George Goussetis

Bio: George Goussetis is an academic researcher from Heriot-Watt University. The author has contributed to research in topics: Antenna (radio) & Band-pass filter. The author has an hindex of 29, co-authored 301 publications receiving 4679 citations. Previous affiliations of George Goussetis include University of Westminster & Thales Group.

Artificial magnetic conductor surfaces and their application to low-profile high-gain planar antennas

Abstract: Planar periodic metallic arrays behave as artificial magnetic conductor (AMC) surfaces when placed on a grounded dielectric substrate and they introduce a zero degrees reflection phase shift to incident waves. In this paper the AMC operation of single-layer arrays without vias is studied using a resonant cavity model and a new application to high-gain printed antennas is presented. A ray analysis is employed in order to give physical insight into the performance of AMCs and derive design guidelines. The bandwidth and center frequency of AMC surfaces are investigated using full-wave analysis and the qualitative predictions of the ray model are validated. Planar AMC surfaces are used for the first time as the ground plane in a high-gain microstrip patch antenna with a partially reflective surface as superstrate. A significant reduction of the antenna profile is achieved. A ray theory approach is employed in order to describe the functioning of the antenna and to predict the existence of quarter wavelength resonant cavities.

Simple and Accurate Analytical Model of Planar Grids and High-Impedance Surfaces Comprising Metal Strips or Patches

Abstract: Simple analytical formulas are introduced for the grid impedance of electrically dense arrays of square patches and for the surface impedance of high-impedance surfaces based on the dense arrays of metal strips or square patches over ground planes. Emphasis is on the oblique-incidence excitation. The approach is based on the known analytical models for strip grids combined with the approximate Babinet principle for planar grids located at a dielectric interface. Analytical expressions for the surface impedance and reflection coefficient resulting from our analysis are thoroughly verified by full-wave simulations and compared with available data in open literature for particular cases. The results can be used in the design of various antennas and microwave or millimeter wave devices which use artificial impedance surfaces and artificial magnetic conductors (reflect-array antennas, tunable phase shifters, etc.), as well as for the derivation of accurate higher-order impedance boundary conditions for artificial (high-) impedance surfaces. As an example, the propagation properties of surface waves along the high-impedance surfaces are studied.

Satellite Communications in the New Space Era: A Survey and Future Challenges

Abstract: Satellite communications (SatComs) have recently entered a period of renewed interest motivated by technological advances and nurtured through private investment and ventures. The present survey aims at capturing the state of the art in SatComs, while highlighting the most promising open research topics. Firstly, the main innovation drivers are motivated, such as new constellation types, on-board processing capabilities, non-terrestrial networks and space-based data collection/processing. Secondly, the most promising applications are described, i.e., 5G integration, space communications, Earth observation, aeronautical and maritime tracking and communication. Subsequently, an in-depth literature review is provided across five axes: i) system aspects, ii) air interface, iii) medium access, iv) networking, v) testbeds & prototyping. Finally, a number of future challenges and the respective open research topics are described.

Tailoring the AMC and EBG characteristics of periodic metallic arrays printed on grounded dielectric substrate

Abstract: The artificial magnetic conductor (AMC) and electromagnetic band gap (EBG) characteristics of planar periodic metallic arrays printed on grounded dielectric substrate are investigated. The currents induced on the arrays are presented for the first time and their study reveals two distinct resonance phenomena associated with these surfaces. A new technique is presented to tailor the spectral position of the AMC operation and the EBG. Square patch arrays with fixed element size and variable periodicities are employed as working examples to demonstrate the dependence of the spectral AMC and EBG characteristics on array parameters. It is revealed that as the array periodicity is increased, the AMC frequency is increased, while the EBG frequency is reduced. This is shown to occur due to the different nature of the resonance phenomena and the associated underlying physical mechanisms that produce the two effects. The effect of substrate thickness is also investigated. Full wave method of moments (MoM) has been employed for the derivation of the reflection characteristics, the currents and the dispersion relations. A uniplanar array with simultaneous AMC and EBG operation is demonstrated theoretically and experimentally.

