scispace - formally typeset
Search or ask a question
Author

Jan Leys

Bio: Jan Leys is an academic researcher from Katholieke Universiteit Leuven. The author has contributed to research in topics: Phase transition & Phase (matter). The author has an hindex of 18, co-authored 48 publications receiving 1171 citations. Previous affiliations of Jan Leys include University of the Littoral Opal Coast & University of Maryland, College Park.

Papers
More filters
Journal ArticleDOI
TL;DR: The electrical conductivities of 1-alkyl-3-methylimidazolium tetrafluoroborate ionic liquids with different anions were determined in the temperature range between 123 and 393 K on the basis of dielectric measurements in the frequency range from 1 to 10(7) Hz.
Abstract: The electrical conductivities of 1-alkyl-3-methylimidazolium tetrafluoroborate ionic liquids and of 1-hexyl-3-methylimidazolium ionic liquids with different anions were determined in the temperature range between 123 and 393 K on the basis of dielectric measurements in the frequency range from 1 to 10(7) Hz. Most of the ionic liquids form a glass and the conductivity values obey the Vogel-Fulcher-Tammann equation. The glass transition temperatures are increasing with increasing length of the alkyl chain. The fragility is weakly dependent on the alkyl chain length but is highly sensitive to the structure of the anion.

179 citations

Journal ArticleDOI
TL;DR: The phase transition behavior of the liquid crystal dimer α,ω-bis(4,4'-cyanobiphenyl)nonane (CBC9CB), which has been reported to exhibit a nematic-nematic phase transition, has been investigated by means of high-resolution adiabatic scanning calorimetry.
Abstract: The phase transition behavior of the liquid crystal dimer α,ω-bis(4,4'-cyanobiphenyl)nonane (CBC9CB), which has been reported to exhibit a nematic-nematic phase transition, has been investigated by means of high-resolution adiabatic scanning calorimetry. This nematic-nematic phase transition is weakly first-order with a latent heat of 0.24±0.01 kJ kg(-1). Mixtures up to 40 wt % with 4-pentyl-4'-cyanobiphenyl (5CB) liquid crystals have also been investigated, which also show this nematic to nematic phase transition. The transition stays weakly first-order with a decreasing latent heat with increasing concentration of 5CB. For mixtures with more than 40 wt % uniaxial nematic-unknown nematic phase transition was not observed.

96 citations

Journal ArticleDOI
TL;DR: The thermophysical properties of water-choline bistriflimide binary mixtures were studied by a photopyroelectric technique and by adiabatic scanning calorimetry (ASC).
Abstract: The ionic liquid (2-hydroxyethylammonium)trimethylammonium) bis(trifluoromethylsulfonyl)imide (choline bistriflimide) was obtained as a supercooled liquid at room temperature (melting point = 30 °C). Crystals of choline bistriflimide suitable for structure determination were grown from the melt in situ on the X-ray diffractometer. The choline cation adopts a folded conformation, whereas the bistriflimide anion exhibits a transoid conformation. The choline cation and the bistriflimide anion are held together by hydrogen bonds between the hydroxyl proton and a sulfonyl oxygen atom. This hydrogen bonding is of importance for the temperature-dependent solubility properties of the ionic liquid. Choline bistriflimide is not miscible with water at room temperature, but forms one phase with water at temperatures above 72 °C (equals upper critical solution temperature). 1H NMR studies show that the hydrogen bonds between the choline cation and the bistriflimide anion are substantially weakened above this temperatu...

