We present a full-sky 100 μm map that is a reprocessed composite of the COBE/DIRBE and IRAS/ISSA maps, with the zodiacal foreground and confirmed point sources removed. Before using the ISSA maps, we remove the remaining artifacts from the IRAS scan pattern. Using the DIRBE 100 and 240 μm data, we have constructed a map of the dust temperature so that the 100 μm map may be converted to a map proportional to dust column density. The dust temperature varies from 17 to 21 K, which is modest but does modify the estimate of the dust column by a factor of 5. The result of these manipulations is a map with DIRBE quality calibration and IRAS resolution. A wealth of filamentary detail is apparent on many different scales at all Galactic latitudes. In high-latitude regions, the dust map correlates well with maps of H I emission, but deviations are coherent in the sky and are especially conspicuous in regions of saturation of H I emission toward denser clouds and of formation of H2 in molecular clouds. In contrast, high-velocity H I clouds are deficient in dust emission, as expected. To generate the full-sky dust maps, we must first remove zodiacal light contamination, as well as a possible cosmic infrared background (CIB). This is done via a regression analysis of the 100 μm DIRBE map against the Leiden-Dwingeloo map of H I emission, with corrections for the zodiacal light via a suitable expansion of the DIRBE 25 μm flux. This procedure removes virtually all traces of the zodiacal foreground. For the 100 μm map no significant CIB is detected. At longer wavelengths, where the zodiacal contamination is weaker, we detect the CIB at surprisingly high flux levels of 32 ± 13 nW m-2 sr-1 at 140 μm and of 17 ± 4 nW m-2 sr-1 at 240 μm (95% confidence). This integrated flux ~2 times that extrapolated from optical galaxies in the Hubble Deep Field. The primary use of these maps is likely to be as a new estimator of Galactic extinction. To calibrate our maps, we assume a standard reddening law and use the colors of elliptical galaxies to measure the reddening per unit flux density of 100 μm emission. We find consistent calibration using the B-R color distribution of a sample of the 106 brightest cluster ellipticals, as well as a sample of 384 ellipticals with B-V and Mg line strength measurements. For the latter sample, we use the correlation of intrinsic B-V versus Mg2 index to tighten the power of the test greatly. We demonstrate that the new maps are twice as accurate as the older Burstein-Heiles reddening estimates in regions of low and moderate reddening. The maps are expected to be significantly more accurate in regions of high reddening. These dust maps will also be useful for estimating millimeter emission that contaminates cosmic microwave background radiation experiments and for estimating soft X-ray absorption. We describe how to access our maps readily for general use.

/pdf/maps-of-dust-infrared-emission-for-use-in-estimation-of-207gvl50wo.pdf

Maps of Dust Infrared Emission for Use in Estimation of Reddening and Cosmic Microwave Background Radiation Foregrounds

We present the automated techniques we have developed for new software that optimally detects, deblends, measures and classifies sources from astronomical images: SExtractor ( Source Extractor  ). We show that a very reliable star/galaxy separation can be achieved on most images using a neural network trained with simulated images. Salient features of SExtractor include its ability to work on very large images, with minimal human intervention, and to deal with a wide variety of object shapes and magnitudes. It is therefore particularly suited to the analysis of large extragalactic surveys.

/pdf/sextractor-software-for-source-extraction-3zgg2qv8fh.pdf

SExtractor: Software for source extraction

We present far-infrared (FIR) photometry at 150 and 205 micron(s) of eight low-redshift starburst galaxies obtained with the Infrared Space Observatory (ISO) ISOPHOT. Five of the eight galaxies are detected in both wave bands, and these data are used, in conjunction with IRAS archival photometry, to model the dust emission at lambda approximately greater than 40 microns. The FIR spectral energy distributions (SEDs) are best fitted by a combination of two modified Planck functions, with T approx. 40 - 55 K (warm dust) and T approx. 20-23 K (cool dust) and with a dust emissivity index epsilon = 2. The cool dust can be a major contributor to the FIR emission of starburst galaxies, representing up to 60% of the total flux. This component is heated not only by the general interstellar radiation field, but also by the starburst itself. The cool dust mass is up to approx. 150 times larger than the warm dust mass, bringing the gas-to-dust ratios of the starbursts in our sample close to Milky Way values, once resealed for the appropriate metallicity. The ratio between the total dust FIR emission in the range 1-1000 microns and the IRAS FIR emission in the range 40 - 120 microns is approx. 1.75, with small variations from galaxy to galaxy. This ratio is about 40% larger than previously inferred from data at millimeter wavelengths. Although the galaxies in our sample are generally classified as "UV bright," for four of them the UV energy emerging shortward of 0.2 microns is less than 15% of the FIR energy. On average, about 30% of the bolometric flux is coming out in the UV-to-near-IR wavelength range; the rest is emitted in the FIR. Energy balance calculations show that the FIR emission predicted by the dust reddening of the UV-to-near-IR stellar emission is within a factor of approx. 2 of the observed value in individual galaxies and within 20% when averaged over a large sample. If our sample of local starbursts is representative of high-redshift (z approx. greater than 1), UV - bright star-forming galaxies, these galaxies' FIR emission will be generally undetected in submillimeter surveys, unless: (1) their bolometric luminosity is comparable to or larger than that of ultraluminous FIR galaxies and (2) their FIR SED contains a cool dust component.

