scispace - formally typeset
Search or ask a question
Author

G. Vinitha

Bio: G. Vinitha is an academic researcher from VIT University. The author has contributed to research in topics: Single crystal & Crystal. The author has an hindex of 23, co-authored 251 publications receiving 2106 citations. Previous affiliations of G. Vinitha include B. S. Abdur Rahman University & Anna University.


Papers
More filters
Journal ArticleDOI
TL;DR: In this article, a thorough review is presented on the various attempts done so far on degradation of different synthetic textile dyes solution using BiFeO3 nanostructures, considering its ability to absorb in the visible light of solar spectrum, its multiferroic property and its crystal structure.
Abstract: Different effluents from textile industries which are dumped into the water bodies have been a major concern of the modern world. The uncontrolled discharge of the synthetic textile dyes in water bodies especially have led to serious environmental problems and health hazards. Among the different existing approaches to treat water, photocatalysis is an attractive approach as it uses the inexhaustible and clean solar energy. Considering its ability to absorb in the visible light of solar spectrum, its multiferroic property and its crystal structure, researchers feel BiFeO3 can provide a breakthrough in the treatment of water. In this article, a thorough review is presented on the various attempts done so far on degradation of different synthetic textile dyes solution using BiFeO3 nanostructures.

99 citations

Journal ArticleDOI
01 Nov 2013-Optik
TL;DR: In this paper, a single crystal of potassium dichromate (KDC) has been grown from aqueous solution by slow evaporation technique and the lattice parameters of the grown crystal were determined by X-ray diffraction analysis.

75 citations

Journal ArticleDOI
TL;DR: In this paper, the negative nonlinear optical parameters of 2-aminopyridinium trichloroacetate were derived by the Z-scan technique, and high-resolution X-ray diffraction measurements were performed to analyze the structural perfection of the grown crystals.

68 citations

Journal ArticleDOI
TL;DR: The third order NLO properties of thiourea and its metal complexes were measured using a 532nm second harmonic of diode pumped Nd:YAG laser (1064nm, 50mW) by employing the Z-scan technique.

65 citations

Journal ArticleDOI
TL;DR: The NLO and PL studies suggested that the investigated glasses containing a 0.01 mol% of AuCl3 is practically appropriate for photonic applications.
Abstract: Alkali borate glasses activated with trivalent europium ions and rooted with gold (Au) nanoparticles (NPs) were synthesised through a melt quenching process involving a selective thermochemical reduction and their applicability as photonic materials was assessed in detail. Non-linear optical (NLO) measurements were performed using a Z-scan approach in the wavelength range of 700-1000 nm. The open aperture Z-scan signatures for the Eu3+-containing glasses embedded with and without the Au NPs established a reverse saturable absorption (RSA) at all of the studied wavelengths ascribed to the two-photon absorption (2PA). Surprisingly, the nonlinear optical absorption switched to a saturable absorption (SA) with an increase in the concentration of AuCl3. With the incorporation of the Au NPs, the UV excited photoluminescence (PL) intensity of the Eu3+-doped glasses increased first as a consequence of the local field enhancement by the Au NPs, and subsequently decreased at a higher concentration of AuCl3 due to the reverse energy transfer from the Eu3+ ion to the Au0 NPs. The electronic polarization effect of the host glass enhanced the 5D0→7F4 transition intensity on the incorporation of the gold NPs owing to the gold NP-embedded glasses showing a deep-red emission. The NLO and PL studies suggested that the investigated glasses containing a 0.01 mol% of AuCl3 is practically appropriate for photonic applications.

