Joseph W. Perry

Bio: Joseph W. Perry is an academic researcher from Georgia Institute of Technology. The author has contributed to research in topics: Two-photon absorption & Absorption (electromagnetic radiation). The author has an hindex of 66, co-authored 310 publications receiving 23886 citations. Previous affiliations of Joseph W. Perry include University of Arizona & New Mexico Highlands University.

Design of Organic Molecules with Large Two-Photon Absorption Cross Sections

Abstract: A strategy for the design of molecules with large two-photon absorption cross sections, δ, was developed, on the basis of the concept that symmetric charge transfer, from the ends of a conjugated system to the middle, or vice versa, upon excitation is correlated to enhanced values of δ. Synthesized bis(styryl)benzene derivatives with donor-π-donor, donor-acceptor-donor, and acceptor-donor-acceptor structural motifs exhibit exceptionally large values of δ, up to about 400 times that of trans-stilbene. Quantum chemical calculations performed on these molecules indicate that substantial symmetric charge redistribution occurs upon excitation and provide δ values in good agreement with experimental values. The combination of large δ and high fluorescence quantum yield or triplet yield exhibited by molecules developed here offers potential for unprecedented brightness in two-photon fluorescent imaging or enhanced photosensitivity in two-photon sensitization, respectively.

Two-photon polymerization initiators for three-dimensional optical data storage and microfabrication

Abstract: Two-photon excitation provides a means of activating chemical or physical processes with high spatial resolution in three dimensions and has made possible the development of three-dimensional fluorescence imaging1, optical data storage2,3 and lithographic microfabrication4,5,6. These applications take advantage of the fact that the two-photon absorption probability depends quadratically on intensity, so under tight-focusing conditions, the absorption is confined at the focus to a volume of order λ3 (where λ is the laser wavelength). Any subsequent process, such as fluorescence or a photoinduced chemical reaction, is also localized in this small volume. Although three-dimensional data storage and microfabrication have been illustrated using two-photon-initiated polymerization of resins incorporating conventional ultraviolet-absorbing initiators, such photopolymer systems exhibit low photosensitivity as the initiators have small two-photon absorption cross-sections (δ). Consequently, this approach requires high laser power, and its widespread use remains impractical. Here we report on a class of π;-conjugated compounds that exhibit large δ (as high as 1, 250 × 10−50 cm4 s per photon) and enhanced two-photon sensitivity relative to ultraviolet initiators. Two-photon excitable resins based on these new initiators have been developed and used to demonstrate a scheme for three-dimensional data storage which permits fluorescent and refractive read-out, and the fabrication of three-dimensional micro-optical and micromechanical structures, including photonic-bandgap-type structures7.

Two-photon polymerization initiators for three-dimensional optical data storage and microfabrication

Abstract: Two-photon excitation provides a means of activating chemical or physical processes with high spatial resolution in three dimensions and has made possible the development of three-dimensional fluorescence imaging, optical data storage, and lithographic microfabrication. These applications take advantage of the fact that the two-photon absorption probability depends quadratically on intensity, so under tight-focusing conditions, the absorption is confined at the focus to a volume of order λ3 (where λ is the laser wavelength). Any subsequent process, such as fluorescence or a photoinduced chemical reaction, is also localized in this small volume. Although three-dimensional data storage and microfabrication have been illustrated using two-photon-initiated polymerization of resins incorporating conventional ultraviolet-absorbing initiators, such photopolymer systems exhibit low photosensitivity as the initiators have small two-photon absorption cross-sections (δ). Consequently, this approach requires high laser power, and its widespread use remains impractical. Here we report on a class of π;-conjugated compounds that exhibit large δ (as high as 1, 250 × 10−50 cm4 s per photon) and enhanced two-photon sensitivity relative to ultraviolet initiators. Two-photon excitable resins based on these new initiators have been developed and used to demonstrate a scheme for three-dimensional data storage which permits fluorescent and refractive read-out, and the fabrication of three-dimensional micro-optical and micromechanical structures, including photonic-bandgap-type structures.

Structure−Property Relationships for Two-Photon Absorbing Chromophores: Bis-Donor Diphenylpolyene and Bis(styryl)benzene Derivatives

Abstract: The two-photon absorption properties of a series of bis dialkylamino- or diarylamino-substituted diphenylpolyenes and bis(styryl)benzenes have been investigated. Two-photon absorption cross sections, δ, as large as 1420 × 10-50 cm4 s/photon-molecule have been observed for molecules with this general bis-donor structure. The effect of the type and length of the conjugated chain and of dialkylamino or diarylamino substitution on the position and magnitude of the peak two-photon absorptivity is reported. The transition dipole moments for the transitions between the ground state and the first excited singlet state (Mge) and between the first and second excited singlet states (Mee‘) have been estimated using experimental data from the one- and two-photon spectra. It was found that increases in chain length result mainly in an increase in Mge, whereas the addition of donor end groups or going from diphenylpolyene- to phenylene-vinylene-type bridges leads primarily to an increase in Mee‘. The trends in the energ...

