James E. Pacheco

Bio: James E. Pacheco is an academic researcher from Sandia National Laboratories. The author has contributed to research in topics: Thermal energy storage & Solar energy. The author has an hindex of 15, co-authored 20 publications receiving 2082 citations.

Development of a Molten-Salt Thermocline Thermal Storage System for Parabolic Trough Plants

Abstract: Thermal storage improves the dispatchability and marketability of parabolic trough power plants allowing them to produce electricity on demand independent of solar collection. One such thermal storage system, a thermocline, uses a single tank containing a fluid with a thermal gradient running vertically through the tank, where hotter fluid (lower density) is at the top of the tank and colder fluid is at the base of the tank. The thermal gradient separates the two temperature potentials. A low-cost filler material provides the bulk of the thermal capacitance of the thermal storage, prevents convective mixing, and reduces the amount of fluid required. In this paper, development of a thermocline system that uses molten-nitrate salt as the heat transfer fluid is described and compared to a two-tank molten salt system. Results of isothermal and thermal cycling tests on candidate materials and salt safety tests are presented as well as results from a small pilot-scale (2.3 MWh) thermocline.

Assessment of a Molten Salt Heat Transfer Fluid in a Parabolic Trough Solar Field

Abstract: An evaluation was carried out to investigate the feasibility of utilizing a molten salt as the heat transfer fluid (HTF) and for thermal storage in a parabolic trough solar field to improve system performance and to reduce the levelized electricity cost. The operating SEGS (Solar Electric Generating Systems located in Mojave Desert, California) plants currently use a high temperature synthetic oil consisting of a eutectic mixture of biphenyl/ diphenyl oxide. The scope of this investigation included examination of known critical issues, postulating solutions or possible approaches where potential problems exist, and the quantification of performance and electricity cost using preliminary cost inputs. The two leading candidates were the so-called solar salt (a binary salt consisting of 60% NaNO 3 and 40% KNO 3 ) and a salt sold commercially as HitecXL (a ternary salt consisting of 48% Ca(NO 3 ) 2 , 7% NaNO 3 , and 45% KNO 3 ). Assuming a two-tank storage system and a maximum operation temperature of 450°C, the evaluation showed that the levelized electricity cost can be reduced by 14.2% compared to a state-of-the-art parabolic trough plant such as the SEGS plants. If higher temperatures are possible, the improvement may be as high as 17.6%. Thermocline salt storage systems offer even greater benefits.

An Update on Solar Central Receiver Systems, Projects, and Technologies

Abstract: Central Receiver Systems that use large heliostat fields and solar receivers located on top of a tower are now in the position to deploy the first generation of grid-connected commercial plants. The technical feasibility of the CRS power plants technology can be valued as sufficiently mature after the pioneering experience at the early 1980s of several pilot plants in the 0.5-10 MW power range and the subsequent improvement of key components like heliostats and solar receiver in many projects merging international collaboration during the past 15 years. Solar-only plants like Solar Tres and PS10 or hybrid schemes like SOLGAS, CONSOLAR, or SOLGATE are being developed and supply a portfolio of alternatives leading to the first scaling-up plants during the period 2000-2010. Those projects with still non-optimized small sizes of 10-15 MW are already revealing a dramatic reduction of costs versus previous feasibility studies and give the path for the formulation of a realistic milestone of achieving a LEC of $0.08/kWh by the year 2010 and penetrating initial competitive markets by 2015 with LECs between $0.04/kWh-$0.06/kWh.

Final Test and Evaluation Results from the Solar Two Project

Abstract: Solar Two was a collaborative, cost-shared project between 11 U. S. industry and utility partners and the U. S. Department of Energy to validate molten-salt power tower technology. The Solar Two plant, located east of Barstow, CA, comprised 1926 heliostats, a receiver, a thermal storage system, a steam generation system, and steam-turbine power block. Molten nitrate salt was used as the heat transfer fluid and storage media. The steam generator powered a 10-MWe (megawatt electric), conventional Rankine cycle turbine. Solar Two operated from June 1996 to April 1999. The major objective of the test and evaluation phase of the project was to validate the technical characteristics of a molten salt power tower. This report describes the significant results from the test and evaluation activities, the operating experience of each major system, and overall plant performance. Tests were conducted to measure the power output (MW) of the each major system, the efficiencies of the heliostat, receiver, thermal storage, and electric power generation systems and the daily energy collected, daily thermal-to-electric conversion, and daily parasitic energy consumption. Also included are detailed test and evaluation reports.

State of the art on high temperature thermal energy storage for power generation. Part 1—Concepts, materials and modellization

Abstract: Concentrated solar thermal power generation is becoming a very attractive renewable energy production system among all the different renewable options, as it has have a better potential for dispatchability. This dispatchability is inevitably linked with an efficient and cost-effective thermal storage system. Thus, of all components, thermal storage is a key one. However, it is also one of the less developed. Only a few plants in the world have tested high temperature thermal energy storage systems. In this paper, the different storage concepts are reviewed and classified. All materials considered in literature or plants are listed. And finally, modellization of such systems is reviewed.

High-temperature phase change materials for thermal energy storage

Abstract: The development of energy saving technologies is very actual issue of present day. One of perspective directions in developing these technologies is the thermal energy storage in various industry branches. The review considers the modern state of art in investigations and developments of high-temperature phase change materials perspective for storage thermal and a solar energy in the range of temperatures from 120 to 1000 °C. The considerable quantity of mixes and compositions on the basis of fluorides, chlorides, hydroxides, nitrates, carbonates, vanadates, molybdates and other salts, and also metal alloys is given. Thermophysical properties of potential heat storage salt compositions and metal alloys are presented. Compatibility of heat storage materials (HSM) and constructional materials have found its reflection in the present work. Data on long-term characteristics of some HSMs in the course of repeated cycles of fusion and solidification are analyzed. Article considers also other problems which should be solved for creation of commercial high-temperature heat storage devices with use of phase change materials.