scispace - formally typeset
Search or ask a question
Author

Kim Kisslinger

Other affiliations: Brookhaven National Laboratory
Bio: Kim Kisslinger is an academic researcher from Center for Functional Nanomaterials. The author has contributed to research in topics: Thin film & Materials science. The author has an hindex of 24, co-authored 147 publications receiving 2639 citations. Previous affiliations of Kim Kisslinger include Brookhaven National Laboratory.


Papers
More filters
Journal ArticleDOI
TL;DR: The results demonstrate that the roughness of oxide-derived copper catalysts plays only a partial role in determining the catalytic performance, while the presence of copper+ is key for lowering the onset potential and enhancing ethylene selectivity.
Abstract: There is an urgent need to develop technologies that use renewable energy to convert waste products such as carbon dioxide into hydrocarbon fuels. Carbon dioxide can be electrochemically reduced to hydrocarbons over copper catalysts, although higher efficiency is required. We have developed oxidized copper catalysts displaying lower overpotentials for carbon dioxide electroreduction and record selectivity towards ethylene (60%) through facile and tunable plasma treatments. Herein we provide insight into the improved performance of these catalysts by combining electrochemical measurements with microscopic and spectroscopic characterization techniques. Operando X-ray absorption spectroscopy and cross-sectional scanning transmission electron microscopy show that copper oxides are surprisingly resistant to reduction and copper(+) species remain on the surface during the reaction. Our results demonstrate that the roughness of oxide-derived copper catalysts plays only a partial role in determining the catalytic performance, while the presence of copper(+) is key for lowering the onset potential and enhancing ethylene selectivity.

854 citations

Journal ArticleDOI
TL;DR: In this article, a dual-modification strategy of synchronous synthesis and in situ modification of LiNi0.8Co0.1Mn 0.1O2 cathodes was proposed to solve the problem of fast capacity drop and voltage fading due to the interfacial instability and bulk structural degradation of the cathodes during battery operation.
Abstract: A critical challenge in the commercialization of layer-structured Ni-rich materials is the fast capacity drop and voltage fading due to the interfacial instability and bulk structural degradation of the cathodes during battery operation. Herein, with the guidance of theoretical calculations of migration energy difference between La and Ti from the surface to the inside of LiNi0.8Co0.1Mn0.1O2, for the first time, Ti-doped and La4NiLiO8-coated LiNi0.8Co0.1Mn0.1O2 cathodes are rationally designed and prepared, via a simple and convenient dual-modification strategy of synchronous synthesis and in situ modification. Impressively, the dual modified materials show remarkably improved electrochemical performance and largely suppressed voltage fading, even under exertive operational conditions at elevated temperature and under extended cutoff voltage. Further studies reveal that the nanoscale structural degradation on material surfaces and the appearance of intergranular cracks associated with the inconsistent evolution of structural degradation at the particle level can be effectively suppressed by the synergetic effect of the conductive La4NiLiO8 coating layer and the strong TiO bond. The present work demonstrates that our strategy can simultaneously address the two issues with respect to interfacial instability and bulk structural degradation, and it represents a significant progress in the development of advanced cathode materials for high-performance lithium-ion batteries.

448 citations

Journal ArticleDOI
TL;DR: DFT calculations reveal that the defect-rich surface of the plasma-oxidized silver foils in the presence of local electric fields drastically decrease the overpotential of CO2 electroreduction.
Abstract: Efficient, stable catalysts with high selectivity for a single product are essential to making the electroreduction of CO2 a viable route to the synthesis of industrial feedstocks and fuels. We reveal how a plasma oxidation pre-treatment can lead to an enhanced content of low-coordinated active sites which dramatically lower the overpotential and increase the activity of CO2 electroreduction to CO. At -0.6 V vs. RHE, more than 90% Faradaic efficiency towards CO could be achieved on a pre-oxidized silver foil. While transmission electron microscopy and operando X-ray absorption spectroscopy showed that oxygen species can survive in the bulk of the catalyst during the reaction, in situ X-ray photoelectron spectroscopy showed that the surface is metallic under reaction conditions. DFT calculations show how the defect-rich surface of the plasma-oxidized silver foils in the presence of local electric fields results in a drastic decrease in the overpotential for the electroreduction of CO2.

170 citations

Journal ArticleDOI
TL;DR: This work investigates the growth of turbostratic graphene on heteroepitaxial Ni(111) thin films utilizing physical vapor deposition and reports an increase in the graphene quality concomitant with a transition in the size of uniform thickness graphene, ranging from nanocrystallites to thousands of square microns.
Abstract: Single-layer graphene has demonstrated remarkable electronic properties that are strongly influenced by interfacial bonding and break down for the lowest energy configuration of stacked graphene layers (AB Bernal). Multilayer graphene with relative rotations between carbon layers, known as turbostratic graphene, can effectively decouple the electronic states of adjacent layers, preserving properties similar to that of SLG. While the growth of AB Bernal graphene through chemical vapor deposition has been widely reported, we investigate the growth of turbostratic graphene on heteroepitaxial Ni(111) thin films utilizing physical vapor deposition. By varying the carbon deposition temperature between 800 –1100 °C, we report an increase in the graphene quality concomitant with a transition in the size of uniform thickness graphene, ranging from nanocrystallites to thousands of square microns. Combination Raman modes of as-grown graphene within the frequency range of 1650 cm−1 to 2300 cm−1, along with features of the Raman 2D mode, were employed as signatures of turbostratic graphene. Bilayer and multilayer graphene were directly identified from areas that exhibited Raman characteristics of turbostratic graphene using high-resolution TEM imaging. Raman maps of the pertinent modes reveal large regions of turbostratic graphene on Ni(111) thin films at a deposition temperature of 1100 °C.