An efficient two-photon-generated photoacid applied to positive-tone 3D microfabrication

Abstract: A two-photon-activatable photoacid generator, based on a bis[(diarylamino) styryl]benzene core with covalently attached sulfonium moieties, has been synthesized. The photoacid generator has both a large two-photon absorption cross section (delta = 690 x 10(-50) centimeter(4) second per photon) and a high quantum yield for the photochemical generation of acid (phiH+ = 0.5). Under near-infrared laser irradiation, the molecule produces acid after two-photon excitation and initiates the polymerization of epoxides at an incident intensity that is one to two orders of magnitude lower than that needed for conventional ultraviolet-sensitive initiators. This photoacid generator was used in conjunction with a positive-tone chemically amplified resist for the fabrication of a three-dimensional (3D) microchannel structure.

Aggregation-Induced Emission: Together We Shine, United We Soar!

Abstract: Ju Mei,†,‡,∥ Nelson L. C. Leung,†,‡,∥ Ryan T. K. Kwok,†,‡ Jacky W. Y. Lam,†,‡ and Ben Zhong Tang*,†,‡,§ †HKUST-Shenzhen Research Institute, Hi-Tech Park, Nanshan, Shenzhen 518057, China ‡Department of Chemistry, HKUST Jockey Club Institute for Advanced Study, Institute of Molecular Functional Materials, Division of Biomedical Engineering, State Key Laboratory of Molecular Neuroscience, Division of Life Science, The Hong Kong University of Science and Technology, Clear Water Bay, Kowloon, Hong Kong, China Guangdong Innovative Research Team, SCUT-HKUST Joint Research Laboratory, State Key Laboratory of Luminescent Materials and Devices, South China University of Technology, Guangzhou 510640, China

Flat Optics With Designer Metasurfaces

Abstract: Metamaterials are artificially fabricated materials that allow for the control of light and acoustic waves in a manner that is not possible in nature. This Review covers the recent developments in the study of so-called metasurfaces, which offer the possibility of controlling light with ultrathin, planar optical components. Conventional optical components such as lenses, waveplates and holograms rely on light propagation over distances much larger than the wavelength to shape wavefronts. In this way substantial changes of the amplitude, phase or polarization of light waves are gradually accumulated along the optical path. This Review focuses on recent developments on flat, ultrathin optical components dubbed 'metasurfaces' that produce abrupt changes over the scale of the free-space wavelength in the phase, amplitude and/or polarization of a light beam. Metasurfaces are generally created by assembling arrays of miniature, anisotropic light scatterers (that is, resonators such as optical antennas). The spacing between antennas and their dimensions are much smaller than the wavelength. As a result the metasurfaces, on account of Huygens principle, are able to mould optical wavefronts into arbitrary shapes with subwavelength resolution by introducing spatial variations in the optical response of the light scatterers. Such gradient metasurfaces go beyond the well-established technology of frequency selective surfaces made of periodic structures and are extending to new spectral regions the functionalities of conventional microwave and millimetre-wave transmit-arrays and reflect-arrays. Metasurfaces can also be created by using ultrathin films of materials with large optical losses. By using the controllable abrupt phase shifts associated with reflection or transmission of light waves at the interface between lossy materials, such metasurfaces operate like optically thin cavities that strongly modify the light spectrum. Technology opportunities in various spectral regions and their potential advantages in replacing existing optical components are discussed.

Luminescent Metal–Organic Frameworks

Abstract: Metal–organic frameworks (MOFs) display a wide range of luminescent behaviors resulting from the multifaceted nature of their structure. In this critical review we discuss the origins of MOF luminosity, which include the linker, the coordinated metal ions, antenna effects, excimer and exciplex formation, and guest molecules. The literature describing these effects is comprehensively surveyed, including a categorization of each report according to the type of luminescence observed. Finally, we discuss potential applications of luminescent MOFs. This review will be of interest to researchers and synthetic chemists attempting to design luminescent MOFs, and those engaged in the extension of MOFs to applications such as chemical, biological, and radiation detection, medical imaging, and electro-optical devices (141 references).

Nonlinear magic: multiphoton microscopy in the biosciences

Abstract: Multiphoton microscopy (MPM) has found a niche in the world of biological imaging as the best noninvasive means of fluorescence microscopy in tissue explants and living animals. Coupled with transgenic mouse models of disease and 'smart' genetically encoded fluorescent indicators, its use is now increasing exponentially. Properly applied, it is capable of measuring calcium transients 500 microm deep in a mouse brain, or quantifying blood flow by imaging shadows of blood cells as they race through capillaries. With the multitude of possibilities afforded by variations of nonlinear optics and localized photochemistry, it is possible to image collagen fibrils directly within tissue through nonlinear scattering, or release caged compounds in sub-femtoliter volumes.