Anisotropic Impedance Surfaces for Linear to Circular Polarization Conversion

Abstract: Anisotropic impedance surfaces are employed as low-profile and broadband reflectors that convert orthogonal linear to right- and left-handed circular polarization respectively. By virtue of anisotropy, it is possible to independently control the reflection characteristics of two orthogonal linearly polarized incident plane waves and therefore achieve linear to circular polarization conversion. Equivalent circuits for anisotropic impedance surfaces with arbitrarily shaped elements are employed to demonstrate the operating principle and a design procedure is proposed. The proposed design procedure is demonstrated by means of an example involving a dipole array. A prototype is designed and its performance characteristics are evaluated. The 3-dB relative axial ratio bandwidth exceeds 60%, while low loss and angular stability are also reported. Numerical and experimental results on a fabricated prototype are presented to validate the synthesis and the performance.

I and i

Abstract: There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality. Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

Principles Of Optics Electromagnetic Theory Of Propagation Interference And Diffraction Of Light

Abstract: Thank you for reading principles of optics electromagnetic theory of propagation interference and diffraction of light. As you may know, people have search hundreds times for their favorite novels like this principles of optics electromagnetic theory of propagation interference and diffraction of light, but end up in harmful downloads. Rather than enjoying a good book with a cup of coffee in the afternoon, instead they are facing with some infectious bugs inside their computer.

An Overview of the Theory and Applications of Metasurfaces: The Two-Dimensional Equivalents of Metamaterials

Abstract: Metamaterials are typically engineered by arranging a set of small scatterers or apertures in a regular array throughout a region of space, thus obtaining some desirable bulk electromagnetic behavior. The desired property is often one that is not normally found naturally (negative refractive index, near-zero index, etc.). Over the past ten years, metamaterials have moved from being simply a theoretical concept to a field with developed and marketed applications. Three-dimensional metamaterials can be extended by arranging electrically small scatterers or holes into a two-dimensional pattern at a surface or interface. This surface version of a metamaterial has been given the name metasurface (the term metafilm has also been employed for certain structures). For many applications, metasurfaces can be used in place of metamaterials. Metasurfaces have the advantage of taking up less physical space than do full three-dimensional metamaterial structures; consequently, metasurfaces offer the possibility of less-lossy structures. In this overview paper, we discuss the theoretical basis by which metasurfaces should be characterized, and discuss their various applications. We will see how metasurfaces are distinguished from conventional frequency-selective surfaces. Metasurfaces have a wide range of potential applications in electromagnetics (ranging from low microwave to optical frequencies), including: (1) controllable “smart” surfaces, (2) miniaturized cavity resonators, (3) novel wave-guiding structures, (4) angular-independent surfaces, (5) absorbers, (6) biomedical devices, (7) terahertz switches, and (8) fluid-tunable frequency-agile materials, to name only a few. In this review, we will see that the development in recent years of such materials and/or surfaces is bringing us closer to realizing the exciting speculations made over one hundred years ago by the work of Lamb, Schuster, and Pocklington, and later by Mandel'shtam and Veselago.

Metasurfaces: From microwaves to visible

Abstract: We review the basic physics and applications of a special class of planar metamaterials, often called metasurfaces, which are composed of optically thin and densely packed planar arrays of resonant or nearly resonant subwavelength elements. Electromagnetic properties and functionalities of such metasurfaces are defined by the structure and specific features of the subwavelength elements and their coupling type and strength, and they are often influenced by an underlying substrate. Metasurfaces may provide a full control of the reflected and transmitted fields, and they can be designed to possess many required properties replacing bulky optical components. Here, we describe different types of metasurfaces suggested in the past and recent years for a broad range of the operational wavelengths ranging from microwaves to the visible, and emphasize their important functionalities. We demonstrate that, despite a wide functional and structural diversity, all suggested metasurfaces can be associated with only several broad classes depending on intrinsic physical mechanisms of their polarizability. We suggest the functionality-based classification of metasurfaces, and clarify a link between their polarization response and field control capabilities. We also suggest a general approach to an optimal design of metasurfaces for many specific applications.