Author
John W. Palmour
Other affiliations: Cree Inc., Ioffe Institute
Bio: John W. Palmour is an academic researcher from Durham University. The author has contributed to research in topics: Silicon carbide & Diode. The author has an hindex of 46, co-authored 202 publications receiving 8835 citations. Previous affiliations of John W. Palmour include Cree Inc. & Ioffe Institute.
Papers published on a yearly basis
Papers
More filters
••
TL;DR: In this article, the authors demonstrate that the effective channel mobility of lateral, inversion-mode 4H-SiC MOSFETs is increased significantly after passivation of SiC/SiO/sub 2/ interface states near the conduction band edge by high temperature anneals in nitric oxide.
Abstract: Results presented in this letter demonstrate that the effective channel mobility of lateral, inversion-mode 4H-SiC MOSFETs is increased significantly after passivation of SiC/SiO/sub 2/ interface states near the conduction band edge by high temperature anneals in nitric oxide. Hi-lo capacitance-voltage (C-V) and ac conductance measurements indicate that, at 0.1 eV below the conduction band edge, the interface trap density decreases from approximately 2/spl times/10/sup 13/ to 2/spl times/10/sup 12/ eV/sup -1/ cm/sup -2/ following anneals in nitric oxide at 1175/spl deg/C for 2 h. The effective channel mobility for MOSFETs fabricated with either wet or dry oxides increases by an order of magnitude to approximately 30-35 cm/sup 2//V-s following the passivation anneals.
590 citations
••
TL;DR: In this paper, the performance of high-power GaN/Al/sub 0.86/N high-electron mobility transistors (HEMTs) fabricated on semi-insulating (SI) 4H-SiC substrates is reported.
Abstract: Record performance of high-power GaN/Al/sub 0.14/-Ga/sub 0.86/N high-electron mobility transistors (HEMTs) fabricated on semi-insulating (SI) 4H-SiC substrates is reported. Devices of 0.125-0.25 mm gate periphery show high CW power densities between 5.3 and 6.9 W/mm, with a typical power-added efficiency (PAE) of 35.4% and an associated gain of 9.2 dB at 10 GHz. High-electron mobility transistors with 1.5-mm gate widths (12/spl times/125 /spl mu/m), measured on-wafer, exhibit a total output power of 3.9 W CW (2.6 W/mm) at 10 GHz with a PAE of 29% and an associated gain of 10 dB at the -2 dB compression point. A 3-mm HEMT, packaged with a hybrid matching circuit, demonstrated 9.1 W CW at 7.4 GHz with a PAE of 29.6% and a gain of 7.1 dB. These data represent the highest power density, total power, and associated gain demonstrated for a III-nitride HEMT under RF drive.
506 citations
••
TL;DR: In this article, the authors review the evolution of SiC power MOSFETs between 1992 and the present, discuss the current status of device development, identify the critical fabrication issues, and assess the prospects for continued progress and eventual commercialization.
Abstract: SiC electronic device technology has made rapid progress during the past decade In this paper, we review the evolution of SiC power MOSFETs between 1992 and the present, discuss the current status of device development, identify the critical fabrication issues, and assess the prospects for continued progress and eventual commercialization
438 citations
••
TL;DR: In this paper, a wide variety of SiC devices are compared to that of similar Si and GaAs devices and to theoretically expected results, and the performance of these devices is compared to the expected results.
Abstract: In recent years, silicon carbide has received increased attention because of its potential for high-power devices. The unique material properties of SiC, high electric breakdown field, high saturated electron drift velocity, and high thermal conductivity are what give this material its tremendous potential in the power device arena. 4H-SiC Schottky barrier diodes (1400 V) with forward current densities over 700 A/cm/sup 2/ at 2 V have been demonstrated. Packaged SITs have produced 57 W of output power at 500 MHz, SiC UMOSFETs (1200 V) are projected to have 15 times the current density of Si IGBTs (1200 V). Submicron gate length 4H-SiC MESFETs have achieved f/sub max/=32 GHz, f/sub T/=14.0 GHz, and power density=2.8 W/mm @ 1.8 GHz. The performances of a wide variety of SiC devices are compared to that of similar Si and GaAs devices and to theoretically expected results.
427 citations
•
06 Aug 1990TL;DR: In this paper, a substantially planar surface on a monocrystalline silicon carbide crystal is formed by exposing the substantiallyplanar surface to an etching plasma until any surface or subsurface damage caused by any mechanical preparation of the surface is substantially removed.
Abstract: The invention is a method of forming a substantially planar surface on a monocrystalline silicon carbide crystal by exposing the substantially planar surface to an etching plasma until any surface or subsurface damage caused by any mechanical preparation of the surface is substantially removed. The etch is limited, however, to a time period less than that over which the plasma etch will develop new defects in the surface or aggravate existing ones, and while using a plasma gas and electrode system that do not themselves aggravate or cause substantial defects in the surface.
408 citations
Cited by
More filters
••
University of Cambridge1, Istituto Italiano di Tecnologia2, Lancaster University3, University of Manchester4, Catalan Institution for Research and Advanced Studies5, Technical University of Denmark6, Nokia7, Queen Mary University of London8, fondazione bruno kessler9, University of Trento10, Technische Universität München11, Polytechnic University of Milan12, Centre national de la recherche scientifique13, University of Trieste14, University of Ioannina15, University of Geneva16, Trinity College, Dublin17, Texas Instruments18, University of Paris19, Spanish National Research Council20, Leiden University21, Delft University of Technology22, University of Patras23, École Normale Supérieure24, Radboud University Nijmegen25, Nest Labs26, Airbus UK27, Seoul National University28, Yonsei University29, University of Oxford30, Chalmers University of Technology31, University of Groningen32, STMicroelectronics33, Chemnitz University of Technology34, Max Planck Society35, Aalto University36
TL;DR: An overview of the key aspects of graphene and related materials, ranging from fundamental research challenges to a variety of applications in a large number of sectors, highlighting the steps necessary to take GRMs from a state of raw potential to a point where they might revolutionize multiple industries are provided.
