Author
Jacopo Buongiorno
Other affiliations: Electric Power Research Institute, Tokyo Electric Power Company
Bio: Jacopo Buongiorno is an academic researcher from Massachusetts Institute of Technology. The author has contributed to research in topics: Boiling & Nanofluid. The author has an hindex of 40, co-authored 170 publications receiving 12125 citations. Previous affiliations of Jacopo Buongiorno include Electric Power Research Institute & Tokyo Electric Power Company.
Topics: Boiling, Nanofluid, Critical heat flux, Nucleate boiling, Heat transfer
Papers published on a yearly basis
Papers
More filters
TL;DR: Transient hot-wire data on thermal conductivity of suspensions of silica and perfluorinated particles show agreement with the mean-field theory of Maxwell but not with the recently postulated microconvection mechanism.
Abstract: Transient hot-wire data on thermal conductivity of suspensions of silica and perfluorinated particles show agreement with the mean-field theory of Maxwell but not with the recently postulated microconvection mechanism. The influence of interfacial thermal resistance, convective effects at microscales, and the possibility of thermal conductivity enhancements beyond the Maxwell limit are discussed.
160 citations
TL;DR: In this article, it was shown that the addition of alumina, zinc-oxide, and diamond particles can enhance the critical heat flux (CHF) limit of water inflow boiling.
Abstract: It is shown that addition of alumina, zinc-oxide, and diamond particles can enhance the critical heat flux (CHF) limit of water inflow boiling. The particles used here were in the nanometer range (<100 nm) and at low concentration (≤0.1 vol %). The CHF tests were conducted at 0.1 MPa and at three different mass fluxes (1500 kg/m 2 s, 2000 kg/m 2 s, and 2500 kg/m 2 s). The thermal conditions at CHF were subcooled. The maximum CHF enhancement was 53%, 53%, and 38% for alumina, zinc oxide, and diamond, respectively, always obtained at the highest mass flux. A postmortem analysis of the boiling surface reveals that its morphology is altered by deposition of the particles during boiling. Additionally, the wettability of the surface is substantially increased, which seems to correlate well with the observed CHF enhancement.
144 citations
01 Oct 2011
TL;DR: In this paper, the authors used differential scanning calorimetry (DSC), a robust experimental methodology for measuring the heat capacity of fluids, the specific heat capacities of water-based silica, alumina, and copper oxide nanofluids were measured.
Abstract: Nanofluids are being considered for heat transfer applications; therefore it is important to know their thermophysical properties accurately. In this paper we focused on nanofluid specific heat capacity. Currently, there exist two models to predict a nanofluid specific heat capacity as a function of nanoparticle concentration and material. Model I is a straight volume-weighted average; Model II is based on the assumption of thermal equilibrium between the particles and the surrounding fluid. These two models give significantly different predictions for a given system. Using differential scanning calorimetry (DSC), a robust experimental methodology for measuring the heat capacity of fluids, the specific heat capacities of water-based silica, alumina, and copper oxide nanofluids were measured. Nanoparticle concentrations were varied between 5 wt% and 50 wt%. Test results were found to be in excellent agreement with Model II, while the predictions of Model I deviated very significantly from the data. Therefo...
142 citations
TL;DR: In this paper, the authors used differential scanning calorimetry (DSC), a robust experimental methodology for measuring the heat capacity of fluids, the specific heat capacities of water-based silica, alumina, and copper oxide nanofluids were measured.
Abstract: Nanofluids are being considered for heat transfer applications; therefore it is important to know their thermophysical properties accurately. In this paper we focused on nanofluid specific heat capacity. Currently, there exist two models to predict a nanofluid specific heat capacity as a function of nanoparticle concentration and material. Model I is a straight volume-weighted average; Model II is based on the assumption of thermal equilibrium between the particles and the surrounding fluid. These two models give significantly different predictions for a given system. Using differential scanning calorimetry (DSC), a robust experimental methodology for measuring the heat capacity of fluids, the specific heat capacities of water-based silica, alumina, and copper oxide nanofluids were measured. Nanoparticle concentrations were varied between 5 wt% and 50 wt%. Test results were found to be in excellent agreement with Model II, while the predictions of Model I deviated very significantly from the data. Therefo...
142 citations
TL;DR: In this paper, the authors explored the design of the injection system with risk-informed analyses and computational fluid dynamics, and determined that the system has a reasonably low failure probability, and that, once injected, the nanofluid would be delivered effectively to the reactor vessel surface within seconds.
134 citations
Cited by
More filters
01 Jan 2015
TL;DR: The work of the IPCC Working Group III 5th Assessment report as mentioned in this paper is a comprehensive, objective and policy neutral assessment of the current scientific knowledge on mitigating climate change, which has been extensively reviewed by experts and governments to ensure quality and comprehensiveness.
Abstract: The talk with present the key results of the IPCC Working Group III 5th assessment report. Concluding four years of intense scientific collaboration by hundreds of authors from around the world, the report responds to the request of the world's governments for a comprehensive, objective and policy neutral assessment of the current scientific knowledge on mitigating climate change. The report has been extensively reviewed by experts and governments to ensure quality and comprehensiveness.
3,224 citations
[...]
01 Jan 1982
TL;DR: In this article, the authors discuss leading problems linked to energy that the world is now confronting and propose some ideas concerning possible solutions, and conclude that it is necessary to pursue actively the development of coal, natural gas, and nuclear power.
Abstract: This chapter discusses leading problems linked to energy that the world is now confronting and to propose some ideas concerning possible solutions. Oil deserves special attention among all energy sources. Since the beginning of 1981, it has merely been continuing and enhancing the downward movement in consumption and prices caused by excessive rises, especially for light crudes such as those from Africa, and the slowing down of worldwide economic growth. Densely-populated oil-producing countries need to produce to live, to pay for their food and their equipment. If the economic growth of the industrialized countries were to be 4%, even if investment in the rational use of energy were pushed to the limit and the development of nonpetroleum energy sources were also pursued actively, it would be extremely difficult to prevent a sharp rise in prices. It is evident that it is absolutely necessary to pursue actively the development of coal, natural gas, and nuclear power if a physical shortage of energy is not to block economic growth.
2,283 citations
TL;DR: In this article, a similarity solution is presented which depends on the Prandtl number Pr, Lewis number Le, Brownian motion number Nb and thermophoresis number Nt.
1,565 citations
TL;DR: In this article, the authors summarized the recent progress on the study of nanofluids, such as the preparation methods, the evaluation methods for the stability of nanometrics, and the ways to enhance the stability for nanofl fluids, and presented the broad range of current and future applications in various fields including energy and mechanical and biomedical fields.
Abstract: Nanofluids, the fluid suspensions of nanomaterials, have shown many interesting properties, and the distinctive features offer unprecedented potential for many applications. This paper summarizes the recent progress on the study of nanofluids, such as the preparation methods, the evaluation methods for the stability of nanofluids, and the ways to enhance the stability for nanofluids, the stability mechanisms of nanofluids, and presents the broad range of current and future applications in various fields including energy and mechanical and biomedical fields. At last, the paper identifies the opportunities for future research.
1,320 citations