L.C.N. de Vreede

Bio: L.C.N. de Vreede is an academic researcher from Delft University of Technology. The author has contributed to research in topics: Amplifier & Varicap. The author has an hindex of 23, co-authored 96 publications receiving 2094 citations.

Adaptive Multi-Band Multi-Mode Power Amplifier Using Integrated Varactor-Based Tunable Matching Networks

Abstract: This paper presents a multi-band multi-mode class-AB power amplifier, which utilizes continuously tunable input and output matching networks integrated in a low-loss silicon-on-glass technology. The tunable matching networks make use of very high Q varactor diodes (Q>100 @ 2 GHz) in a low distortion anti-series configuration to achieve the desired source and load impedance tunability. A QUBIC4G (SiGe, ft=50 GHz) high voltage breakdown transistor (VCBO=14 V, VCEO>3.6 V) is used as active device. The realized adaptive amplifier provides 13 dB gain, 27-28 dBm output power at the 900, 1800, 1900 and 2100 MHz bands. For the communication bands above 1 GHz optimum load adaptation is facilitated resulting in efficiencies between 30%-55% over a 10 dB output power control range. The total chip area (including matching networks) of the amplifier is 8 mm2

A High-Efficiency 100-W GaN Three-Way Doherty Amplifier for Base-Station Applications

Abstract: A three-way Doherty 100-W GaN base-station power amplifier at 2.14 GHz is presented. Simple, but accurate design equations for the output power combiner of the amplifier are introduced. Mixed-signal techniques are utilized for uncompromised control of the amplifier stages to optimize efficiency, as well as linearity. The combination of the above techniques resulted in an unprecedented high efficiency over a 12-dB power backoff range, facilitating a record high power-added efficiency for a wideband code division multiple access test signal with high crest factor, while meeting all the spectral requirements for Universal Mobile Telecommunications System base stations.

A 90-W Peak Power GaN Outphasing Amplifier With Optimum Input Signal Conditioning

Abstract: A 90-W peak-power 2.14-GHz improved GaN outphasing amplifier with 50.5% average efficiency for wideband code division multiple access (W-CDMA) signals is presented. Independent control of the branch amplifiers by two in-phase/quadrature modulators enables optimum outphasing and input power leveling, yielding significant improvements in gain, efficiency, and linearity. In deep-power backoff operation, the outphasing angle of the branch amplifiers is kept constant below a certain power level. This results in class-B operation for the very low output power levels, yielding less reactive loading of the output stages, and therefore, improved efficiency in power backoff operation compared to the classical outphasing amplifiers. Based on these principles, the optimum design parameters and input signal conditioning are discussed. The resulting theoretical maximum achievable average efficiency for W-CDMA signals is presented. Experimental results support the foregoing theory and show high efficiency over a large bandwidth, while meeting the linearity specifications using low-cost low-complexity memoryless pre-distortion. These properties make this amplifier concept an interesting candidate for future multiband base-station implementations.

A Mixed-Signal Approach Towards Linear and Efficient $N$ -Way Doherty Amplifiers

Abstract: A mixed-signal approach for the design and testing of high-performance N-way Doherty amplifiers is introduced. In support of this, an analysis of N-way power-combining networks is presented-in particular, their optimum design-by examining the relationship between the drive conditions of the active devices and input power. This analysis makes no prior assumption on the network topology and facilitates free-to-choose levels for the high-efficiency power back-off points. By comparing the results of this analysis with prior work, it is shown that very specific drive conditions apply to traditional three-way Doherty amplifier implementations to obtain simultaneously high-efficiency and high-linearity operation. To support these conclusions, a 15-W three-way Doherty amplifier was constructed using Philips GEN4 LDMOS devices featuring three separate inputs to independently drive the main and peaking devices. By testing this three-way amplifier with a custom-built measurement setup, capable of providing multiple digitally controlled coherent RF input signals with high spectral purity, a unique flexible amplifier concept is created resulting in a record-high efficiency for LDMOS-based Doherty amplifiers over a 12-dB back-off power range

“Distortion-Free” Varactor Diode Topologies for RF Adaptivity

Abstract: Varactor diode-based circuit topologies, which can act as high-Q “distortion-free” tunable capacitive elements, are presented. These diodes are implemented in a novel ultra low-loss silicon-on-glass technology, with resulting measured Q's of over 200 at 2 GHz. The measured IM3 improvement compared to traditional single varactor tuning techniques is greater than 30 dB.