Abstract: We present the science and technology roadmap for graphene, related two-dimensional crystals, and hybrid systems, targeting an evolution in technology, that might lead to impacts and benefits reaching into most areas of society. This roadmap was developed within the framework of the European Graphene Flagship and outlines the main targets and research areas as best understood at the start of this ambitious project. We provide an overview of the key aspects of graphene and related materials (GRMs), ranging from fundamental research challenges to a variety of applications in a large number of sectors, highlighting the steps necessary to take GRMs from a state of raw potential to a point where they might revolutionize multiple industries. We also define an extensive list of acronyms in an effort to standardize the nomenclature in this emerging field.
2,560 citations
••
TL;DR: In this article, the authors compare the performance of SiC, GaN, and ZnSe for high-temperature electronics and short-wavelength optical applications and conclude that SiC is the leading contender for high temperature and high power applications if ohmic contacts and interface state densities can be further improved.
Abstract: In the past several years, research in each of the wide‐band‐gap semiconductors, SiC, GaN, and ZnSe, has led to major advances which now make them viable for device applications. The merits of each contender for high‐temperature electronics and short‐wavelength optical applications are compared. The outstanding thermal and chemical stability of SiC and GaN should enable them to operate at high temperatures and in hostile environments, and also make them attractive for high‐power operation. The present advanced stage of development of SiC substrates and metal‐oxide‐semiconductor technology makes SiC the leading contender for high‐temperature and high‐power applications if ohmic contacts and interface‐state densities can be further improved. GaN, despite fundamentally superior electronic properties and better ohmic contact resistances, must overcome the lack of an ideal substrate material and a relatively advanced SiC infrastructure in order to compete in electronics applications. Prototype transistors have been fabricated from both SiC and GaN, and the microwave characteristics and high‐temperature performance of SiC transistors have been studied. For optical emitters and detectors, ZnSe, SiC, and GaN all have demonstrated operation in the green, blue, or ultraviolet (UV) spectra. Blue SiC light‐emitting diodes (LEDs) have been on the market for several years, joined recently by UV and blue GaN‐based LEDs. These products should find wide use in full color display and other technologies. Promising prototype UV photodetectors have been fabricated from both SiC and GaN. In laser development, ZnSe leads the way with more sophisticated designs having further improved performance being rapidly demonstrated. If the low damage threshold of ZnSe continues to limit practical laser applications, GaN appears poised to become the semiconductor of choice for short‐wavelength lasers in optical memory and other applications. For further development of these materials to be realized, doping densities (especially p type) and ohmic contact technologies have to be improved. Economies of scale need to be realized through the development of larger SiC substrates. Improved substrate materials, ideally GaN itself, need to be aggressively pursued to further develop the GaN‐based material system and enable the fabrication of lasers. ZnSe material quality is already outstanding and now researchers must focus their attention on addressing the short lifetimes of ZnSe‐based lasers to determine whether the material is sufficiently durable for practical laser applications. The problems related to these three wide‐band‐gap semiconductor systems have moved away from materials science toward the device arena, where their technological development can rapidly be brought to maturity.
2,514 citations
••
07 Nov 2002TL;DR: This paper attempts to present the status of the technology and the market with a view of highlighting both the progress and the remaining problems of the AlGaN/GaN high-electron mobility transistor.
Abstract: Wide bandgap semiconductors are extremely attractive for the gamut of power electronics applications from power conditioning to microwave transmitters for communications and radar. Of the various materials and device technologies, the AlGaN/GaN high-electron mobility transistor seems the most promising. This paper attempts to present the status of the technology and the market with a view of highlighting both the progress and the remaining problems.
1,849 citations
••
TL;DR: In this article, a review of recent progresses in the development of SiC- and GaN-based power semiconductor devices together with an overall view of the state of the art of this new device generation is presented.
Abstract: Wide bandgap semiconductors show superior material properties enabling potential power device operation at higher temperatures, voltages, and switching speeds than current Si technology. As a result, a new generation of power devices is being developed for power converter applications in which traditional Si power devices show limited operation. The use of these new power semiconductor devices will allow both an important improvement in the performance of existing power converters and the development of new power converters, accounting for an increase in the efficiency of the electric energy transformations and a more rational use of the electric energy. At present, SiC and GaN are the more promising semiconductor materials for these new power devices as a consequence of their outstanding properties, commercial availability of starting material, and maturity of their technological processes. This paper presents a review of recent progresses in the development of SiC- and GaN-based power semiconductor devices together with an overall view of the state of the art of this new device generation.
1,648 citations
•
01 Aug 2008
TL;DR: In this article, the oxide semiconductor film has at least a crystallized region in a channel region, which is defined as a region of interest (ROI) for a semiconductor device.
Abstract: An object is to provide a semiconductor device of which a manufacturing process is not complicated and by which cost can be suppressed, by forming a thin film transistor using an oxide semiconductor film typified by zinc oxide, and a manufacturing method thereof. For the semiconductor device, a gate electrode is formed over a substrate; a gate insulating film is formed covering the gate electrode; an oxide semiconductor film is formed over the gate insulating film; and a first conductive film and a second conductive film are formed over the oxide semiconductor film. The oxide semiconductor film has at least a crystallized region in a channel region.
1,501 citations