/pdf/the-dust-content-and-opacity-of-actively-star-forming-3rvrlvzkyq.pdf

The Dust Content and Opacity of Actively Star-Forming Galaxies

The masses of supermassive black holes correlate almost perfectly with the velocity dispersions of their host bulges, Mbh ∝ σα, where α = 48 ± 05 The relation is much tighter than the relation between Mbh and bulge luminosity, with a scatter no larger than expected on the basis of measurement error alone Black hole masses recently estimated by Magorrian et al lie systematically above the Mbh-σ relation defined by more accurate mass estimates, some by as much as 2 orders of magnitude The tightness of the Mbh-σ relation implies a strong link between black hole formation and the properties of the stellar bulge

https://iopscience.iop.org/article/10.1086/312838/pdf

A Fundamental Relation Between Supermassive Black Holes and Their Host Galaxies

We present a two-dimensional fitting algorithm (GALFIT) designed to extract structural components from galaxy images, with emphasis on closely modeling light profiles of spatially well-resolved, nearby galaxies observed with the Hubble Space Telescope. Our algorithm improves on previous techniques in two areas: by being able to simultaneously fit a galaxy with an arbitrary number of components and with optimization in computation speed, suited for working on large galaxy images. We use two-dimensional models such as the "Nuker" law, the Sersic (de Vaucouleurs) profile, an exponential disk, and Gaussian or Moffat functions. The azimuthal shapes are generalized ellipses that can fit disky and boxy components. Some potential applications of our program include: standard modeling of global galaxy profiles; extracting bars, stellar disks, double nuclei, and compact nuclear sources; and measuring absolute dust extinction or surface brightness fluctuations after removing the galaxy model. When examined in detail, we find that even simple looking galaxies generally require at least three components to be modeled accurately, rather than the one or two components more often employed. Many galaxies with complex isophotes, ellipticity changes, and position angle twists can be modeled accurately in two dimensions. We illustrate this by way of 11 case studies, which include regular and barred spiral galaxies, highly disky lenticular galaxies, and elliptical galaxies displaying various levels of complexities. A useful extension of this algorithm is to accurately extract nuclear point sources in galaxies. We compare two-dimensional and one-dimensional extraction techniques on simulated images of galaxies having nuclear slopes with different degrees of cuspiness, and we then illustrate the application of the program to several examples of nearby galaxies with weak nuclei.

https://iopscience.iop.org/article/10.1086/340952/pdf

Detailed structural decomposition of galaxy images

This new, enlarged reference catalogue of bright galaxies in three volumes reflects the explosive growth of extragalactic astronomy over the last 15 years. With data on more than 23,000 galaxies, it includes all galaxies with apparent diameters larger than one arc minute, magnitudes brighter than about magnitude 15.5, and redshifts not larger than 15,000 km/sec, as well as many other objects of interest. Volume 1 contains the explanations and references; volumes 2 and 3 contain the catalogue proper. The catalogue gives for each galaxy, the position, names, type and luminosity class, optical diameters, optical and infrared magnitudes, various colour indices and radial velocities. The work also makes reference to papers on bright galaxies published between 1913 and 1988. This dictionary/encyclopaedia on stellar systems is intended for researchers in astronomy.

Third Reference Catalogue of Bright Galaxies

Reference catalogue of bright galaxies

Evidence for a local super,galaxy

Further evidence for a local super-cluster of galaxies: rotation and expansion

After a survey of various definitions of the photometric characteristic curve of photographic emulsions, this paper reintroduces a long forgotten photometric parameter, the opacitance omega = opacity - 1 = 10(D) - 1 and describes its application to a characteristic function I = Aomega(n)(n approximately (1/2)), Which is linear in log-log co-ordinates over the whole range of densities of practical interest in photographic photometry. In a special case n = 1 and J = I/A = omega.

Gerard de Vaucouleurs

Papers

Third Reference Catalogue of Bright Galaxies

Reference catalogue of bright galaxies

Evidence for a local super,galaxy

Further evidence for a local super-cluster of galaxies: rotation and expansion

Linearization of characteristic curves in photographic photometry.