102 citations


Cited by
More filters
Journal ArticleDOI
TL;DR: A broad and historical view of different aspects and their complex interplay in CO2R catalysis on Cu is taken, with the purpose of providing new insights, critical evaluations, and guidance to the field with regard to research directions and best practices.
Abstract: To date, copper is the only heterogeneous catalyst that has shown a propensity to produce valuable hydrocarbons and alcohols, such as ethylene and ethanol, from electrochemical CO2 reduction (CO2R). There are variety of factors that impact CO2R activity and selectivity, including the catalyst surface structure, morphology, composition, the choice of electrolyte ions and pH, and the electrochemical cell design. Many of these factors are often intertwined, which can complicate catalyst discovery and design efforts. Here we take a broad and historical view of these different aspects and their complex interplay in CO2R catalysis on Cu, with the purpose of providing new insights, critical evaluations, and guidance to the field with regard to research directions and best practices. First, we describe the various experimental probes and complementary theoretical methods that have been used to discern the mechanisms by which products are formed, and next we present our current understanding of the complex reaction networks for CO2R on Cu. We then analyze two key methods that have been used in attempts to alter the activity and selectivity of Cu: nanostructuring and the formation of bimetallic electrodes. Finally, we offer some perspectives on the future outlook for electrochemical CO2R.

2,055 citations

Book
01 Jan 2010

1,870 citations

Journal ArticleDOI
18 May 2018-Science
TL;DR: A copper electrocatalyst at an abrupt reaction interface in an alkaline electrolyte reduces CO2 to ethylene with 70% faradaic efficiency at a potential of −0.55 volts versus a reversible hydrogen electrode (RHE).
Abstract: Carbon dioxide (CO 2 ) electroreduction could provide a useful source of ethylene, but low conversion efficiency, low production rates, and low catalyst stability limit current systems. Here we report that a copper electrocatalyst at an abrupt reaction interface in an alkaline electrolyte reduces CO 2 to ethylene with 70% faradaic efficiency at a potential of −0.55 volts versus a reversible hydrogen electrode (RHE). Hydroxide ions on or near the copper surface lower the CO 2 reduction and carbon monoxide (CO)–CO coupling activation energy barriers; as a result, onset of ethylene evolution at −0.165 volts versus an RHE in 10 molar potassium hydroxide occurs almost simultaneously with CO production. Operational stability was enhanced via the introduction of a polymer-based gas diffusion layer that sandwiches the reaction interface between separate hydrophobic and conductive supports, providing constant ethylene selectivity for an initial 150 operating hours.

1,352 citations

01 Mar 1996
TL;DR: In this paper, a mean-field phase diagram for conformationally symmetric diblock melts using the standard Gaussian polymer model is presented, which traverses the weak- to strong-segregation regimes, is free of traditional approximations.
Abstract: A mean-field phase diagram for conformationally symmetric diblock melts using the standard Gaussian polymer model is presented. Our calculation, which traverses the weak- to strong-segregation regimes, is free of traditional approximations. Regions of stability are determined for disordered (DIS) melts and for ordered structures including lamellae (L), hexagonally packed cylinders (H), body-centered cubic spheres (QIm3m), close-packed spheres (CPS), and the bicontinuous cubic network with Ia3d symmetry (QIa3d). The CPS phase exists in narrow regions along the order−disorder transition for χN ≥ 17.67. Results suggest that the QIa3d phase is not stable above χN ∼ 60. Along the L/QIa3d phase boundaries, a hexagonally perforated lamellar (HPL) phase is found to be nearly stable. Our results for the bicontinuous Pn3m cubic (QPn3m) phase, known as the OBDD, indicate that it is an unstable structure in diblock melts. Earlier approximation schemes used to examine mean-field behavior are reviewed, and compa...

1,256 citations

Journal ArticleDOI
TL;DR: In this article, the authors review recent advances and challenges in the understanding of electrochemical CO2 reduction and discuss existing models for the initial activation of CO2 on the electrocatalyst and their importance for understanding selectivity.
Abstract: The electrocatalytic reduction of carbon dioxide is a promising approach for storing (excess) renewable electricity as chemical energy in fuels. Here, we review recent advances and challenges in the understanding of electrochemical CO2 reduction. We discuss existing models for the initial activation of CO2 on the electrocatalyst and their importance for understanding selectivity. Carbon–carbon bond formation is also a key mechanistic step in CO2 electroreduction to high-density and high-value fuels. We show that both the initial CO2 activation and C–C bond formation are influenced by an intricate interplay between surface structure (both on the nano- and on the mesoscale), electrolyte effects (pH, buffer strength, ion effects) and mass transport conditions. This complex interplay is currently still far from being completely understood. In addition, we discuss recent progress in in situ spectroscopic techniques and computational techniques for mechanistic work. Finally, we identify some challenges in furthering our understanding of these themes. Electrocatalytic reduction of CO2 to fuels could be used as an approach to store renewable energy in the form of chemical energy. Here, Birdja et al. review current understanding of electrocatalytic systems and reaction pathways for these conversions.

1,141 citations