K. Andre Mkhoyan

Bio: K. Andre Mkhoyan is an academic researcher from University of Minnesota. The author has contributed to research in topics: Scanning transmission electron microscopy & Thin film. The author has an hindex of 34, co-authored 167 publications receiving 6969 citations.

Evolution of Electrical, Chemical, and Structural Properties of Transparent and Conducting Chemically Derived Graphene Thin Films

Abstract: A detailed description of the electronic properties, chemical state, and structure of uniform single and few-layered graphene oxide (GO) thin films at different stages of reduction is reported. The residual oxygen content and structure of GO are monitored and these chemical and structural characteristics are correlated to electronic properties of the thin films at various stages of reduction. It is found that the electrical characteristics of reduced GO do not approach those of intrinsic graphene obtained by mechanical cleaving because the material remains significantly oxidized. The residual oxygen forms sp3 bonds with carbon atoms in the basal plane such that the carbon sp2 bonding fraction in fully reduced GO is ∼0.80. The minority sp3 bonds disrupt the transport of carriers delocalized in the sp2 network, limiting the mobility, and conductivity of reduced GO thin films. Extrapolation of electrical conductivity data as a function of oxygen content reveals that complete removal of oxygen should lead to properties that are comparable to graphene.

Atomic and Electronic Structure of Graphene-Oxide

Abstract: We elucidate the atomic and electronic structure of graphene oxide (GO) using annular dark field imaging of single and multilayer sheets and electron energy loss spectroscopy for measuring the fine structure of C and O K-edges in a scanning transmission electron microscope. Partial density of states and electronic plasma excitations are also measured for these GO sheets showing unusual π* + σ* excitation at 19 eV. The results of this detailed analysis reveal that the GO is rough with an average surface roughness of 0.6 nm and the structure is predominantly amorphous due to distortions from sp3 C−O bonds. Around 40% sp3 bonding was found to be present in these sheets with measured O/C ratio of 1:5. These sp2 to sp3 bond modifications due to oxidation are also supported by ab initio calculations.

Dispersible exfoliated zeolite nanosheets and their application as a selective membrane

Abstract: Thin zeolite films are attractive for a wide range of applications, including molecular sieve membranes, catalytic membrane reactors, permeation barriers, and low-dielectric-constant materials. Synthesis of thin zeolite films using high-aspect-ratio zeolite nanosheets is desirable because of the packing and processing advantages of the nanosheets over isotropic zeolite nanoparticles. Attempts to obtain a dispersed suspension of zeolite nanosheets via exfoliation of their lamellar precursors have been hampered because of their structure deterioration and morphological damage (fragmentation, curling, and aggregation). We demonstrated the synthesis and structure determination of highly crystalline nanosheets of zeolite frameworks MWW and MFI. The purity and morphological integrity of these nanosheets allow them to pack well on porous supports, facilitating the fabrication of molecular sieve membranes.

Ultra-selective high-flux membranes from directly synthesized zeolite nanosheets

Abstract: A direct synthesis of high-aspect-ratio microporous zeolite nanosheets and the use of such nanosheets in separation membranes are described. Zeolites—naturally occurring porous crystalline aluminosilicates that are also produced industrially on a large scale—are used commercially as selective adsorbents. Zeolite membranes can be used for selective dehydration, but more general separations, for example of hydrocarbon isomers, are challenging because they require thin membranes with highly oriented pores. At present, such thin membranes are produced by an expensive and low-yielding exfoliation process. Here the authors produce nanometre-thick zeolite nanosheets using a bottom-up seeded growth method that retains the pore structure and avoids rotational intergrowths. Using xylene isomer separation as a benchmark, the authors found that their compact membranes had higher selectivities and flux rates than previous zeolite membranes. A zeolite with structure type MFI1,2 is an aluminosilicate or silicate material that has a three-dimensionally connected pore network, which enables molecular recognition in the size range 0.5–0.6 nm. These micropore dimensions are relevant for many valuable chemical intermediates, and therefore MFI-type zeolites are widely used in the chemical industry as selective catalysts or adsorbents3,4,5. As with all zeolites, strategies to tailor them for specific applications include controlling their crystal size and shape5,6,7,8. Nanometre-thick MFI crystals (nanosheets) have been introduced in pillared9 and self-pillared (intergrown)10 architectures, offering improved mass-transfer characteristics for certain adsorption and catalysis applications11,12,13,14. Moreover, single (non-intergrown and non-layered) nanosheets have been used to prepare thin membranes15,16 that could be used to improve the energy efficiency of separation processes17. However, until now, single MFI nanosheets have been prepared using a multi-step approach based on the exfoliation of layered MFI9,15, followed by centrifugation to remove non-exfoliated particles18. This top-down method is time-consuming, costly and low-yield and it produces fragmented nanosheets with submicrometre lateral dimensions. Alternatively, direct (bottom-up) synthesis could produce high-aspect-ratio zeolite nanosheets, with improved yield and at lower cost. Here we use a nanocrystal-seeded growth method triggered by a single rotational intergrowth to synthesize high-aspect-ratio MFI nanosheets with a thickness of 5 nanometres (2.5 unit cells). These high-aspect-ratio nanosheets allow the fabrication of thin and defect-free coatings that effectively cover porous substrates. These coatings can be intergrown to produce high-flux and ultra-selective MFI membranes that compare favourably with other MFI membranes prepared from existing MFI materials (such as exfoliated nanosheets or nanocrystals).