92 citations

Journal ArticleDOI
TL;DR: It is investigated whether phase separation in polymer blends can be used as a tool to create well dispersed conducting filler rich domains in 3D with controlled morphology, potentially resulting in more effective percolation.
Abstract: Conducting polymeric materials with stable phase microstructures have a range of potential applications. In this work, it is investigated whether phase separation in polymer blends can be used as a tool to create well dispersed conducting filler rich domains in 3D with controlled morphology, potentially resulting in more effective percolation. The effect of amine functionalized multiwall carbon nanotubes (NH2-MWCNTs) on the thermally induced phase separation processes in poly[(α-methyl styrene)-co-acrylonitrile]/poly(methyl methacrylate) (PαMSAN/PMMA) blends was monitored by melt rheology, conductivity spectroscopy, and microscopic techniques. Electron microscopic images revealed that the phase separation resulted in a heterogeneous distribution of NH2-MWCNTs in the blends. The migration of NH2-MWCNTs is controlled by the thermodynamic forces that drive phase separation and led to an increase in their local concentration in a specific phase resulting in percolative “network-like” structure. Conductivity s...

90 citations

Journal ArticleDOI
TL;DR: No correlation between the strength of the NI transition of a given compound and the pretransitional effects observed is found, neither dielectrically, nor thermally.
Abstract: The classification of phase transitions in first-order and second-order (or continuous) ones is widely used. The nematic-to-isotropic (NI) transition in liquid crystals is a weakly first-order transition, with only small discontinuities in enthalpy and specific volume at the transition which are not always easy to measure. On the other hand, fluctuation effects near the transition, typical for a continuous transition, are present because of the only weakly first-order character. In a recent paper [Phys. Rev. E 69, 022701 (2004)], it was concluded from the static dielectric permittivity in the isotropic phase near the NI transition that less polar mesogens (with little or no pretransitional effects) are characteristic for a first-order NI phase transition, whereas in the case of strongly polar ones (with large pretransitional effects) the NI transition is close to second order. In this paper, we address the question whether it is, indeed, possible to use these fluctuation effects in the isotropic phase to quantify the "strength" of a weakly first-order transition, i.e., how far it is from second order. Therefore, we measured the temperature dependence of the enthalpy near the NI transition of seven liquid crystals with adiabatic scanning calorimetry and compared the measured values of the latent heat with pretransitional effects in the dielectric constant and the specific heat capacity. The compounds used in the comparison are MBBA, 5CB, 8CB, 5NCS, 5CN, 8CHBT, and D7AB. From our analysis we find, contrary to the assertion in the above reference, no correlation between the strength of the NI transition of a given compound and the pretransitional effects observed, neither dielectrically, nor thermally.

68 citations


Cited by
More filters
Journal ArticleDOI
01 Apr 1988-Nature
TL;DR: In this paper, a sedimentological core and petrographic characterisation of samples from eleven boreholes from the Lower Carboniferous of Bowland Basin (Northwest England) is presented.
Abstract: Deposits of clastic carbonate-dominated (calciclastic) sedimentary slope systems in the rock record have been identified mostly as linearly-consistent carbonate apron deposits, even though most ancient clastic carbonate slope deposits fit the submarine fan systems better. Calciclastic submarine fans are consequently rarely described and are poorly understood. Subsequently, very little is known especially in mud-dominated calciclastic submarine fan systems. Presented in this study are a sedimentological core and petrographic characterisation of samples from eleven boreholes from the Lower Carboniferous of Bowland Basin (Northwest England) that reveals a >250 m thick calciturbidite complex deposited in a calciclastic submarine fan setting. Seven facies are recognised from core and thin section characterisation and are grouped into three carbonate turbidite sequences. They include: 1) Calciturbidites, comprising mostly of highto low-density, wavy-laminated bioclast-rich facies; 2) low-density densite mudstones which are characterised by planar laminated and unlaminated muddominated facies; and 3) Calcidebrites which are muddy or hyper-concentrated debrisflow deposits occurring as poorly-sorted, chaotic, mud-supported floatstones. These

9,929 citations

Journal ArticleDOI
22 Jun 2010-ACS Nano
TL;DR: The present review critically investigates to what extent self-assembly can be directed, enhanced, or controlled by either changing the energy or entropy landscapes, using templates or applying external fields.
Abstract: Within the field of nanotechnology, nanoparticles are one of the most prominent and promising candidates for technological applications. Self-assembly of nanoparticles has been identified as an important process where the building blocks spontaneously organize into ordered structures by thermodynamic and other constraints. However, in order to successfully exploit nanoparticle self-assembly in technological applications and to ensure efficient scale-up, a high level of direction and control is required. The present review critically investigates to what extent self-assembly can be directed, enhanced, or controlled by either changing the energy or entropy landscapes, using templates or applying external fields.

