Kenji Kawano

Bio: Kenji Kawano is an academic researcher from Nippon Telegraph and Telephone. The author has contributed to research in topics: Optical modulator & Optical fiber. The author has an hindex of 20, co-authored 50 publications receiving 1467 citations.

New travelling-wave electrode Mach-Zehnder optical modulator with 20 GHz bandwidth and 4.7 V driving voltage at 1.52 μm wavelength

Abstract: A wideband and low-driving voltage Ti:LiNbO3 Mach-Zehnder optical modulator of nearly 50 Ω characteristic impedance has been developed employing a shielded-phasevelocity-matching travelling-wave (TW) electrode. Both wide modulation bandwidth of 20 GHz (3 dB optical) and low driving voltage of 4.7 V were attained at 1.52 μm wavelength.

Polarisation-insensitive travelling-wave electrode electroabsorption (TW-EA) modulator with bandwidth over 50 GHz and driving voltage less than 2 V

Abstract: The proposed TW-EA modulator has a thin intrinsic layer (a 0.2 /spl mu/m thick strained InGaAlAs (13 nm)/InAlAs (5 nm) MQW) and short interaction length (200 /spl mu/m). The optical 3 dB modulation bandwidth exceeds 50 GHz, and the driving voltages for the 15 dB extinction ratio are 1.7 and 1.9 V for TE and TM modes respectively, at 1.55 /spl mu/m wavelength.

Photonic Floquet topological insulators

Abstract: Topological insulators are a new phase of matter, with the striking property that conduction of electrons occurs only on their surfaces. In two dimensions, electrons on the surface of a topological insulator are not scattered despite defects and disorder, providing robustness akin to that of superconductors. Topological insulators are predicted to have wide-ranging applications in fault-tolerant quantum computing and spintronics. Substantial effort has been directed towards realizing topological insulators for electromagnetic waves. One-dimensional systems with topological edge states have been demonstrated, but these states are zero-dimensional and therefore exhibit no transport properties. Topological protection of microwaves has been observed using a mechanism similar to the quantum Hall effect, by placing a gyromagnetic photonic crystal in an external magnetic field. But because magnetic effects are very weak at optical frequencies, realizing photonic topological insulators with scatter-free edge states requires a fundamentally different mechanism-one that is free of magnetic fields. A number of proposals for photonic topological transport have been put forward recently. One suggested temporal modulation of a photonic crystal, thus breaking time-reversal symmetry and inducing one-way edge states. This is in the spirit of the proposed Floquet topological insulators, in which temporal variations in solid-state systems induce topological edge states. Here we propose and experimentally demonstrate a photonic topological insulator free of external fields and with scatter-free edge transport-a photonic lattice exhibiting topologically protected transport of visible light on the lattice edges. Our system is composed of an array of evanescently coupled helical waveguides arranged in a graphene-like honeycomb lattice. Paraxial diffraction of light is described by a Schrodinger equation where the propagation coordinate (z) acts as 'time'. Thus the helicity of the waveguides breaks z-reversal symmetry as proposed for Floquet topological insulators. This structure results in one-way edge states that are topologically protected from scattering.

Integrated optics

Abstract: In order to enable optical systems to operate with a high degree of compactness and reliability it is necessary to combine large number of optical functions in small monolithic structures. A development, somewhat reminiscent of that that took place in Integrated Electronics, is now beginning to take place in optics. The initial challenge in this emerging field, known appropriately as "Integrated Optics", is to demonstrate the possibility of performing basic optical functions such as light generation, coupling, modulation, and guiding in Integrated Optical configurations. The talk will review the main theoretical and experimental developments to date in Integrated Optics. Specific topics to be discussed include: Material considerations, guiding mechanisms, modulation, coupling and mode losses. The fabrication and applications of periodic thin film structures will be discussed.

Photonic-crystal slow-light enhancement of nonlinear phase sensitivity

Abstract: We demonstrate how slow group velocities of light, which are readily achievable in photonic-crystal systems, can dramatically increase the induced phase shifts caused by small changes in the index of refraction. Such increased phase sensitivity may be used to decrease the sizes of many devices, including switches, routers, all-optical logical gates, wavelength converters, and others. At the same time a low group velocity greatly decreases the power requirements needed to operate these devices. We show how these advantages can be used to design switches smaller than 20 µm×200 µm in size by using readily available materials and at modest levels of power. With this approach, one could have ∼105 such devices on a surface that is 2 cm×2 cm, making it an important step towards large-scale all-optical integration.

Limits on the performance of RF-over-fiber links and their impact on device design

Abstract: This paper is divided into two major parts. Following a brief introduction that establishes some definitions and assumptions, Section II updates our earlier study on the limits of the RF performance of optical links. Section III reviews progress since our 1997 review paper in the development of devices enabling link performance closer to these limits, including (but not limited to): 1) cascade lasers that permit broad-band direct modulation links with gain >0 dB; 2) injection-locked edge- and surface-emitting lasers at 1300 and 1550 nm with modulation frequency responses as great as 40 GHz; 3) modulators with improved performance, especially electroabsorption modulators that now have switching voltages as low as 0.36 V, or handle optical powers as great as 60 mW, or have bandwidths as great as 50 GHz (but not all three of these in one device yet); and 4) high-speed photodetectors with high saturation currents, e.g., a 20-GHz device with a saturation current of 90 mA and a 55-GHz device with saturation at 50 mA. We conclude in Section IV by summarizing the component developments necessary for higher performance RF-over-fiber links, i.e.: 1) semiconductor lasers (for direct modulation) that have higher slope efficiency and bandwidth and lower relative intensity noise (RIN) at reasonable bias current levels; 2) continuous wave (CW) lasers (for external modulation) with higher fiber-coupled power and lower RIN; 3) higher frequency lower loss external modulators with more linear transfer functions and lower V/sub /spl pi// that can withstand larger CW optical powers; and 4) photodetectors with higher responsivity and bandwidth that respond linearly even when illuminated by greater average optical powers.

High-speed and high-output InP-InGaAs unitraveling-carrier photodiodes

Abstract: The unitraveling-carrier photodiode (UTC-PD) is a novel photodiode that utilizes only electrons as the active carriers. This unique feature is the key for its ability to achieve excellent high-speed and high-output characteristics simultaneously. To date, a record 3-dB bandwidth of 310 GHz and a millimeter-wave output power of over 20 mW at 100 GHz have been achieved. The superior capability of the UTC-PD for generating very large high-bit-rate electrical signals as well as a very high RF output power in millimeter/submillimeter ranges can lead to innovations in various systems, such as broadband optical communications systems, wireless communications systems, and high-frequency measurement systems. Accomplishments include photoreceivers of up to 160 Gb/s, error-free DEMUX operations using an integrated UTC-PD driven optical gate of up to 320 Gb/s, a 10-Gb/s millimeter-wave wireless link at 120 GHz, submillimeter-wave generation at frequencies of up to 1.5 THz, and photonic frequency conversion with an efficiency of -8 dB at 60 GHz. For the practical use, various types of modules, such as a 1-mm coaxial connector module, a rectangular-waveguide output module, and a quasi-optic module, have been developed. The superior reliability and stability are also confirmed demonstrating usefulness of the UTC-PD for the system applications.