Kevin Englehart

Bio: Kevin Englehart is an academic researcher from University of New Brunswick. The author has contributed to research in topics: Proportional myoelectric control & Linear discriminant analysis. The author has an hindex of 46, co-authored 144 publications receiving 11835 citations.

A robust, real-time control scheme for multifunction myoelectric control

Abstract: This paper represents an ongoing investigation of dexterous and natural control of upper extremity prostheses using the myoelectric signal (MES). The scheme described within uses pattern recognition to process four channels of MES, with the task of discriminating multiple classes of limb movement. The method does not require segmentation of the MES data, allowing a continuous stream of class decisions to be delivered to a prosthetic device. It is shown in this paper that, by exploiting the processing power inherent in current computing systems, substantial gains in classifier accuracy and response time are possible. Other important characteristics for prosthetic control systems are met as well. Due to the fact that the classifier learns the muscle activation patterns for each desired class for each individual, a natural control actuation results. The continuous decision stream allows complex sequences of manipulation involving multiple joints to be performed without interruption. Finally, minimal storage capacity is required, which is an important factor in embedded control systems.

Targeted muscle reinnervation for real-time myoelectric control of multifunction artificial arms.

Abstract: Context Improving the function of prosthetic arms remains a challenge, because access to the neural-control information for the arm is lost during amputation. A surgical technique called targeted muscle reinnervation (TMR) transfers residual arm nerves to alternative muscle sites. After reinnervation, these target muscles produce electromyogram (EMG) signals on the surface of the skin that can be measured and used to control prosthetic arms. Objective To assess the performance of patients with upper-limb amputation who had undergone TMR surgery, using a pattern-recognition algorithm to decode EMG signals and control prosthetic-arm motions. Design, Setting, and Participants Study conducted between January 2007 and January 2008 at the Rehabilitation Institute of Chicago among 5 patients with shoulder-disarticulation or transhumeral amputations who underwent TMR surgery between February 2002 and October 2006 and 5 control participants without amputation. Surface EMG signals were recorded from all participants and decoded using a pattern-recognition algorithm. The decoding program controlled the movement of a virtual prosthetic arm. All participants were instructed to perform various arm movements, and their abilities to control the virtual prosthetic arm were measured. In addition, TMR patients used the same control system to operate advanced arm prosthesis prototypes. Main Outcome Measure Performance metrics measured during virtual arm movements included motion selection time, motion completion time, and motion completion (“success”) rate. Results The TMR patients were able to repeatedly perform 10 different elbow, wrist, and hand motions with the virtual prosthetic arm. For these patients, the mean motion selection and motion completion times for elbow and wrist movements were 0.22 seconds (SD, 0.06) and 1.29 seconds (SD, 0.15), respectively. These times were 0.06 seconds and 0.21 seconds longer than the mean times for control participants. For TMR patients, the mean motion selection and motion completion times for hand-grasp patterns were 0.38 seconds (SD, 0.12) and 1.54 seconds (SD, 0.27), respectively. These patients successfully completed a mean of 96.3% (SD, 3.8) of elbow and wrist movements and 86.9% (SD, 13.9) of hand movements within 5 seconds, compared with 100% (SD, 0) and 96.7% (SD, 4.7) completed by controls. Three of the patients were able to demonstrate the use of this control system in advanced prostheses, including motorized shoulders, elbows, wrists, and hands. Conclusion These results suggest that reinnervated muscles can produce sufficient EMG information for real-time control of advanced artificial arms.

Electromyogram pattern recognition for control of powered upper-limb prostheses: state of the art and challenges for clinical use.

Abstract: Using electromyogram (EMG) signals to control upper-limb prostheses is an important clinical option, offering a person with amputation autonomy of control by contracting residual muscles. The dexterity with which one may control a prosthesis has progressed very little, especially when control- ling multiple degrees of freedom. Using pattern recognition to discriminate multiple degrees of freedom has shown great promise in the research literature, but it has yet to transition to a clinically viable option. This article describes the pertinent issues and best practices in EMG pattern recognition, identifies the major challenges in deploying robust control, and advocates research directions that may have an effect in the near future.

A wavelet-based continuous classification scheme for multifunction myoelectric control

Abstract: This work represents an ongoing investigation of dexterous and natural control of powered upper limbs using the myoelectric signal. When approached as a pattern recognition problem, the success of a myoelectric control scheme depends largely on the classification accuracy. A novel approach is described that demonstrates greater accuracy than in previous work. Fundamental to the success of this method is the use of a wavelet-based feature set, reduced in dimension by principal components analysis. Further, it is shown that four channels of myoelectric data greatly improve the classification accuracy, as compared to one or two channels. It is demonstrated that exceptionally accurate performance is possible using the steady-state myoelectric signal. Exploiting these successes, a robust online classifier is constructed, which produces class decisions on a continuous stream of data. Although in its preliminary stages of development, this scheme promises a more natural and efficient means of myoelectric control than one based on discrete, transient bursts of activity.

A robust, real-time control scheme for multifunction myoelectric control

Abstract: This paper represents an ongoing investigation of dexterous and natural control of upper extremity prostheses using the myoelectric signal (MES). The scheme described within uses pattern recognition to process four channels of MES, with the task of discriminating multiple classes of limb movement. The method does not require segmentation of the MES data, allowing a continuous stream of class decisions to be delivered to a prosthetic device. It is shown in this paper that, by exploiting the processing power inherent in current computing systems, substantial gains in classifier accuracy and response time are possible. Other important characteristics for prosthetic control systems are met as well. Due to the fact that the classifier learns the muscle activation patterns for each desired class for each individual, a natural control actuation results. The continuous decision stream allows complex sequences of manipulation involving multiple joints to be performed without interruption. Finally, minimal storage capacity is required, which is an important factor in embedded control systems.

Feature reduction and selection for EMG signal classification

Abstract: Feature extraction is a significant method to extract the useful information which is hidden in surface electromyography (EMG) signal and to remove the unwanted part and interferences. To be successful in classification of the EMG signal, selection of a feature vector ought to be carefully considered. However, numerous studies of the EMG signal classification have used a feature set that have contained a number of redundant features. In this study, most complete and up-to-date thirty-seven time domain and frequency domain features have been proposed to be studied their properties. The results, which were verified by scatter plot of features, statistical analysis and classifier, indicated that most time domain features are superfluity and redundancy. They can be grouped according to mathematical property and information into four main types: energy and complexity, frequency, prediction model, and time-dependence. On the other hand, all frequency domain features are calculated based on statistical parameters of EMG power spectral density. Its performance in class separability viewpoint is not suitable for EMG recognition system. Recommendation of features to avoid the usage of redundant features for classifier in EMG signal classification applications is also proposed in this study.

Robotic surgery system including position sensors using fiber bragg gratings

Abstract: A surgical instrument is provided, including: at least one articulatable arm having a distal end, a proximal end, and at least one joint region disposed between the distal and proximal ends; an optical fiber bend sensor provided in the at least one joint region of the at least one articulatable arm; a detection system coupled to the optical fiber bend sensor, said detection system comprising a light source and a light detector for detecting light reflected by or transmitted through the optical fiber bend sensor to determine a position of at least one joint region of the at least one articulatable arm based on the detected light reflected by or transmitted through the optical fiber bend sensor; and a control system comprising a servo controller for effectuating movement of the arm.