Showing papers by "Leigh T. Canham published in 2016"

Enhanced quantum yield of photoluminescent porous silicon prepared by supercritical drying

Abstract: The effect of supercritical drying (SCD) on the preparation of porous silicon (pSi) powders has been investigated in terms of photoluminescence (PL) efficiency. Since the pSi contains closely spaced and possibly interconnected Si nanocrystals (<5 nm), pore collapse and morphological changes within the nanocrystalline structure after common drying processes can affect PL efficiency. We report the highly beneficial effects of using SCD for preparation of photoluminescent pSi powders. Significantly higher surface areas and pore volumes have been realized by utilizing SCD (with CO2 solvent) instead of air-drying. Correspondingly, the pSi powders better retain the porous structure and the nano-sized silicon grains, thus minimizing the formation of non-radiative defects during liquid evaporation (air drying). The SCD process also minimizes capillary-stress induced contact of neighboring nanocrystals, resulting in lower exciton migration levels within the network. A significant enhancement of the PL quantum yiel...

All-optical modulation in Mid-Wavelength Infrared using porous Si membranes.

Abstract: We demonstrate for the first time the possibility of all-optical modulation of self-standing porous Silicon (pSi) membrane in the Mid-Wavelength Infrared (MWIR) range using femtosecond pump-probe techniques. To study optical modulation, we used pulses of an 800 nm, 60 femtosecond for pump and a MWIR tunable probe in the spectral range between 3.5 and 4.4 μm. We show that pSi possesses a natural transparency window centred around 4 μm. Yet, about 55% of modulation contrast can be achieved by means of optical excitation at the pump power of 60 mW (4.8 mJ/cm2). Our analysis shows that the main mechanism of the modulation is interaction of the MWIR signal with the free charge carrier excited by the pump. The time-resolved measurements showed a sub-picosecond rise time and a recovery time of about 66 ps, which suggests a modulation speed performance of ~15 GHz. This optical modulation of pSi membrane in MWIR can be applied to a variety of applications such as thermal imaging and free space communications.

Stain Etched Nanostructured Porous Silicon: The Role of Morphology on Antibacterial Drug Loading and Release

Abstract: In this work, nanostructured porous silicon (pSi) prepared by a metal-assisted stain etched route is investigated for its ability to act as a carrier for sustained delivery of the antibacterial drug triclosan. The morphology, analyzed by transmission electron microscopy, reveals a rather different microstructure than traditional anodized porous silicon; as a consequence, such morphology manifests a different loaded drug crystallinity, triclosan release behavior, and associated antibacterial activity versus Staphococcus aureus relative to high porosity anodized porous silicon. In addition to electron microscopies and antibacterial disk diffusion assays, a combination of x-ray diffraction, thermogravimetric analyses, and UV/Vis spectrophotometric analysis of triclosan release are employed to carry out the above investigations.

Enhancement of Peroxidase Stability Against Oxidative Self-Inactivation by Co-immobilization with a Redox-Active Protein in Mesoporous Silicon and Silica Microparticles

Abstract: The study of the stability enhancement of a peroxidase immobilized onto mesoporous silicon/silica microparticles is presented. Peroxidases tend to get inactivated in the presence of hydrogen peroxide, their essential co-substrate, following an auto-inactivation mechanism. In order to minimize this inactivation, a second protein was co-immobilized to act as an electron acceptor and thus increase the stability against self-oxidation of peroxidase. Two heme proteins were immobilized into the microparticles: a fungal commercial peroxidase and cytochrome c from equine heart. Two types of biocatalysts were prepared: one with only covalently immobilized peroxidase (one-protein system) and another based on covalent co-immobilization of peroxidase and cytochrome c (two-protein system), both immobilized by using carbodiimide chemistry. The amount of immobilized protein was estimated spectrophotometrically, and the characterization of the biocatalyst support matrix was performed using Brunauer–Emmett–Teller (BET), scanning electron microscopy with energy-dispersive X-ray spectroscopy (SEM-EDX), and Fourier transform infrared (FTIR) analyses. Stability studies show that co-immobilization with the two-protein system enhances the oxidative stability of peroxidase almost four times with respect to the one-protein system. Thermal stability analysis shows that the immobilization of peroxidase in derivatized porous silicon microparticles does not protect the protein from thermal denaturation, whereas biogenic silica microparticles confer significant thermal stabilization.

MWIR optical modulation using structured silicon membranes

Abstract: We have used near IR pump – Mid IR probe techniques to compare the feasibility and potential of using free standing nano-porous and micro-porous silicon (ordered hole arrays) as optically controlled modulators operating in the Mid-Wave Infrared (MWIR) covering the range from 3.3-5 μm. We employed 800 nm pumping pulses with the duration of 60 fs to reduce 4 μm light transmission modulation to about 25% and 45% for both silicon structures, respectively, at excitation powers of 50mW (4 mJ=cm2). However, at 5 μm both structures shown similar contrast of about 60%. The time resolved measurements revealed a fast sub-picosecond rise time for both structures suggesting that the optically generated carriers are a dominant mechanism for the modulation. However, the measurements demonstrated a significant difference in the relaxation dynamics. The nanoporous silicon demonstrated recovery as fast as a few tens of picoseconds and a possibility to effectively work in the GHz regime, while hole arrays shown almost three orders of magnitude slower response making it suitable for the MHz regime.

Single Plant Derived Nanotechnology for Synergistic Antibacterial Therapies.

Abstract: Multiple new approaches to tackle multidrug resistant infections are urgently needed and under evaluation. One nanotechnology-based approach to delivering new relevant therapeutics involves silicon accumulator plants serving as a viable silicon source in green routes for the fabrication of the nanoscale drug delivery carrier porous silicon (pSi). If the selected plant leaf components contain medicinally-active species as well, then a single substance can provide not only the nanoscale high surface area drug delivery carrier, but the drug itself. With this idea in mind, porous silicon was fabricated from joints of the silicon accumulator plant Bambuseae (Tabasheer) and loaded with an antibacterial extract originating from leaves of the same type of plant (Bambuseae arundinacea). Preparation of porous silicon from Tabasheer includes extraction of biogenic silica from the ground plant by calcination, followed by reduction with magnesium in the presence of sodium chloride, thereby acting as a thermal moderator that helps to retain the mesoporous structure of the feedstock. The purified product was characterized by a combination of scanning electron microscopy (SEM), energy dispersive X-ray analysis (EDX), X-ray diffraction (XRD), Raman spectroscopy, transmission electron microscopy (TEM), and low temperature nitrogen gas adsorption measurements. Antimicrobial activity and minimum inhibitory concentration of a leaf extract of Bambuseae arundinacea was tested against the bacteria Escherichia Coli (E. Coli) and Staphylococcus aureus (S. Aureus), along with the fungus Candida albicans (C. Albicans). A S. aureus active ethanolic leaf extract was loaded into the above Tabasheer-derived porous silicon. Initial studies indicate sustained in vitro antibacterial activity of the extract-loaded plant derived pSi (25 wt %, TGA), as measured by disk diffusion inhibitory zone assays. Subsequent chromatographic separation of this extract revealed that the active antimicrobial species present include stigmasterol and 2,6-dimethoxy-p-benzoquinone.