Juliano G. Hayashi

Bio: Juliano G. Hayashi is an academic researcher from University of Southampton. The author has contributed to research in topics: Optical fiber & Metamaterial. The author has an hindex of 8, co-authored 34 publications receiving 302 citations. Previous affiliations of Juliano G. Hayashi include State University of Campinas & University of Sydney.

Ultrahigh-sensitivity temperature fiber sensor based on multimode interference

Abstract: The proposed sensing device relies on the self-imaging effect that occurs in a pure silica multimode fiber (coreless MMF) section of a single-mode–multimode–single-mode (SMS)-based fiber structure. The influence of the coreless-MMF diameter on the external refractive index (RI) variation permitted the sensing head with the lowest MMF diameter (i.e., 55 μm) to exhibit the maximum sensitivity (2800 nm/RIU). This approach also implied an ultrahigh sensitivity of this fiber device to temperature variations in the liquid RI of 1.43: a maximum sensitivity of −1880 pm/°C was indeed attained. Therefore, the results produced were over 100-fold those of the typical value of approximately 13 pm/°C achieved in air using a similar device. Numerical analysis of an evanescent wave absorption sensor was performed, in order to extend the range of liquids with a detectable RI to above 1.43. The suggested model is an SMS fiber device where a polymer coating, with an RI as low as 1.3, is deposited over the coreless MMF; numerical results are presented pertaining to several polymer thicknesses in terms of external RI variation.

Surface-enhanced Resonance Raman Scattering (serrs) Using Au Nanohole Arrays On Optical Fiber Tips

Abstract: Circular and bow tie-shaped Au nanoholes arrays were fabricated on gold films deposited on the tips of single-mode optical fibers. The nanostructures were milled using focused ion beam with a high quality control of their shapes and sizes. The optical fiber devices were used for surface-enhanced resonance Raman scattering (SERRS) measurements in both back- and forward-scattering geometries, yielding promising performance in both detection arrangements. The effect of the hole shape on the SERRS performance was explored with the bow tie nanostructures presenting a better SERRS performance than the circular holes arrays. The results present here are another step towards the development of optical fiber tips modified with plasmonic nanostructures for SERRS applications.

Photonic-crystal fiber-based pressure sensor for dual environment monitoring

Abstract: In this paper the development of a side-hole photonic-crystal fiber (SH-PCF) pressure sensor for dual environment monitoring is reported. SH-PCF properties (phase and group birefringence, sensitivity to pressure variations) are measured and compared to simulated data. In order to probe two environments, two sections of the SH-PCF with different lengths are spliced and set in a Solc filter-like configuration. This setup allows obtaining the individual responses of the first and second fiber independently, which is useful for a space-multiplexed measurement. As the employed fiber is sensitive to pressure variations, we report the use of this configuration for dual environment pressure sensing.

Fiber-Drawn Metamaterial for THz Waveguiding and Imaging

Abstract: In this paper, we review the work of our group in fabricating metamaterials for terahertz (THz) applications by fiber drawing. We discuss the fabrication technique and the structures that can be obtained before focusing on two particular applications of terahertz metamaterials, i.e., waveguiding and sub-diffraction imaging. We show the experimental demonstration of THz radiation guidance through hollow core waveguides with metamaterial cladding, where substantial improvements were realized compared to conventional hollow core waveguides, such as reduction of size, greater flexibility, increased single-mode operating regime, and guiding due to magnetic and electric resonances. We also report recent and new experimental work on near- and far-field THz imaging using wire array metamaterials that are capable of resolving features as small as λ/28.

Pressure Sensing Based on Nonconventional Air-Guiding Transmission Windows in Hollow-Core Photonic Crystal Fibers

Abstract: Non-conventional core-guided transmission windows within the visible spectral range are identified in commercial hollow-core photonic crystal fibers designed to operate at 1550 nm. These windows are likely to be related to higher-order cladding photonic bandgaps and are found to be highly dependent on the cladding microstructure, thus being affected by pressure-induced stress/deformation. 20-cm-long fiber samples are then used to demonstrate simple and temperature-independent hydrostatic pressure sensing with two different setups. While in the first setup pressure is externally applied to the fiber and results in operation in the hundreds of kgf/cm 2 (or tens of MPa) range, the second setup applies pressure directly to fiber internal microstructure and is sensitive to pressures down to a fraction of kgf/cm 2 (hundredths of MPa). The fact that pressure is directly transduced into transmitted power greatly simplifies the required sensor interrogation setup.

Handbook of Chemistry and Physics

Abstract: There is a special reason for reviewing this book at this time: it is the 50th edition of a compendium that is known and used frequently in most chemical and physical laboratories in many parts of the world. Surely, a publication that has been published for 56 years, withstanding the vagaries of science in this century, must have had something to offer. There is another reason: while the book is a standard fixture in most chemical and physical laboratories, including those in medical centers, it is not as frequently seen in the laboratories of physician's offices (those either in solo or group practice). I believe that the Handbook can be useful in those laboratories. One of the reasons, among others, is that the various basic items of information it offers may be helpful in new tests, either physical or chemical, which are continuously being published. The basic information may relate

Supercontinuum generation, photonic crystal fiber

Abstract: A topical review of numerical and experimental studies of supercontinuum generation in photonic crystal fiber is presented over the full range of experimentally reported parameters, from the femtosecond to the continuous-wave regime. Results from numerical simulations are used to discuss the temporal and spectral characteristics of the supercontinuum, and to interpret the physics of the underlying spectral broadening processes. Particular attention is given to the case of supercontinuum generation seeded by femtosecond pulses in the anomalous group velocity dispersion regime of photonic crystal fiber, where the processes of soliton fission, stimulated Raman scattering, and dispersive wave generation are reviewed in detail. The corresponding intensity and phase stability properties of the supercontinuum spectra generated under different conditions are also discussed.

Negative curvature fibers

Abstract: We describe the history, guiding mechanism, recent advances, applications, and future prospects for hollow-core negative curvature fibers. We first review one-dimensional slab waveguides, two-dimensional annular core fibers, and negative curvature tube lattice fibers to illustrate the inhibited coupling guiding mechanism. Antiresonance in the glass at the core boundary and a wavenumber mismatch between the core and cladding modes inhibit coupling between the modes and have led to remarkably low loss in negative curvature fibers. We also summarize recent advances in negative curvature fibers that improve the performance of the fibers, including negative curvature that increases confinement, gaps between tubes that increase confinement and bandwidth, additional tubes that decrease mode coupling, tube structures that suppress higher-order modes, nested tubes that increase guidance, and tube parameters that decrease bend loss. Recent applications of negative curvature fibers are also presented, including mid-infrared fiber lasers, micromachining, and surgical procedures. At the end, we discuss the future prospects for negative curvature fibers.

Lab on Fiber Technology for biological sensing applications

Abstract: This review presents an overview of “Lab on Fiber” technologies and devices with special focus on the design and development of advanced fiber optic nanoprobes for biological applications. Depending on the specific location where functional materials at micro and nanoscale are integrated, “Lab on Fiber Technology” is classified into three main paradigms: Lab on Tip (where functional materials are integrated onto the optical fiber tip), Lab around Fiber (where functional materials are integrated on the outer surface of optical fibers), and Lab in Fiber (where functional materials are integrated within the holey structure of specialty optical fibers). This work reviews the strategies, the main achievements and related devices developed in the “Lab on Fiber” roadmap, discussing perspectives and challenges that lie ahead, with special focus on biological sensing applications.