55 citations


Cited by
More filters
Journal Article
TL;DR: In this article, a class of π;-conjugated compounds that exhibit large δ (as high as 1, 250 × 10−50 cm4 s per photon) and enhanced two-photon sensitivity relative to ultraviolet initiators were developed and used to demonstrate a scheme for three-dimensional data storage which permits fluorescent and refractive read-out, and the fabrication of 3D micro-optical and micromechanical structures, including photonic-bandgap-type structures.
Abstract: Two-photon excitation provides a means of activating chemical or physical processes with high spatial resolution in three dimensions and has made possible the development of three-dimensional fluorescence imaging, optical data storage, and lithographic microfabrication. These applications take advantage of the fact that the two-photon absorption probability depends quadratically on intensity, so under tight-focusing conditions, the absorption is confined at the focus to a volume of order λ3 (where λ is the laser wavelength). Any subsequent process, such as fluorescence or a photoinduced chemical reaction, is also localized in this small volume. Although three-dimensional data storage and microfabrication have been illustrated using two-photon-initiated polymerization of resins incorporating conventional ultraviolet-absorbing initiators, such photopolymer systems exhibit low photosensitivity as the initiators have small two-photon absorption cross-sections (δ). Consequently, this approach requires high laser power, and its widespread use remains impractical. Here we report on a class of π;-conjugated compounds that exhibit large δ (as high as 1, 250 × 10−50 cm4 s per photon) and enhanced two-photon sensitivity relative to ultraviolet initiators. Two-photon excitable resins based on these new initiators have been developed and used to demonstrate a scheme for three-dimensional data storage which permits fluorescent and refractive read-out, and the fabrication of three-dimensional micro-optical and micromechanical structures, including photonic-bandgap-type structures.

1,833 citations

Journal ArticleDOI
TL;DR: This Review gives emphasis to the nonlinear optical properties of photoactive materials for the function of optical power limiting and describes the known mechanisms of optical limiting for the different types of materials.
Abstract: The control of luminous radiation has extremely important implications for modern and future technologies as well as in medicine. In this Review, we detail chemical structures and their relevant photophysical features for various groups of materials, including organic dyes such as metalloporphyrins and metallophthalocyanines (and derivatives), other common organic materials, mixed metal complexes and clusters, fullerenes, dendrimeric nanocomposites, polymeric materials (organic and/or inorganic), inorganic semiconductors, and other nanoscopic materials, utilized or potentially useful for the realization of devices able to filter in a smart way an external radiation. The concept of smart is referred to the characteristic of those materials that are capable to filter the radiation in a dynamic way without the need of an ancillary system for the activation of the required transmission change. In particular, this Review gives emphasis to the nonlinear optical properties of photoactive materials for the functi...

424 citations

Journal ArticleDOI
TL;DR: In this article, a review highlights the applied protocols to ameliorate the photoactivity of graphitic carbon nitride (g-C3N4) based nanocomposites through combining with various materials.

381 citations

Journal ArticleDOI
TL;DR: In this article, the authors survey the recent advances in nonlinear optics and the applications of two-dimensional (2D) materials and highlight a few representative current applications of 2D materials to photonic and optoelectronic devices.
Abstract: In this review, we survey the recent advances in nonlinear optics and the applications of two-dimensional (2D) materials. We briefly cover the key developments pertaining to research in the nonlinear optics of graphene, the quintessential 2D material. Subsequently, we discuss the linear and nonlinear optical properties of several other 2D layered materials, including transition metal chalcogenides, black phosphorus, hexagonal boron nitride, perovskites, and topological insulators, as well as the recent progress in hybrid nanostructures containing 2D materials, such as composites with dyes, plasmonic particles, 2D crystals, and silicon integrated structures. Finally, we highlight a few representative current applications of 2D materials to photonic and optoelectronic devices.

235 citations

Journal ArticleDOI
TL;DR: In this article, the nonlinear optical properties of metal nanoparticles (including copper, silver, gold, and bismuth nanoparticles) doped in various bases have been discussed.
Abstract: Metal nanoparticles (MNPs) hold great technological promise because of the possibility of engineering their electronic and optical properties through material design. One of the effective methods to fabricate MNPs is ion implantation. In this review, recent results on the nonlinear optical properties of nanoparticles (including copper, silver, gold, and bismuth nanoparticles) doped in various bases have been discussed. Some specific optical nonlinear properties, such as nonlinear refraction, two-photon absorption, and optical limiting, for femtosecond, picosecond, and nanosecond laser pulses have also been covered. In addition to ion implantation, we have summarized several other methods for the preparation of composite materials, and Z-scan has been used to study the nonlinear optical properties of these materials.

232 citations