Room-temperature high spin-orbit torque due to quantum confinement in sputtered BixSe(1-x) films.

Abstract: The spin–orbit torque (SOT) that arises from materials with large spin–orbit coupling promises a path for ultralow power and fast magnetic-based storage and computational devices. We investigated the SOT from magnetron-sputtered BixSe(1–x) thin films in BixSe(1–x)/Co20Fe60B20 heterostructures by using d.c. planar Hall and spin-torque ferromagnetic resonance (ST-FMR) methods. Remarkably, the spin torque efficiency (θS) was determined to be as large as 18.62 ± 0.13 and 8.67 ± 1.08 using the d.c. planar Hall and ST-FMR methods, respectively. Moreover, switching of the perpendicular CoFeB multilayers using the SOT from the BixSe(1–x) was observed at room temperature with a low critical magnetization switching current density of 4.3 × 105 A cm–2. Quantum transport simulations using a realistic sp3 tight-binding model suggests that the high SOT in sputtered BixSe(1–x) is due to the quantum confinement effect with a charge-to-spin conversion efficiency that enhances with reduced size and dimensionality. The demonstrated θS, ease of growth of the films on a silicon substrate and successful growth and switching of perpendicular CoFeB multilayers on BixSe(1–x) films provide an avenue for the use of BixSe(1–x) as a spin density generator in SOT-based memory and logic devices. Sputtered BixSe(1–x) thin films can generate very large current-induced spin–orbit torque, capable to switch both in-plane and out-of-plane magnetized CoFeB-based structures deposited on top, at room temperature.

Fast parallel algorithms for short-range molecular dynamics

Abstract: Three parallel algorithms for classical molecular dynamics are presented. The first assigns each processor a fixed subset of atoms; the second assigns each a fixed subset of inter-atomic forces to compute; the third assigns each a fixed spatial region. The algorithms are suitable for molecular dynamics models which can be difficult to parallelize efficiently—those with short-range forces where the neighbors of each atom change rapidly. They can be implemented on any distributed-memory parallel machine which allows for message-passing of data between independently executing processors. The algorithms are tested on a standard Lennard-Jones benchmark problem for system sizes ranging from 500 to 100,000,000 atoms on several parallel supercomputers--the nCUBE 2, Intel iPSC/860 and Paragon, and Cray T3D. Comparing the results to the fastest reported vectorized Cray Y-MP and C90 algorithm shows that the current generation of parallel machines is competitive with conventional vector supercomputers even for small problems. For large problems, the spatial algorithm achieves parallel efficiencies of 90% and a 1840-node Intel Paragon performs up to 165 faster than a single Cray C9O processor. Trade-offs between the three algorithms and guidelines for adapting them to more complex molecular dynamics simulations are also discussed.

疟原虫var基因转换速率变化导致抗原变异[英]／Paul H, Robert P, Christodoulou Z, et al//Proc Natl Acad Sci U S A

Abstract: 抗原变异可使得多种致病微生物易于逃避宿主免疫应答。表达在感染红细胞表面的恶性疟原虫红细胞表面蛋白1（PfPMP1）与感染红细胞、内皮细胞、树突状细胞以及胎盘的单个或多个受体作用，在黏附及免疫逃避中起关键的作用。每个单倍体基因组var基因家族编码约60种成员，通过启动转录不同的var基因变异体为抗原变异提供了分子基础。

Improved Synthesis of Graphene Oxide

Abstract: An improved method for the preparation of graphene oxide (GO) is described. Currently, Hummers’ method (KMnO4, NaNO3, H2SO4) is the most common method used for preparing graphene oxide. We have found that excluding the NaNO3, increasing the amount of KMnO4, and performing the reaction in a 9:1 mixture of H2SO4/H3PO4 improves the efficiency of the oxidation process. This improved method provides a greater amount of hydrophilic oxidized graphene material as compared to Hummers’ method or Hummers’ method with additional KMnO4. Moreover, even though the GO produced by our method is more oxidized than that prepared by Hummers’ method, when both are reduced in the same chamber with hydrazine, chemically converted graphene (CCG) produced from this new method is equivalent in its electrical conductivity. In contrast to Hummers’ method, the new method does not generate toxic gas and the temperature is easily controlled. This improved synthesis of GO may be important for large-scale production of GO as well as the ...

Graphene photonics and optoelectronics

Abstract: The richness of optical and electronic properties of graphene attracts enormous interest. Graphene has high mobility and optical transparency, in addition to flexibility, robustness and environmental stability. So far, the main focus has been on fundamental physics and electronic devices. However, we believe its true potential lies in photonics and optoelectronics, where the combination of its unique optical and electronic properties can be fully exploited, even in the absence of a bandgap, and the linear dispersion of the Dirac electrons enables ultrawideband tunability. The rise of graphene in photonics and optoelectronics is shown by several recent results, ranging from solar cells and light-emitting devices to touch screens, photodetectors and ultrafast lasers. Here we review the state-of-the-art in this emerging field.