based thin-film transistors (TFT) is reviewed, with special emphasis on solution-processed and p-type, and the major milestones already achieved with this emerging and very promising technology are summarizeed. After a short introduction where the main advantages of these semiconductors are presented, as well as the industry expectations, the beautiful history of TFTs is revisited, including the main landmarks in the last 80 years, finishing by referring to some papers that have played an important role in shaping transparent electronics. Then, an overview is presented of state of the art n-type TFTs processed by physical vapour deposition methods, and finally one of the most exciting, promising, and low cost but powerful technologies is discussed: solution-processed oxide TFTs. Moreover, a more detailed focus analysis will be given concerning p-type oxide TFTs, mainly centred on two of the most promising semiconductor candidates: copper oxide and tin oxide. The most recent data related to the production of complementary metal oxide semiconductor (CMOS) devices based on n- and p-type oxide TFT is also be presented. The last topic of this review is devoted to some emerging applications, finalizing with the main conclusions. Related work that originated at CENIMAT|I3N during the last six years is included in more detail, which has led to the fabrication of high performance n- and p-type oxide transistors as well as the fabrication of CMOS devices with and on paper.

P-type electrical conduction in transparent thin films of CuAlO2

Abstract: Optically transparent oxides tend to be electrical insulators, by virtue of their large electronic bandgap (⩾3.1 eV). The most notable exceptions are doped versions of the oxides In2O3, SnO2 and ZnO—all n-type (electron) conductors—which are widely used as the transparent electrodes in flat-panel displays1,2. On the other hand, no transparent oxide exhibiting high p-type (hole) conductivity is known to exist, whereas such materials could open the way to a range of novel applications. For example, a combination of the two types of transparent conductor in the form of a pn junction could lead to a ‘functional’ window that transmits visible light yet generates electricity in response to the absorption of ultraviolet photons. Here we describe a strategy for identifying oxide materials that should combine p-type conductivity with good optical transparency. We illustrate the potential of this approach by reporting the properties of thin films of CuAlO2, a transparent oxide having room-temperature p-type conductivity up to 1 S cm−1. Although the conductivity of our candidate material is significantly lower than that observed for the best n-type conducting oxides, it is sufficient for some applications, and demonstrates that the development of transparent p-type conductors is not an insurmountable goal.

Semiconductor device, and manufacturing method thereof

Abstract: An object is to provide a semiconductor device of which a manufacturing process is not complicated and by which cost can be suppressed, by forming a thin film transistor using an oxide semiconductor film typified by zinc oxide, and a manufacturing method thereof. For the semiconductor device, a gate electrode is formed over a substrate; a gate insulating film is formed covering the gate electrode; an oxide semiconductor film is formed over the gate insulating film; and a first conductive film and a second conductive film are formed over the oxide semiconductor film. The oxide semiconductor film has at least a crystallized region in a channel region.

ZnO-based transparent thin-film transistors

Abstract: Highly transparent ZnO-based thin-film transistors (TFTs) are fabricated with optical transmission (including substrate) of ∼75% in the visible portion of the electromagnetic spectrum. Current–voltage measurements indicate n-channel, enhancement-mode TFT operation with excellent drain current saturation and a drain current on-to-off ratio of ∼107. Threshold voltages and channel mobilities of devices fabricated to date range from ∼10 to 20 V and ∼0.3 to 2.5 cm2/V s, respectively. Exposure to ambient light has little to no observable effect on the drain current. In contrast, exposure to intense ultraviolet radiation results in persistent photoconductivity, associated with the creation of electron-hole pairs by ultraviolet photons with energies greater than the ZnO band gap. Light sensitivity is reduced by decreasing the ZnO channel layer thickness. One attractive application for transparent TFTs involves their use as select-transistors in each pixel of an active-matrix liquid-crystal display.