Izaskun Garrido

Bio: Izaskun Garrido is an academic researcher from University of the Basque Country. The author has contributed to research in topics: Oscillating Water Column & Tokamak. The author has an hindex of 24, co-authored 117 publications receiving 1511 citations. Previous affiliations of Izaskun Garrido include Potsdam Institute for Climate Impact Research & University of Bergen.

Modeling and Simulation of Wave Energy Generation Plants: Output Power Control

Abstract: The control and simulation of the power delivered to the grid are becoming an important topic, particularly when the number of distributed power generation systems increases. In this paper, two different control schemes for an oscillating-water-column Wells-turbine-generator module are simulated, implemented, and compared. In the first method, the control system does appropriately adapt the slip of the induction generator according to the pressure drop entry in order to maximize the generated power, while in the second method, a traditional proportional-integral-derivative-based control is implemented in order to deal with the desired power-reference-tracking problem. It will be shown how the controllers avoid the stalling behavior and that the average power of the generator fed into the grid is significantly higher in the controlled cases than in the uncontrolled one while providing the desired output power.

Sliding-Mode Control of Wave Power Generation Plants

Abstract: The worldwide demand for energy requires alternatives to fossil fuels and nuclear fission, so renewable resources, particularly ocean energy, are called to play a relevant role in a near future. In particular, the oscillating water column (OWC) is one of the most promising devices to harness energy from the sea, as it is the case of the Nereida project plant, located in the Basque coast of Mutriku. This kind of devices consists of a particular type of turbine and a doubly fed induction generator. The turbogenerator module is usually controlled using a traditional proportional-integral (PI)-based vector control scheme, which requires an accurate knowledge of the system parameters and lacks of robustness, limiting, in some cases, the power extraction. To avoid these drawbacks, a novel sliding-mode-control-based vector control scheme for the OWC plant is presented in this paper. This variable-structure control is intrinsically robust under parameter uncertainties, which always appear in real systems, and presents a convenient disturbance rejection. The stability of the proposed controller is analyzed using the Lyapunov theory. The performance of the control scheme presented is proved by comparing it to the traditional PI-based vector control scheme in a series of representative maximum power generation case studies. Both numerical simulations and experimental results show that the proposed solution provides high-performance dynamic characteristics, improving the power extraction in spite of parameter uncertainties and system disturbances.

Complementary Control of Oscillating Water Column-Based Wave Energy Conversion Plants to Improve the Instantaneous Power Output

Abstract: In this paper, an oscillating water column-based wave energy conversion plant is modeled and controlled by means of two complementary control strategies in order to improve the conversion of wave energy into electric power. This wave power generation system consists of a capture chamber, a Wells turbine, and an induction generator. The improvement relays on the implementation of a control scheme that combines two different control methods: a rotational speed control and an airflow control implemented by means of a throttle valve in series with the turbine. The use of rotational speed control provides a fast way to react to the abrupt and short changes in the turbine speed, ensuring that the average power of the generator is adequately adjusted according to the incident wave power level. Besides, a throttle-valve is used to control the flow through the turbine so as to increase the amount of energy produced, particularly at the higher incident wave power levels. These two control strategies complement each other, maximizing and improving the quality of supply by controlling and smoothing the generated power for different scenarios of wave oscillations, variations of wave grouping, and changes in the sea state.

