James D. Iversen

Bio: James D. Iversen is an academic researcher from Iowa State University. The author has contributed to research in topics: Wind tunnel & Saltation (geology). The author has an hindex of 28, co-authored 66 publications receiving 3495 citations.

Dust storms on Mars: Considerations and simulations

Abstract: Aeolian processes are important in modifying the surface of Mars at present, and appear to have been significant in the geological past. Aeolian activity includes local and global dust storms, the formation of erosional features such as yardangs and depositional features such as sand dunes, and the erosion of rock and soil. As a means of understanding aeolian processes on Mars, an investigation is in progress that includes laboratory simulations, field studies of earth analogs, and interpretation of spacecraft data. This report describes the Martian Surface Wind Tunnel, an experimental facility established at NASA-Ames Research Center, and presents some results of the general investigation. Experiments dealing with wind speeds and other conditions required for the initiation of particle movement on Mars are described and considerations are given to the resulting effectiveness of aeolian erosion.

Dynamics of lava flow: Thickness growth characteristics of steady two-dimensional flow

Abstract: The thickness growth characteristics of flowing lava are investigated using a heat balance model and a two-dimensional model for flow of a Bingham plastic fluid down an inclined plane. It is found that yield strength plays a crucial role in the thickening of a lava flow of given flow rate. To illustrate this point, downstream thickness profiles and yield strength distributions were calculated for flows with mass flow rates of 10,000 and 100,000 kg/m-sec. Higher flow rates led to slow cooling rates which resulted in slow rate of increase of yield strength and thus greater flow lengths.

Estimated grain saltation in a Martian atmosphere

Abstract: Mariner 9 spacecraft images showing evidence of variable surface features and surface erosion resulting from atmospheric wind on Mars have caused a renewed interest in the eolian mechanics of saltating grains. To study this phenomenon, both experimental investigation in an atmospheric wind tunnel and numerical solutions of the equations of motion of a single grain under Martian surface conditions were conducted. The numerical solutions for earth were used and empirically adjusted to correlate with existing experimental data for Mars. These modified equations were then solved to estimate grain motion for Mars. These calculations show the importance of a lifting force on the grain to initiate motion in both earth and Mars calculations. Major findings include a comparison of earth and Mars grain trajectories that show Mars length scales to be longer and to fall with a higher terminal grain velocity. The grains in the Mars calculation also made a smaller collision angle with the surface on rebound.

Sources and distributions of dust aerosols simulated with the GOCART model

Abstract: The global distribution of dust aerosol is simulated with the Georgia Tech/Goddard Global Ozone Chemistry Aerosol Radiation and Transport (GOCART) model. In this model all topographic lows with bare ground surface are assumed to have accumulated sediments which are potential dust sources. The uplifting of dust particles is expressed as a function of surface wind speed and wetness. The GOCART model is driven by the assimilated meteorological fields from the Goddard Earth Observing System Data Assimilation System (GEOS DAS) which facilitates direct comparison with observations. The model includes seven size classes of mineral dust ranging from 0.1–6 μm radius. The total annual emission is estimated to be between 1604 and 1960 Tg yr−1 in a 5-year simulation. The model has been evaluated by comparing simulation results with ground-based measurements and satellite data. The evaluation has been performed by comparing surface concentrations, vertical distributions, deposition rates, optical thickness, and size distributions. The comparisons show that the model results generally agree with the observations without the necessity of invoking any contribution from anthropogenic disturbances to soils. However, the model overpredicts the transport of dust from the Asian sources to the North Pacific. This discrepancy is attributed to an overestimate of small particle emission from the Asian sources.

Modeling the atmospheric dust cycle: 1. Design of a soil-derived dust emission scheme

Abstract: A soil-derived dust emission scheme has been designed to provide an explicit representation of the desert dust sources for the atmospheric transport models dealing with the simulation of the desert dust cycle. Two major factors characterizing the erodible surface are considered: (1) the size distribution of the erodible loose particles of the soil which controls the erosion threshold and the emission strength and (2) the surface roughness which imposes the efficient wind friction velocity acting on the erodible surface. These two parameters are included in a formulation of the threshold wind friction velocity by adapting a size-dependent parameterization proposed by Iversen and White (1982) and by applying to the rough erodible surfaces a drag partition scheme derived from Arya (1975). This parameterization of the threshold friction velocity has been included in an horizontal flux equation proposed by White (1979). This allows to attribute a specific production rate to each soil size range for each type of surface. The dust flux F is then considered as a fraction of the total horizontal flux G, the value of the ratio F/G being imposed, at this time, by the soil clay content. In summary, the computed mass fluxes depend on the soil size distribution, the roughness lengths, and the wind friction velocity. The different steps of this scheme have been independently validated by comparison with relevant experimental data. Globally, the agreement is satisfying, so that the dust fluxes could be retrieved with less uncertainties than those observed in previous simulations of the desert dust cycle.

The physics of wind-blown sand and dust

Abstract: The transport of sand and dust by wind is a potent erosional force, creates sand dunes and ripples, and loads the atmosphere with suspended dust aerosols This article presents an extensive review of the physics of wind-blown sand and dust on Earth and Mars Specifically, we review the physics of aeolian saltation, the formation and development of sand dunes and ripples, the physics of dust aerosol emission, the weather phenomena that trigger dust storms, and the lifting of dust by dust devils and other small-scale vortices We also discuss the physics of wind-blown sand and dune formation on Venus and Titan

Context Camera Investigation on board the Mars Reconnaissance Orbiter

Abstract: [1] The Context Camera (CTX) on the Mars Reconnaissance Orbiter (MRO) is a Facility Instrument (i.e., government-furnished equipment operated by a science team not responsible for design and fabrication) designed, built, and operated by Malin Space Science Systems and the MRO Mars Color Imager team (MARCI). CTX will (1) provide context images for data acquired by other MRO instruments, (2) observe features of interest to NASA's Mars Exploration Program (e.g., candidate landing sites), and (3) conduct a scientific investigation, led by the MARCI team, of geologic, geomorphic, and meteorological processes on Mars. CTX consists of a digital electronics assembly; a 350 mm f/3.25 Schmidt-type telescope of catadioptric optical design with a 5.7° field of view, providing a ∼30-km-wide swath from ∼290 km altitude; and a 5000-element CCD with a band pass of 500–700 nm and 7 μm pixels, giving ∼6 m/pixel spatial resolution from MRO's nearly circular, nearly polar mapping orbit. Raw data are transferred to the MRO spacecraft flight computer for processing (e.g., data compression) before transmission to Earth. The ground data system and operations are based on 9 years of Mars Global Surveyor Mars Orbiter Camera on-orbit experience. CTX has been allocated 12% of the total MRO data return, or about ≥3 terabits for the nominal mission. This data volume would cover ∼9% of Mars at 6 m/pixel, but overlapping images (for stereo, mosaics, and observation of changes and meteorological events) will reduce this area. CTX acquired its first (instrument checkout) images of Mars on 24 March 2006.

The physics of wind-blown sand and dust

Abstract: The transport of sand and dust by wind is a potent erosional force, creates sand dunes and ripples, and loads the atmosphere with suspended dust aerosols. This paper presents an extensive review of the physics of wind-blown sand and dust on Earth and Mars. Specifically, we review the physics of aeolian saltation, the formation and development of sand dunes and ripples, the physics of dust aerosol emission, the weather phenomena that trigger dust storms, and the lifting of dust by dust devils and other small-scale vortices. We also discuss the physics of wind-blown sand and dune formation on Venus and Titan.