scispace - formally typeset
Search or ask a question
Author

Haisheng Chen

Bio: Haisheng Chen is an academic researcher from Chinese Academy of Sciences. The author has contributed to research in topics: Energy storage & Compressed air energy storage. The author has an hindex of 48, co-authored 250 publications receiving 12376 citations. Previous affiliations of Haisheng Chen include East Sussex County Council & University of Leeds.


Papers
More filters
Journal ArticleDOI
TL;DR: In this paper, a review of electrical energy storage technologies for stationary applications is presented, with particular attention paid to pumped hydroelectric storage, compressed air energy storage, battery, flow battery, fuel cell, solar fuel, superconducting magnetic energy storage and thermal energy storage.
Abstract: Electrical energy storage technologies for stationary applications are reviewed. Particular attention is paid to pumped hydroelectric storage, compressed air energy storage, battery, flow battery, fuel cell, solar fuel, superconducting magnetic energy storage, flywheel, capacitor/supercapacitor, and thermal energy storage. Comparison is made among these technologies in terms of technical characteristics, applications and deployment status.

3,031 citations

Journal ArticleDOI
TL;DR: The International Nanofluid Property Benchmark Exercise (INPBE) as mentioned in this paper was held in 1998, where the thermal conductivity of identical samples of colloidally stable dispersions of nanoparticles or "nanofluids" was measured by over 30 organizations worldwide, using a variety of experimental approaches, including the transient hot wire method, steady state methods, and optical methods.
Abstract: This article reports on the International Nanofluid Property Benchmark Exercise, or INPBE, in which the thermal conductivity of identical samples of colloidally stable dispersions of nanoparticles or “nanofluids,” was measured by over 30 organizations worldwide, using a variety of experimental approaches, including the transient hot wire method, steady-state methods, and optical methods. The nanofluids tested in the exercise were comprised of aqueous and nonaqueous basefluids, metal and metal oxide particles, near-spherical and elongated particles, at low and high particle concentrations. The data analysis reveals that the data from most organizations lie within a relatively narrow band (±10% or less) about the sample average with only few outliers. The thermal conductivity of the nanofluids was found to increase with particle concentration and aspect ratio, as expected from classical theory. There are (small) systematic differences in the absolute values of the nanofluid thermal conductivity among the various experimental approaches; however, such differences tend to disappear when the data are normalized to the measured thermal conductivity of the basefluid. The effective medium theory developed for dispersed particles by Maxwell in 1881 and recently generalized by Nan et al. [J. Appl. Phys. 81, 6692 (1997)], was found to be in good agreement with the experimental data, suggesting that no anomalous enhancement of thermal conductivity was achieved in the nanofluids tested in this exercise.

942 citations

Journal ArticleDOI
TL;DR: In this paper, stable aqueous TiO2 nanofluids with different particle sizes and concentrations were formulated and measured for their static thermal conductivity and rheological behaviour.

889 citations

Journal Article
TL;DR: The International Nanofluid Property Benchmark Exercise (INPBE) as discussed by the authors was held in 1998, where the thermal conductivity of identical samples of colloidally stable dispersions of nanoparticles or "nanofluids" was measured by over 30 organizations worldwide, using a variety of experimental approaches, including the transient hot wire method, steady state methods, and optical methods.
Abstract: This article reports on the International Nanofluid Property Benchmark Exercise, or INPBE, in which the thermal conductivity of identical samples of colloidally stable dispersions of nanoparticles or “nanofluids,” was measured by over 30 organizations worldwide, using a variety of experimental approaches, including the transient hot wire method, steady-state methods, and optical methods. The nanofluids tested in the exercise were comprised of aqueous and nonaqueous basefluids, metal and metal oxide particles, near-spherical and elongated particles, at low and high particle concentrations. The data analysis reveals that the data from most organizations lie within a relatively narrow band (±10% or less) about the sample average with only few outliers. The thermal conductivity of the nanofluids was found to increase with particle concentration and aspect ratio, as expected from classical theory. There are (small) systematic differences in the absolute values of the nanofluid thermal conductivity among the various experimental approaches; however, such differences tend to disappear when the data are normalized to the measured thermal conductivity of the basefluid. The effective medium theory developed for dispersed particles by Maxwell in 1881 and recently generalized by Nan et al. [J. Appl. Phys. 81, 6692 (1997)], was found to be in good agreement with the experimental data, suggesting that no anomalous enhancement of thermal conductivity was achieved in the nanofluids tested in this exercise.

