Lew Goldberg

Bio: Lew Goldberg is an academic researcher from United States Naval Research Laboratory. The author has contributed to research in topics: Laser & Amplifier. The author has an hindex of 40, co-authored 162 publications receiving 5413 citations. Previous affiliations of Lew Goldberg include Harvard University.

Single-mode operation of a coiled multimode fiber amplifier

Abstract: The authors report a new approach to obtain single-transverse-mode operation of a multimode fiber amplifier, in which the gain fiber is coiled to induce significant bend loss for all but the lowest-order mode. They have demonstrated this method by constructing a coiled amplifier using Yb-doped, double-clad fiber with a core diameter of 25 {micro}m and NA of {minus}0.1 (V {approx} 7.4). When operated as an ASE source, the output beam had an M{sup 2} value of 1.09 {+-} 0.09; when seeded at 1,064 nm, the slope efficiency was similar to that of an uncoiled amplifier. This technique does not require exotic fiber designs or increase system complexity and is inexpensive to implement. It will allow scaling of pulsed fiber lasers and amplifiers to significantly higher pulse energies and peak powers and cw fiber sources to higher average powers while maintaining excellent beam quality.

Microwave signal generation with injection-locked laser diodes

Abstract: Heterodyne detection of the light from two slave lasers injection locked to FM sidebands of a modulated master laser is used to generate a narrowband microwave signal at 10.5 GHz.

Fiber-optic prism true time-delay antenna feed

Abstract: Experimental results for an optical-control technique for implementing a true time-delay function for array antennas are reported. A microwave signal is transmitted on a wavelength-tunable optical carrier through a fiber-optic prism-a set of nominally equal-delay fibers with differing net dispersion-to photodetectors that feed each antenna element. The relative interelement time-delay (beam angle) adjustment is accomplished by tuning the optical carrier wavelength. Measured antenna patterns of a two-element array clearly demonstrate beam steering and true time-delay operation over a two-octave bandwidth of 2-8 GHz. >

Injection locking of coupled‐stripe diode laser arrays

Abstract: The control of the far‐field beam pattern and the spectrum of 10‐element laser diode array by injection locking to a single‐mode master laser are described. With less than 3 mW of injected power an array output of 105 mW at a single frequency with a 0.5° wide far‐field lobe is obtained. Similar results are observed when the entire array is illuminated by the master laser beam, or when only one of the stripes is illuminated. The narrow lobe contains 60–70% of the total power and is centered at an angle of about 4° relative to the normal of the array facet.

High efficiency side-coupling of light into optical fibres using imbedded v-grooves

Abstract: Transverse v-grooves, directly formed into the side of an optical fibre, totally reflect light incident on the fibre side-wall, directing it along the fibre axis. For a 96 µm core fibre, light incident from a laser diode is coupled into the fibre by the v-groove with 96% coupling efficiency.

I and i

Abstract: There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality. Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

Band parameters for III–V compound semiconductors and their alloys

Abstract: We present a comprehensive, up-to-date compilation of band parameters for the technologically important III–V zinc blende and wurtzite compound semiconductors: GaAs, GaSb, GaP, GaN, AlAs, AlSb, AlP, AlN, InAs, InSb, InP, and InN, along with their ternary and quaternary alloys. Based on a review of the existing literature, complete and consistent parameter sets are given for all materials. Emphasizing the quantities required for band structure calculations, we tabulate the direct and indirect energy gaps, spin-orbit, and crystal-field splittings, alloy bowing parameters, effective masses for electrons, heavy, light, and split-off holes, Luttinger parameters, interband momentum matrix elements, and deformation potentials, including temperature and alloy-composition dependences where available. Heterostructure band offsets are also given, on an absolute scale that allows any material to be aligned relative to any other.

Neuronal Oscillations in Cortical Networks

Abstract: Clocks tick, bridges and skyscrapers vibrate, neuronal networks oscillate. Are neuronal oscillations an inevitable by-product, similar to bridge vibrations, or an essential part of the brain’s design? Mammalian cortical neurons form behavior-dependent oscillating networks of various sizes, which span five orders of magnitude in frequency. These oscillations are phylogenetically preserved, suggesting that they are functionally relevant. Recent findings indicate that network oscillations bias input selection, temporally link neurons into assemblies, and facilitate synaptic plasticity, mechanisms that cooperatively support temporal representation and long-term consolidation of information.

Microwave photonics combines two worlds

Abstract: Microwave photonics, which brings together the worlds of radiofrequency engineering and optoelectronics, has attracted great interest from both the research community and the commercial sector over the past 30 years and is set to have a bright future. The technology makes it possible to have functions in microwave systems that are complex or even not directly possible in the radiofrequency domain and also creates new opportunities for telecommunication networks. Here we introduce the technology to the photonics community and summarize recent research and important applications.

Optical coherence tomography - principles and applications

Abstract: There have been three basic approaches to optical tomography since the early 1980s: diffraction tomography, diffuse optical tomography and optical coherence tomography (OCT). Optical techniques are of particular importance in the medical field, because these techniques promise to be safe and cheap and, in addition, offer a therapeutic potential. Advances in OCT technology have made it possible to apply OCT in a wide variety of applications but medical applications are still dominating. Specific advantages of OCT are its high depth and transversal resolution, the fact, that its depth resolution is decoupled from transverse resolution, high probing depth in scattering media, contact-free and non-invasive operation, and the possibility to create various function dependent image contrasting methods. This report presents the principles of OCT and the state of important OCT applications. OCT synthesises cross-sectional images from a series of laterally adjacent depth-scans. At present OCT is used in three different fields of optical imaging, in macroscopic imaging of structures which can be seen by the naked eye or using weak magnifications, in microscopic imaging using magnifications up to the classical limit of microscopic resolution and in endoscopic imaging, using low and medium magnification. First, OCT techniques, like the reflectometry technique and the dual beam technique were based on time-domain low coherence interferometry depth-scans. Later, Fourier-domain techniques have been developed and led to new imaging schemes. Recently developed parallel OCT schemes eliminate the need for lateral scanning and, therefore, dramatically increase the imaging rate. These schemes use CCD cameras and CMOS detector arrays as photodetectors. Video-rate three-dimensional OCT pictures have been obtained. Modifying interference microscopy techniques has led to high-resolution optical coherence microscopy that achieved sub-micrometre resolution. This report is concluded with a short presentation of important OCT applications. Ophthalmology is, due to the transparent ocular structures, still the main field of OCT application. The first commercial instrument too has been introduced for ophthalmic diagnostics (Carl Zeiss Meditec AG). Advances in using near-infrared light, however, opened the path for OCT imaging in strongly scattering tissues. Today, optical in vivo biopsy is one of the most challenging fields of OCT application. High resolution, high penetration depth, and its potential for functional imaging attribute to OCT an optical biopsy quality, which can be used to assess tissue and cell function and morphology in situ. OCT can already clarify the relevant architectural tissue morphology. For many diseases, however, including cancer in its early stages, higher resolution is necessary. New broad-bandwidth light sources, like photonic crystal fibres and superfluorescent fibre sources, and new contrasting techniques, give access to new sample properties and unmatched sensitivity and resolution.