The introduction of millimeter wave (mm-wave) frequency bands for cellular communications with significantly larger bandwidths compared to their sub-6 GHz counterparts, the resulting densification of network deployments and the introduction of antenna arrays with beamforming result in major increases in fronthaul capacity required for 5G networks As a result, a radical re-design of the radio access network is required since traditional fronthaul technologies are not scaleable In this article the use of analog radio-over-fiber (ARoF) is proposed and demonstrated as a viable alternative which, combined with space division multiplexing in the optical distribution network as well as photonic integration of the required transceivers, shows a path to a scaleable fronthaul solution for 5G The trade-off between digitized and analog fronthaul is discussed and the ARoF architecture proposed by blueSPACE is introduced Two options for the generation of ARoF two-tone signals for mm-wave generation via optical heterodyning are discussed in detail, including designs for the implementation in photonic integrated circuits as well as measurements of their phase noise performance The proposed photonic integrated circuit designs include the use of both InP and SiN platforms for ARoF signal generation and optical beamforming respectively, proposing a joint design that allows for true multi-beam transmission from a single antenna array Phase noise measurements based on laboratory implementations of ARoF generation based on a Mach–Zehnder modulator with suppressed carrier and with an optical phase-locked loop are presented and the suitability of these transmitters is evaluated though phase noise simulations Finally, the viability of the proposed ARoF fronthaul architecture for the transport of high-bandwidth mm-wave 5G signals is proven with the successful implementation of a real-time transmission link based on an ARoF baseband unit with full real-time processing of extended 5G new radio signals with 800 MHz bandwidth, achieving transmission over 10 km of 7-core single-mode multi-core fiber and 9 m mm-wave wireless at 255 GHz with bit error rates below the limit for a 7% overhead hard decision forward error correction

/pdf/towards-a-scaleable-5g-fronthaul-analog-radio-over-fiber-and-4vnrom4a9o.pdf

Towards a Scaleable 5G Fronthaul: Analog Radio-over-Fiber and Space Division Multiplexing

Fifth-generation mobile networks (5G) are the solution for the demanding mobile traffic requirements, providing technologies that fulfill the requisites of different type of services. The utilization of the millimeter-wave (mm-wave) band is the straightforward technique to achieve high bit rates. Moreover, analog radio-over-fiber (ARoF) brings outstanding benefits such as low cost, low power consumption, and high spectral efficiency, among others. Thereby, mm-wave ARoF is a strong candidate to pave the way for common public radio interface (CPRI) in the fronthaul for the future 5G architecture. As orthogonal frequency-division multiplexing (OFDM) is the adopted waveform in the 5G standard, it should be also utilized in mm-wave ARoF systems for 5G. However, phase noise is one of the most degrading factors in mm-wave OFDM ARoF systems. Therefore, in this work, an analysis of the phase noise is carried out through an experimental setup up. The configuration of this setup enables to gradually modify the final phase noise level of the system. Furthermore, an original and novel algorithm to compensate the phase noise in OFDM receivers is proposed. The performance of this algorithm is experimentally evaluated through the setup for different phase noise levels and different subcarrier spacings. The obtained results show the effectiveness of the proposed algorithm under those conditions, highlighting the viability of mm-wave OFDM ARoF for 5G and beyond.

/pdf/analysis-and-compensation-of-phase-noise-in-mm-wave-ofdm-krlnp7wsv2.pdf

Analysis and Compensation of Phase Noise in Mm-Wave OFDM ARoF Systems for Beyond 5G

Power over fiber (PoF) with sleep mode operation in centralized radio access networks (C-RAN) of low power Remote Radio Heads (RRH) helps to reduce power consumption. This proposal includes bundles of single mode optical fibers (SMF) as part of the 5G C-RAN front-haul solution for providing control on power consumption by selectively activating some parts of the RRH. We experimentally demonstrate a PoF system based on 14.43 km of SMF feed by 2.24 W giving 226 mW electrical power at the RRH for control, battery charge, load operation and communication purposes. A bidirectional control channel is integrated in the central office and the RRH for providing the capability of entering in sleep mode operation and to provide information about the status of the battery and sensing elements at RRH. The optical data uplink/downlink operates over separate optical fibers shared by various RRHs and achieves low power consumption below 33 mW with low data rates. The measured PV cells conversion efficiency is above 30%. The RRH has two sleep modes of operation with a minimum power consumption of 5.8 mW.