881 citations

Journal ArticleDOI
TL;DR: In this article, the experimental results show that the EG-based nanofluids are Newtonian under the conditions of this work with the shear viscosity as a strong function of temperature and particle concentration.
Abstract: This work aims at a more fundamental understanding of the rheological behaviour of nanofluids and the interpretation of the discrepancy in the recent literature. Both experiments and theoretical analyses are carried out with the experimental work on ethylene glycol (EG)-based nanofluids containing 0.5–8.0 wt% spherical TiO2 nanoparticles at 20–60 °C and the theoretical analyses on the high shear viscosity, shear thinning behaviour and temperature dependence. The experimental results show that the EG-based nanofluids are Newtonian under the conditions of this work with the shear viscosity as a strong function of temperature and particle concentration. The relative viscosity of the nanofluids is, however, independent of temperature. The theoretical analyses show that the high shear viscosity of nanofluids can be predicted by the Krieger–Dougherty equation if the effective nanoparticle concentration is used. For spherical nanoparticles, an aggregate size of approximately 3 times the primary nanoparticle size gives the best prediction of experimental data of both this work and those from the literature. The shear thinning behaviour of nanofluids depends on the effective particle concentration, the range of shear rate and viscosity of the base liquid. Such non-Newtonian behaviour can be characterized by a characteristic shear rate, which decreases with increasing volume fraction, increasing base liquid viscosity, or increasing aggregate size. These findings explain the reported controversy of the rheological behaviour of nanofluids in the literature. At temperatures not very far from the ambient temperature, the relative high shear viscosity is independent of temperature due to negligible Brownian diffusion in comparison to convection in high shear flows, in agreement with the experimental results. However, the characteristic shear rate can have strong temperature dependence, thus affecting the shear thinning behaviour. The theoretical analyses also lead to a classification of nanofluids into dilute, semi-dilute, semi-concentrated and concentrated nanofluids depending on particle concentration and particle structuring.

519 citations


Cited by
More filters
Journal ArticleDOI
TL;DR: Two important future research directions are indicated and summarized, based on results published in the literature: the development of composite and nanostructured ES materials to overcome the major challenge posed by the low energy density.
Abstract: In this critical review, metal oxides-based materials for electrochemical supercapacitor (ES) electrodes are reviewed in detail together with a brief review of carbon materials and conducting polymers. Their advantages, disadvantages, and performance in ES electrodes are discussed through extensive analysis of the literature, and new trends in material development are also reviewed. Two important future research directions are indicated and summarized, based on results published in the literature: the development of composite and nanostructured ES materials to overcome the major challenge posed by the low energy density of ES (476 references).

7,642 citations

Journal ArticleDOI
TL;DR: This Review introduces several typical energy storage systems, including thermal, mechanical, electromagnetic, hydrogen, and electrochemical energy storage, and the current status of high-performance hydrogen storage materials for on-board applications and electrochemicals for lithium-ion batteries and supercapacitors.
Abstract: [Liu, Chang; Li, Feng; Ma, Lai-Peng; Cheng, Hui-Ming] Chinese Acad Sci, Inst Met Res, Shenyang Natl Lab Mat Sci, Shenyang 110016, Peoples R China.;Cheng, HM (reprint author), Chinese Acad Sci, Inst Met Res, Shenyang Natl Lab Mat Sci, 72 Wenhua Rd, Shenyang 110016, Peoples R China;cheng@imr.ac.cn

4,105 citations

Journal ArticleDOI
TL;DR: This review offers details of the technologies, in terms of needs, status, challenges and future R&d directions, that are expected to integrate significant levels of renewables into the electrical grid.
Abstract: The is a comprehensive review on the needs and potential storage technologies for electrical grid that is expected to integrate significant levels of renewables. This review offers details of the technologies, in terms of needs, status, challenges and future R&d directions.

4,096 citations

Journal ArticleDOI
TL;DR: In this paper, a review of electrical energy storage technologies for stationary applications is presented, with particular attention paid to pumped hydroelectric storage, compressed air energy storage, battery, flow battery, fuel cell, solar fuel, superconducting magnetic energy storage and thermal energy storage.
Abstract: Electrical energy storage technologies for stationary applications are reviewed. Particular attention is paid to pumped hydroelectric storage, compressed air energy storage, battery, flow battery, fuel cell, solar fuel, superconducting magnetic energy storage, flywheel, capacitor/supercapacitor, and thermal energy storage. Comparison is made among these technologies in terms of technical characteristics, applications and deployment status.

3,031 citations

Journal ArticleDOI
TL;DR: A comprehensive and clear picture of the state-of-the-art technologies available, and where they would be suited for integration into a power generation and distribution system is provided in this article.

2,790 citations