PHASAR-based WDM-devices: Principles, design and applications

Abstract: Wavelength multiplexers, demultiplexers and routers based on optical phased arrays play a key role in multiwavelength telecommunication links and networks. In this paper, a detailed description of phased-array operation and design is presented and an overview is given of the most important applications.

A Review of GaN on SiC High Electron-Mobility Power Transistors and MMICs

Abstract: Gallium-nitride power transistor (GaN HEMT) and integrated circuit technologies have matured dramatically over the last few years, and many hundreds of thousands of devices have been manufactured and fielded in applications ranging from pulsed radars and counter-IED jammers to CATV modules and fourth-generation infrastructure base-stations. GaN HEMT devices, exhibiting high power densities coupled with high breakdown voltages, have opened up the possibilities for highly efficient power amplifiers (PAs) exploiting the principles of waveform engineered designs. This paper summarizes the unique advantages of GaN HEMTs compared to other power transistor technologies, with examples of where such features have been exploited. Since RF power densities of GaN HEMTs are many times higher than other technologies, much attention has also been given to thermal management-examples of both commercial “off-the-shelf” packaging as well as custom heat-sinks are described. The very desirable feature of having accurate large-signal models for both discrete transistors and monolithic microwave integrated circuit foundry are emphasized with a number of circuit design examples. GaN HEMT technology has been a major enabler for both very broadband high-PAs and very high-efficiency designs. This paper describes examples of broadband amplifiers, as well as several of the main areas of high-efficiency amplifier design-notably Class-D, Class-E, Class-F, and Class-J approaches, Doherty PAs, envelope-tracking techniques, and Chireix outphasing.

IEEE Transactions on Microwave Theory and Techniques and Antennas and Propagation Announce a Joint Special Issue on Ultra-Wideband (UWB) Technology

Abstract: Before the emergence of ultra-wideband (UWB) radios, widely used wireless communications were based on sinusoidal carriers, and impulse technologies were employed only in specific applications (e.g. radar). In 2002, the Federal Communication Commission (FCC) allowed unlicensed operation between 3.1–10.6 GHz for UWB communication, using a wideband signal format with a low EIRP level (−41.3dBm/MHz). UWB communication systems then emerged as an alternative to narrowband systems and significant effort in this area has been invested at the regulatory, commercial, and research levels.

