Harith Ahmad

Bio: Harith Ahmad is an academic researcher from University of Malaya. The author has contributed to research in topics: Fiber laser & Laser. The author has an hindex of 45, co-authored 1126 publications receiving 11904 citations. Previous affiliations of Harith Ahmad include Airlangga University & University of Glasgow.

Chronology of Fabry-Perot interferometer fiber-optic sensors and their applications: a review.

Abstract: Optical fibers have been involved in the area of sensing applications for more than four decades. Moreover, interferometric optical fiber sensors have attracted broad interest for their prospective applications in sensing temperature, refractive index, strain measurement, pressure, acoustic wave, vibration, magnetic field, and voltage. During this time, numerous types of interferometers have been developed such as Fabry-Perot, Michelson, Mach-Zehnder, Sagnac Fiber, and Common-path interferometers. Fabry-Perot interferometer (FPI) fiber-optic sensors have been extensively investigated for their exceedingly effective, simple fabrication as well as low cost aspects. In this study, a wide variety of FPI sensors are reviewed in terms of fabrication methods, principle of operation and their sensing applications. The chronology of the development of FPI sensors and their implementation in various applications are discussed.

Towards 5G: A Photonic Based Millimeter Wave Signal Generation for Applying in 5G Access Fronthaul.

Abstract: 5G communications require a multi Gb/s data transmission in its small cells. For this purpose millimeter wave (mm-wave) RF signals are the best solutions to be utilized for high speed data transmission. Generation of these high frequency RF signals is challenging in electrical domain therefore photonic generation of these signals is more studied. In this work, a photonic based simple and robust method for generating millimeter waves applicable in 5G access fronthaul is presented. Besides generating of the mm-wave signal in the 60 GHz frequency band the radio over fiber (RoF) system for transmission of orthogonal frequency division multiplexing (OFDM) with 5 GHz bandwidth is presented. For the purpose of wireless transmission for 5G application the required antenna is designed and developed. The total system performance in one small cell was studied and the error vector magnitude (EVM) of the system was evaluated.

Current sensor based on microfiber knot resonator

Abstract: A compact current sensor using a microfiber knot resonator (MKR) is demonstrated. With the assistance of a copper wire that is wrapped by the microfiber knot, resonant wavelength inside the MKR can be tuned by applying electric current to the copper wire. The resonant wavelength change is based on the thermally induced optical phase shift in the MKR due to the heat produced by the flow of electric current over a short transit length. It is shown that the wavelength shift is linearly proportional to the square of the amount of current and the maximum tuning slope of 51.3 pm/A2 is achieved using a newly fabricated MKR.

C-Band Q-Switched Fiber Laser Using Titanium Dioxide (TiO 2 ) As Saturable Absorber

Abstract: We demonstrate a passively Q-switched erbium fiber laser using titanium dioxide (TiO 2) as a saturable absorber. The TiO 2 saturable absorber was fabricated as a polymer composite film and sandwiched between fiber ferrules. Q-switched pulsing starts with the assistance of physical disturbance of the laser cavity (by lightly tapping the cavity to induce instability) at 140 mW and lasts until 240 mW. The repetition rate increases with the pump power from 80.28 to 120.48 kHz. On the other hand, the pulsewidth decreases from $2.054\ \mu\text{s}$ until it reaches a plateau at $1.84\ \mu\text{s}$ . The Q-switched fiber laser exhibits two competing modes: at 1558.1 and 1558.9 nm as the pump power increases. A high signal-to-noise ratio of 49.65 dB is obtained.

I and i

Abstract: There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality. Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

Phd by thesis

Abstract: Deposits of clastic carbonate-dominated (calciclastic) sedimentary slope systems in the rock record have been identified mostly as linearly-consistent carbonate apron deposits, even though most ancient clastic carbonate slope deposits fit the submarine fan systems better. Calciclastic submarine fans are consequently rarely described and are poorly understood. Subsequently, very little is known especially in mud-dominated calciclastic submarine fan systems. Presented in this study are a sedimentological core and petrographic characterisation of samples from eleven boreholes from the Lower Carboniferous of Bowland Basin (Northwest England) that reveals a >250 m thick calciturbidite complex deposited in a calciclastic submarine fan setting. Seven facies are recognised from core and thin section characterisation and are grouped into three carbonate turbidite sequences. They include: 1) Calciturbidites, comprising mostly of highto low-density, wavy-laminated bioclast-rich facies; 2) low-density densite mudstones which are characterised by planar laminated and unlaminated muddominated facies; and 3) Calcidebrites which are muddy or hyper-concentrated debrisflow deposits occurring as poorly-sorted, chaotic, mud-supported floatstones. These