Lee Fingersh

Bio: Lee Fingersh is an academic researcher from National Renewable Energy Laboratory. The author has contributed to research in topics: Wind power & Turbine. The author has an hindex of 22, co-authored 41 publications receiving 2763 citations.

Unsteady Aerodynamics Experiment Phase VI: Wind Tunnel Test Configurations and Available Data Campaigns

Abstract: The primary objective of the insteady aerodynamics experiment was to provide information needed to quantify the full-scale, three-dimensional aerodynamic behavior of horizontal-axis wind turbines. This report is intended to familiarize the user with the entire scope of the wind tunnel test and to support the use of the resulting data.

Control of variable-speed wind turbines: standard and adaptive techniques for maximizing energy capture

Abstract: This article considers an adaptive control scheme previously developed for region 2 control of a variable speed wind turbine. In this paper, the question of theoretical stability of the torque controller is addressed, showing that the rotor speed is asymptotically stable under the torque control law in the constant wind speed input case and L/sub 2/ stable with respect to time-varying wind input. Further, a method is derived for selecting /spl gamma//sub /spl Delta/M/ in the gain adaptation law to guarantee convergence of the adaptive gain M to its optimal value M*.

Standard and adaptive techniques for maximizing energy capture

Abstract: 1066-033X/06/$20.00©2006IEEE W ind energy is the fastest-growing energy source in the world, with worldwide wind-generation capacity tripling in the five years leading up to 2004 [1]. Because wind turbines are large, flexible structures operating in noisy environments, they present a myriad of control problems that, if solved, could reduce the cost of wind energy. In contrast to constantspeed turbines (see “Wind Turbine Development and Types of Turbines”), variable-speed wind turbines are designed to follow wind-speed variations in low winds to maximize aerodynamic efficiency. Standard control laws [2] require that complex aerodynamic properties be well known so that the variable-speed turbine can maximize energy capture; in practice, uncertainties limit the efficient energy capture of a variable-speed turbine. The turbine used as a model for this article’s research is the Controls Advanced Research Turbine (CART) pictured in Figure 1. CART is located in Golden, Colorado, at the U.S. National Renewable Energy Laboratory’s National Wind Technology Center (see “The National Renewable Energy Laboratory and National Wind Technology Center”). A modern utility-scale wind turbine, as shown in Figure 2, has several levels of control systems. On the uppermost level, a supervisory controller monitors the turbine and wind resource to determine when the wind speed is sufficient to start up the turbine and when, due to high winds, the turbine must be shut down for safety. This type of control is the discrete if-then variety. On the middle level is turbine control, which includes generator torque control, blade pitch control, and yaw control. Generator torque control, performed using the power electronics, determines how much torque is extracted from the turbine, specifically, the high-speed shaft. The extracted torque opposes the aerodynamic torque provided by the wind and, thus, indirectly regulates the turbine speed. Depending on the pitch actuators and type of generator and power electronics, blade pitch control and generator torque control can operate quickly relative to the rotor-speed time constant. STANDARD AND ADAPTIVE TECHNIQUES FOR MAXIMIZING ENERGY CAPTURE

Methods for Increasing Region 2 Power Capture on a Variable-Speed Wind Turbine

Abstract: The standard region 2 control scheme for a variable-speed wind turbine,t c5Kv 2 , has several shortcomings that can result in significant power loss. The first of these is that there is no accurate way to determine the gain K; modeling programs are not accurate enough to represent all of the complex aerodynamics, and these aerodynamics change over time. Furthermore, it is not certain whether the value of K used in the standard control even provides for the maximum energy capture under real-world turbulent conditions. We introduce new control methods to address these issues. First, we show in simulation that using smaller values of K than the standard can result in increased energy capture. Second, we give simulation results showing that an optimally tracking rotor control scheme can improve upon the standard scheme by assisting the rotor speed in tracking wind-speed fluctuations more rapidly. Finally, we propose an adaptive control scheme that allows for maximum power capture despite parameter uncertainty. @DOI: 10.1115/1.1792653#

A review of wind energy technologies

Abstract: Energy is an essential ingredient of socio-economic development and economic growth. Renewable energy sources like wind energy is indigenous and can help in reducing the dependency on fossil fuels. Wind is the indirect form of solar energy and is always being replenished by the sun. Wind is caused by differential heating of the earth's surface by the sun. It has been estimated that roughly 10 million MW of energy are continuously available in the earth's wind. Wind energy provides a variable and environmental friendly option and national energy security at a time when decreasing global reserves of fossil fuels threatens the long-term sustainability of global economy. This paper reviews the wind resources assessment models, site selection models and aerodynamic models including wake effect. The different existing performance and reliability evaluation models, various problems related to wind turbine components (blade, gearbox, generator and transformer) and grid for wind energy system have been discussed. This paper also reviews different techniques and loads for design, control systems and economics of wind energy conversion system.

Dynamics Modeling and Loads Analysis of an Offshore Floating Wind Turbine

Abstract: This report describes the development, verification, and application of a comprehensive simulation tool for modeling coupled dynamic responses of offshore floating wind turbines.

AeroDyn Theory Manual

Abstract: AeroDyn is a set of routines used in conjunction with an aeroelastic simulation code to predict the aerodynamics of horizontal axis wind turbines. These subroutines provide several different models whose theoretical bases are described in this manual. AeroDyn contains two models for calculating the effect of wind turbine wakes: the blade element momentum theory and the generalized dynamic-wake theory. Blade element momentum theory is the classical standard used by many wind turbine designers and generalized dynamic wake theory is a more recent model useful for modeling skewed and unsteady wake dynamics. When using the blade element momentum theory, various corrections are available for the user, such as incorporating the aerodynamic effects of tip losses, hub losses, and skewed wakes. With the generalized dynamic wake, all of these effects are automatically included. Both of these methods are used to calculate the axial induced velocities from the wake in the rotor plane. The user also has the option of calculating the rotational induced velocity. In addition, AeroDyn contains an important model for dynamic stall based on the semi-empirical Beddoes-Leishman model. This model is particularly important for yawed wind turbines. Another aerodynamic model in AeroDyn is a tower shadow model based on potentialmore » flow around a cylinder and an expanding wake. Finally, AeroDyn has the ability to read several different formats of wind input, including single-point hub-height wind files or multiple-point turbulent winds.« less