High Efficiency RF and Microwave Solid State Power Amplifiers

Abstract: Preface. About the Authors. Acknowledgments. 1 Power Amplifier Fundamentals. 1.1 Introduction. 1.2 Definition of Power Amplifier Parameters. 1.3 Distortion Parameters. 1.4 Power Match Condition. 1.5 Class of Operation. 1.6 Overview of Semiconductors for PAs. 1.7 Devices for PA. 1.8 Appendix: Demonstration of Useful Relationships. 1.9 References. 2 Power Amplifier Design. 2.1 Introduction. 2.2 Design Flow. 2.3 Simplified Approaches. 2.4 The Tuned Load Amplifier. 2.5 Sample Design of a Tuned Load PA. 2.6 References. 3 Nonlinear Analysis for Power Amplifiers. 3.1 Introduction. 3.2 Linear vs. Nonlinear Circuits. 3.3 Time Domain Integration. 3.4 Example. 3.5 Solution by Series Expansion. 3.6 The Volterra Series. 3.7 The Fourier Series. 3.8 The Harmonic Balance. 3.9 Envelope Analysis. 3.10 Spectral Balance. 3.11 Large Signal Stability Issue. 3.12 References. 4 Load Pull. 4.1 Introduction. 4.2 Passive Source/Load Pull Measurement Systems. 4.3 Active Source/Load Pull Measurement Systems. 4.4 Measurement Test-sets. 4.5 Advanced Load Pull Measurements. 4.6 Source/Load Pull Characterization. 4.7 Determination of Optimum Load Condition. 4.8 Appendix: Construction of Simplified Load Pull Contours through Linear Simulations. 4.9 References. 5 High Efficiency PA Design Theory. 5.1 Introduction. 5.2 Power Balance in a PA. 5.3 Ideal Approaches. 5.4 High Frequency Harmonic Tuning Approaches. 5.5 High Frequency Third Harmonic Tuned (Class F). 5.6 High Frequency Second Harmonic Tuned. 5.7 High Frequency Second and Third Harmonic Tuned. 5.8 Design by Harmonic Tuning. 5.9 Final Remarks. 5.10 References. 6 Switched Amplifiers. 6.1 Introduction. 6.2 The Ideal Class E Amplifier. 6.3 Class E Behavioural Analysis. 6.4 Low Frequency Class E Amplifier Design. 6.5 Class E Amplifier Design with 50# Duty-cycle. 6.6 Examples of High Frequency Class E Amplifiers. 6.7 Class E vs. Harmonic Tuned. 6.8 Class E Final Remarks. 6.9 Appendix: Demonstration of Useful Relationships. 6.10 References. 7 High Frequency Class F Power Amplifiers. 7.1 Introduction. 7.2 Class F Description Based on Voltage Wave-shaping. 7.3 High Frequency Class F Amplifiers. 7.4 Bias Level Selection. 7.5 Class F Output Matching Network Design. 7.6 Class F Design Examples. 7.7 References. 8 High Frequency Harmonic Tuned Power Amplifiers. 8.1 Introduction. 8.2 Theory of Harmonic Tuned PA Design. 8.3 Input Device Nonlinear Phenomena: Theoretical Analysis. 8.4 Input Device Nonlinear Phenomena: Experimental Results. 8.5 Output Device Nonlinear Phenomena. 8.6 Design of a Second HT Power Amplifier. 8.7 Design of a Second and Third HT Power Amplifier. 8.8 Example of 2nd HT GaN PA. 8.9 Final Remarks. 8.10 References. 9 High Linearity in Efficient Power Amplifiers. 9.1 Introduction. 9.2 Systems Classification. 9.3 Linearity Issue. 9.4 Bias Point Influence on IMD. 9.5 Harmonic Loading Effects on IMD. 9.6 Appendix: Volterra Analysis Example. 9.7 References. 10 Power Combining. 10.1 Introduction. 10.2 Device Scaling Properties. 10.3 Power Budget. 10.4 Power Combiner Classification. 10.5 The T-junction Power Divider. 10.6 Wilkinson Combiner. 10.7 The Quadrature (90 ) Hybrid. 10.8 The 180 Hybrid (Ring Coupler or Rat-race). 10.9 Bus-bar Combiner. 10.10 Other Planar Combiners. 10.11 Corporate Combiners. 10.12 Resonating Planar Combiners. 10.13 Graceful Degradation. 10.14 Matching Properties of Combined PAs. 10.15 Unbalance Issue in Hybrid Combiners. 10.16 Appendix: Basic Properties of Three-port Networks. 10.17 References. 11 The Doherty Power Amplifier. 11.1 Introduction. 11.2 Doherty's Idea. 11.3 The Classical Doherty Configuration. 11.4 The 'AB-C' Doherty Amplifier Analysis. 11.5 Power Splitter Sizing. 11.6 Evaluation of the Gain in a Doherty Amplifier. 11.7 Design Example. 11.8 Advanced Solutions. 11.9 References. Index.

A 1-Bit $10 \times 10$ Reconfigurable Reflectarray Antenna: Design, Optimization, and Experiment

Abstract: An electronically reconfigurable reflectarray antenna (RRA) with $10\times10$ elements is presented with a detailed design procedure for an improved beam-scanning performance. The element, designed at Ku band using a simple patch structure with one PIN diode and two substrate layers, can be electronically controlled to generate two states with 180° phase difference and low reflection loss. A reflectarray prototype is fabricated and experimentally studied for proof of principle. The limitations of the small aperture size are analyzed in detail, and synthetic optimizations of both feed location and aperture phase distribution are used to improve the beam-scanning performance of the prototype. Experimental results agree well with the full-wave simulations, and scan beams within ${\pm}{50}^\circ$ range are obtained with a maximum aperture efficiency of 17.9% at 12.5 GHz. Consistent scan beams are obtained from 11.75 to 13.25 GHz. Furthermore, the versatile beam-forming capability of the RRA is also demonstrated by a wide-beam pattern synthesis. A fast beam-switching time ( $12\;\upmu \text{s}$ ) is theoretically analyzed and verified by the measurement.