George Swallow

Bio: George Swallow is an academic researcher from Cisco Systems, Inc.. The author has contributed to research in topics: Multiprotocol Label Switching & Network packet. The author has an hindex of 20, co-authored 70 publications receiving 3357 citations.

RSVP-TE: Extensions to RSVP for LSP Tunnels

Abstract: This document describes the use of RSVP (Resource Reservation Protocol), including all the necessary extensions, to establish label-switched paths (LSPs) in MPLS (Multi-Protocol Label Switching) Since the flow along an LSP is completely identified by the label applied at the ingress node of the path, these paths may be treated as tunnels A key application of LSP tunnels is traffic engineering with MPLS as specified in RFC 2702

Fast Reroute Extensions to RSVP-TE for LSP Tunnels

Abstract: This document defines RSVP-TE extensions to establish backup label- switched path (LSP) tunnels for local repair of LSP tunnels. These mechanisms enable the re-direction of traffic onto backup LSP tunnels in 10s of milliseconds, in the event of a failure. Two methods are defined here. The one-to-one backup method creates detour LSPs for each protected LSP at each potential point of local repair. The facility backup method creates a bypass tunnel to protect a potential failure point; by taking advantage of MPLS label stacking, this bypass tunnel can protect a set of LSPs that have similar backup constraints. Both methods can be used to protect links and nodes during network failure. The described behavior and extensions to RSVP allow nodes to implement either method or both and to interoperate in a mixed network. [STANDARDS-TRACK]

RSVP Refresh Overhead Reduction Extensions

Abstract: This document describes a number of mechanisms that can be used to reduce processing overhead requirements of refresh messages, eliminate the state synchronization latency incurred when an RSVP (Resource ReserVation Protocol) message is lost and, when desired, refreshing state without the transmission of whole refresh messages. The same extensions also support reliable RSVP message delivery on a per hop basis. These extension present no backwards compatibility issues.

Detecting Multi-Protocol Label Switched (MPLS) Data Plane Failures

Abstract: This document describes a simple and efficient mechanism that can be used to detect data plane failures in Multi-Protocol Label Switching (MPLS) Label Switched Paths (LSPs). There are two parts to this document: information carried in an MPLS "echo request" and "echo reply" for the purposes of fault detection and isolation, and mechanisms for reliably sending the echo reply. [STANDARDS-TRACK]

System and methods for network reachability detection

Abstract: A mechanism for ASBRs to identify the originating node, or router, in an LSP conversant autonomous system (AS), such as an MPLS VPN environment, maintains the identity of the originating node and successive nodes in subsequent autonomous systems along the path to the node to be pinged. The identity of the transporting nodes is stored in a stack or other object associated with the ping request (ping), such that the pinged node may employ the stored identity as a set of return path routing information. Successive ASBRs store their identity on the stack, in an ordered manner, along the path to the destination. Upon reaching the destination (ping) node, the destination node employs the identity of the first node on the stack to send the acknowledgment, or ping response.

Software-Defined Networking: A Comprehensive Survey

Abstract: The Internet has led to the creation of a digital society, where (almost) everything is connected and is accessible from anywhere. However, despite their widespread adoption, traditional IP networks are complex and very hard to manage. It is both difficult to configure the network according to predefined policies, and to reconfigure it to respond to faults, load, and changes. To make matters even more difficult, current networks are also vertically integrated: the control and data planes are bundled together. Software-defined networking (SDN) is an emerging paradigm that promises to change this state of affairs, by breaking vertical integration, separating the network's control logic from the underlying routers and switches, promoting (logical) centralization of network control, and introducing the ability to program the network. The separation of concerns, introduced between the definition of network policies, their implementation in switching hardware, and the forwarding of traffic, is key to the desired flexibility: by breaking the network control problem into tractable pieces, SDN makes it easier to create and introduce new abstractions in networking, simplifying network management and facilitating network evolution. In this paper, we present a comprehensive survey on SDN. We start by introducing the motivation for SDN, explain its main concepts and how it differs from traditional networking, its roots, and the standardization activities regarding this novel paradigm. Next, we present the key building blocks of an SDN infrastructure using a bottom-up, layered approach. We provide an in-depth analysis of the hardware infrastructure, southbound and northbound application programming interfaces (APIs), network virtualization layers, network operating systems (SDN controllers), network programming languages, and network applications. We also look at cross-layer problems such as debugging and troubleshooting. In an effort to anticipate the future evolution of this new paradigm, we discuss the main ongoing research efforts and challenges of SDN. In particular, we address the design of switches and control platforms—with a focus on aspects such as resiliency, scalability, performance, security, and dependability—as well as new opportunities for carrier transport networks and cloud providers. Last but not least, we analyze the position of SDN as a key enabler of a software-defined environment.