/pdf/power-over-fiber-in-c-ran-with-low-power-sleep-mode-remote-2wj3w9s0rq.pdf

Power Over Fiber in C-RAN With Low Power Sleep Mode Remote Nodes Using SMF

This paper presents a beyond 5G fronthaul network with dynamic beamforming and -steering. The proposed fronthaul solution deploys optical beamforming (OBF) by combining space division multiplexing (SDM), analogue radio-over-fiber (ARoF), and the novel optical beam forming network (OBFN) technologies. From the service management and orchestration (MANO) point of view, the proposed fronthaul solution also deploys an advanced software defined networking (SDN) and Network Function Virtualization (NFV) control and orchestration architecture developed with the goal to optimally manage and reconfigure the physical layer resources (i.e., optical and radio) at the central office and cell sites (i.e., pool of baseband units (BBUs), remote radio heads (RRHs), ARoF transceivers and OBFNs). The proposed beyond 5G fronthaul architecture is primarily oriented to deploy massive machine-type communication (mMTC) services with high-bandwidth requirements, such as for industry 4.0. In this paper we experimentally validate the novel OBFN system, and the dynamic SDN/NFV MANO of the transport connectivity and network services for optical beamforming. The obtained experimental results show that the overall delay for the provisioning and removal of an OBF service, considering the contribution of the involved optical and radio systems and the SDN/NFV MANO layer, is 134s and 18s respectively. The reconfiguration of the OBF service to add or remove a beam can be performed in the range of 65–87s.

/pdf/experimental-demonstration-of-dynamic-optical-beamforming-3hv4lj4x38.pdf

Experimental Demonstration of Dynamic Optical Beamforming for Beyond 5G Spatially Multiplexed Fronthaul Networks

We evaluate the impact of Power-over-Fiber (PoF) technology on the fronthaul of a 5G-NR network with an Analog-Radio-over-Fiber at 25.5 GHz on a 10 km long multicore fiber. The study in this Letter analyzes the bit error rate (BER) performance for different levels of energy transmitted by the PoF system. 133 mW of maximum optical power at reception is demonstrated showing negligible BER impact or data transmission BER improvement in a dedicated and shared scenario.

Power-over-fiber in a 10 km long multicore fiber link within a 5G fronthaul scenario

This paper presents an experimental demonstration of analog radio-over-fiber (ARoF) fronthaul for high-bandwidth, high-capacity millimeter wave (mm-wave) extended fifth generation mobile network (5G) new radio (NR) signals over an optical distribution network with optical space division multiplexing (SDM). ARoF is shown to alleviate fronthaul capacity bottlenecks, transporting an 800 MHz wide extended 5G NR signal and allowing to maintain full centralization in a centralized radio access network (C-RAN). The proposed ARoF fronthaul architecture features a transmitter that generates the ARoF signal and an optical signal carrying a reference local oscillator (LO) employed for downconversion at the remote unit (RU) from a single radio frequency (RF) reference at the central office (CO). An SDM based RAN with 7-core multi-core fiber (MCF) allows parallel transport of the uplink ARoF signal and reference LO at the same wavelength over separate cores. Transmission of an 800 MHz wide extended 5G NR fronthaul signal over 7-core MCF is shown with full real-time processing, achieving 1.4 Gbit/s with BER<3.8 × 10−3 and thus below the limit for hard-decision forward error correction (FEC) with 7 % overhead. Downconversion at the RU is performed electrically with the remote-fed LO provided by the CO.

Real-Time Demonstration of ARoF Fronthaul for High-Bandwidth mm-Wave 5G NR Signal Transmission over Multi-Core Fiber

This article presents an experimental demonstration of a high-capacity millimeter-wave 5G NR signal transmission with analog radio-over-fiber (ARoF) fronthaul over multi-core fiber and full real-time processing. The demonstration validates the core of the blueSPACE fronthaul architecture which combines ARoF fronthaul with space division multiplexing in the optical distribution network to alleviate the fronthaul capacity bottleneck and maintain a centralized radio access network with fully centralized signal processing. The introduction of optical beamforming in the blueSPACE architecture brings true multi-beam transmission and enables full spatial control over the RF signal. The proposed ARoF architecture features a transmitter that generates the ARoF signal and an optical signal carrying a reference local oscillator employed for downconversion at the remote unit from a single RF reference at the central office. A space division multiplexing based radio access network with multi-core fibre allows parallel transport of the uplink ARoF signal and reference local oscillator at the same wavelength over separate cores. A complete description of the real-time signal processing and experimental setup is provided and system performance is evaluated. Transmission of an 800 MHz wide extended 5G NR fronthaul signal over a 7-core fibre is shown with full real-time signal processing, achieving 1.4 Gbit/s with a bit error rate $$<3.8\times 10^{-3}$$
 and thus below the limit for hard-decision forward error correction with 7% overhead.

/pdf/real-time-high-bandwidth-mm-wave-5g-nr-signal-transmission-2ej4sn4yg7.pdf

Juliana Barros Carvalho

Papers

Towards a Scaleable 5G Fronthaul: Analog Radio-over-Fiber and Space Division Multiplexing

Real-Time Demonstration of ARoF Fronthaul for High-Bandwidth mm-Wave 5G NR Signal Transmission over Multi-Core Fiber

Real-time high-bandwidth mm-wave 5G NR signal transmission with analog radio-over-fiber fronthaul over multi-core fiber