1,938 citations

Journal ArticleDOI
TL;DR: One of the advantages of RTILs as compared to their high-temperature molten salt (HTMS) “sister-systems” is that the dissolved molecules are not imbedded in a harsh high temperature environment which could be destructive for many classes of fragile (organic) molecules.
Abstract: Until recently, “room-temperature” (<100–150 °C) liquid-state electrochemistry was mostly electrochemistry of diluted electrolytes(1)–(4) where dissolved salt ions were surrounded by a considerable amount of solvent molecules. Highly concentrated liquid electrolytes were mostly considered in the narrow (albeit important) niche of high-temperature electrochemistry of molten inorganic salts(5-9) and in the even narrower niche of “first-generation” room temperature ionic liquids, RTILs (such as chloro-aluminates and alkylammonium nitrates).(10-14) The situation has changed dramatically in the 2000s after the discovery of new moisture- and temperature-stable RTILs.(15, 16) These days, the “later generation” RTILs attracted wide attention within the electrochemical community.(17-31) Indeed, RTILs, as a class of compounds, possess a unique combination of properties (high charge density, electrochemical stability, low/negligible volatility, tunable polarity, etc.) that make them very attractive substances from fundamental and application points of view.(32-38) Most importantly, they can mix with each other in “cocktails” of one’s choice to acquire the desired properties (e.g., wider temperature range of the liquid phase(39, 40)) and can serve as almost “universal” solvents.(37, 41, 42) It is worth noting here one of the advantages of RTILs as compared to their high-temperature molten salt (HTMS)(43) “sister-systems”.(44) In RTILs the dissolved molecules are not imbedded in a harsh high temperature environment which could be destructive for many classes of fragile (organic) molecules.

1,076 citations

Journal ArticleDOI
TL;DR: The discussion is focused on low molar mass and dendrimeric thermotropic ionic mesogens, as well as selected metal-containing compounds (metallomesogens), but some references to polymeric and/or lyotropic ionIC liquid crystals and particularly to ionic liquids will also be provided.
Abstract: This Review covers the recent developments (2005-2015) in the design, synthesis, characterization, and application of thermotropic ionic liquid crystals. It was designed to give a comprehensive overview of the "state-of-the-art" in the field. The discussion is focused on low molar mass and dendrimeric thermotropic ionic mesogens, as well as selected metal-containing compounds (metallomesogens), but some references to polymeric and/or lyotropic ionic liquid crystals and particularly to ionic liquids will also be provided. Although zwitterionic and mesoionic mesogens are also treated to some extent, emphasis will be directed toward liquid-crystalline materials consisting of organic cations and organic/inorganic anions that are not covalently bound but interact via electrostatic and other noncovalent interactions.

563 citations

Journal ArticleDOI
TL;DR: Graphene is a potential nanofiller that can dramatically improve the properties of polymer-based composites at a very low loading as mentioned in this paper, which can improve tensile strength and elastic modulus, electrical and thermal conductivity.
Abstract: Graphene is a potential nanofiller that can dramatically improve the properties of polymer-based composites at a very low loading. This article reviews the state-of-the-art progress in the fabrication, properties, and uses of polymer composites with different kinds of graphene fillers. The results so far reported in the literature indicate that graphene/polymer composites are promising multifunctional materials with significantly improved tensile strength and elastic modulus, electrical and thermal conductivity, etc. Despite some challenges and the fact that carbon naotube/polymer composites are sometimes better in some particular performance, graphene/polymer composites may have wide potential applications due to their outstanding properties and the availability of graphene in a large quantity at low cost.

551 citations