B4: experience with a globally-deployed software defined wan

Abstract: We present the design, implementation, and evaluation of B4, a private WAN connecting Google's data centers across the planet. B4 has a number of unique characteristics: i) massive bandwidth requirements deployed to a modest number of sites, ii) elastic traffic demand that seeks to maximize average bandwidth, and iii) full control over the edge servers and network, which enables rate limiting and demand measurement at the edge.These characteristics led to a Software Defined Networking architecture using OpenFlow to control relatively simple switches built from merchant silicon. B4's centralized traffic engineering service drives links to near 100% utilization, while splitting application flows among multiple paths to balance capacity against application priority/demands. We describe experience with three years of B4 production deployment, lessons learned, and areas for future work.

Software-Defined Networking: A Comprehensive Survey

Abstract: Software-Defined Networking (SDN) is an emerging paradigm that promises to change this state of affairs, by breaking vertical integration, separating the network's control logic from the underlying routers and switches, promoting (logical) centralization of network control, and introducing the ability to program the network. The separation of concerns introduced between the definition of network policies, their implementation in switching hardware, and the forwarding of traffic, is key to the desired flexibility: by breaking the network control problem into tractable pieces, SDN makes it easier to create and introduce new abstractions in networking, simplifying network management and facilitating network evolution. In this paper we present a comprehensive survey on SDN. We start by introducing the motivation for SDN, explain its main concepts and how it differs from traditional networking, its roots, and the standardization activities regarding this novel paradigm. Next, we present the key building blocks of an SDN infrastructure using a bottom-up, layered approach. We provide an in-depth analysis of the hardware infrastructure, southbound and northbound APIs, network virtualization layers, network operating systems (SDN controllers), network programming languages, and network applications. We also look at cross-layer problems such as debugging and troubleshooting. In an effort to anticipate the future evolution of this new paradigm, we discuss the main ongoing research efforts and challenges of SDN. In particular, we address the design of switches and control platforms -- with a focus on aspects such as resiliency, scalability, performance, security and dependability -- as well as new opportunities for carrier transport networks and cloud providers. Last but not least, we analyze the position of SDN as a key enabler of a software-defined environment.

Achieving high utilization with software-driven WAN

Abstract: We present SWAN, a system that boosts the utilization of inter-datacenter networks by centrally controlling when and how much traffic each service sends and frequently re-configuring the network's data plane to match current traffic demand. But done simplistically, these re-configurations can also cause severe, transient congestion because different switches may apply updates at different times. We develop a novel technique that leverages a small amount of scratch capacity on links to apply updates in a provably congestion-free manner, without making any assumptions about the order and timing of updates at individual switches. Further, to scale to large networks in the face of limited forwarding table capacity, SWAN greedily selects a small set of entries that can best satisfy current demand. It updates this set without disrupting traffic by leveraging a small amount of scratch capacity in forwarding tables. Experiments using a testbed prototype and data-driven simulations of two production networks show that SWAN carries 60% more traffic than the current practice.

A Path Computation Element (PCE)-Based Architecture

Abstract: Constraint-based path computation is a fundamental building block for traffic engineering systems such as Multiprotocol Label Switching (MPLS) and Generalized Multiprotocol Label Switching (GMPLS) networks. Path computation in large, multi-domain, multi-region, or multi-layer networks is complex and may require special computational components and cooperation between the different network domains. This document specifies the architecture for a Path Computation Element (PCE)-based model to address this problem space. This document does not attempt to provide a detailed description of all the architectural components, but rather it describes a set of building blocks for the PCE architecture from which solutions may be constructed. This memo provides information for the Internet community.