Overview of the TCV tokamak program: scientific progress and facility upgrades

Abstract: The TCV tokamak is augmenting its unique historical capabilities (strong shaping, strong electron heating) with ion heating, additional electron heating compatible with high densities, and variable divertor geometry, in a multifaceted upgrade program designed to broaden its operational range without sacrificing its fundamental flexibility. The TCV program is rooted in a three-pronged approach aimed at ITER support, explorations towards DEMO, and fundamental research. A 1 MW, tangential neutral beam injector (NBI) was recently installed and promptly extended the TCV parameter range, with record ion temperatures and toroidal rotation velocities and measurable neutral-beam current drive. ITER-relevant scenario development has received particular attention, with strategies aimed at maximizing performance through optimized discharge trajectories to avoid MHD instabilities, such as peeling-ballooning and neoclassical tearing modes. Experiments on exhaust physics have focused particularly on detachment, a necessary step to a DEMO reactor, in a comprehensive set of conventional and advanced divertor concepts. The specific theoretical prediction of an enhanced radiation region between the two X-points in the low-field-side snowflake-minus configuration was experimentally confirmed. Fundamental investigations of the power decay length in the scrape-off layer (SOL) are progressing rapidly, again in widely varying configurations and in both D and He plasmas; in particular, the double decay length in L-mode limited plasmas was found to be replaced by a single length at high SOL resistivity. Experiments on disruption mitigation by massive gas injection and electron-cyclotron resonance heating (ECRH) have begun in earnest, in parallel with studies of runaway electron generation and control, in both stable and disruptive conditions; a quiescent runaway beam carrying the entire electrical current appears to develop in some cases. Developments in plasma control have benefited from progress in individual controller design and have evolved steadily towards controller integration, mostly within an environment supervised by a tokamak profile control simulator. TCV has demonstrated effective wall conditioning with ECRH in He in support of the preparations for JT-60SA operation.

Fault-Ride-Through Capability of Oscillating-Water-Column-Based Wave-Power-Generation Plants Equipped With Doubly Fed Induction Generator and Airflow Control

Abstract: The increasing use of distributed power-generation systems, as with the case of wave-power-generation plants, requires a reliable fault-ride-through capability. The effects of grid fault include uncontrolled turbogenerator acceleration, dangerous rotor peak currents, and high reactive-power consumption so that the plant may contribute to the voltage dip. A simple solution is automatic disconnection from the grid, but this policy could lead to a massive power-network failure. This is why new Grid Codes oblige these systems to remain connected to the grid. In this paper, an oscillating-water-column-based wave-power-generation plant equipped with a doubly fed induction generator is modeled and controlled to overcome balanced grid faults. The improvement relies on the implementation of a control scheme that suitably coordinates the airflow control, the active crowbar, and the rotor- and grid-side converters to allow the plant to remain in service during grid fault, contributing to its attenuation by supplying reactive power to the network and complying with new Grid Code requirements. The simulated results show that it obtains a great reduction of the rotor currents, improving the transients and avoiding rotor acceleration. Similar results are obtained from the experimental implementation.

I and i

Abstract: There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality. Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

Of Theory and Practice

Abstract: Much has been written about theory and practice in the law, and the tension between practitioners and theorists. Judges do not cite theoretical articles often; they rarely "apply" theories to particular cases. These arguments are not revisited. Instead the Essay explores the working and interaction of theory and practice, practitioners and theorists. The Essay starts with a story about solving a legal issue using our intellectual tools - theory, practice, and their progenies: experience and "gut." Next the Essay elaborates on the nature of theory, practice, experience and "gut." The third part of the Essay discusses theories that are helpful to practitioners and those that are less helpful. The Essay concludes that practitioners theorize, and theorists practice. They use these intellectual tools differently because the goals and orientations of theorists and practitioners, and the constraints under which they act, differ. Theory, practice, experience and "gut" help us think, remember, decide and create. They complement each other like the two sides of the same coin: distinct but inseparable.

Physics of plasmas

Abstract: 1 The Equations of Gas Dynamics 2 Magnetoplasma Dynamics 3 Waves in Magnetoplasmas 4 Magnetoplasma Stability 5 Transport in Magnetoplasmas 6 Extensions of Theory Bibliography Index

Nuclear fusion

Abstract: The advantages of nuclear fusion as an energy source and research progress in this area are summarized. The current state of the art is described. Laser fusion, inertial confinement fusion, and magnetic fusion (the tokamak) are explained, the latter in some detail. Remaining problems and planned future reactors are considered. They are the Compact Ignition Tokamak (CIT), the International Thermonuclear Experimental Reactor (ITER), and a US design called TIBER II. The design of the latter is shown. >